Question about Ford Cars & Trucks

Open Question

Brake line routing for 2002 chevy silverado - Ford Cars & Trucks

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Auto Master
  • 139 Answers

SOURCE: 00 Chevy Silverado... ABS EBCM diagram help??? Brake line hookups

Hello,
I hope this helps.






1ec2f93.jpg
Thank You,
Roy

Posted on Aug 28, 2009

Ad
rtpflh
  • 546 Answers

SOURCE: 2002 chevy silverado 4x4, brakes

did you bleed the brakes in the proper order? RR LR RF LF. check rubber lines for deterioration or BULGING when you apply brakes.

Posted on Sep 22, 2009

  • 468 Answers

SOURCE: Power steering and brake line location2002 Chevy Silverado 2500HD

the power steering lines are very short hoses approximately 8 inches long that go from the power steering pump down to the steering box, which is located on the frame, just below the pump. The brake lines run from the master cylinder(where you fill it with fluid on the drivers side firewall) down to the frame, and then follow the frame both directions; both to the front end and the rear end, along the drivers side frame rail, just on the inside of it. The fuel line runs along the same path to the rear.

Posted on Oct 03, 2009

emissionwiz
  • 77169 Answers

SOURCE: can't get brake fluid from abs into lines after

I read this same problem all the time, the reason u can't bleed the lines is that a special tool is required that pluge into the ABS and holds the hydraulic valves in the ABS control open for bleeding, there is no way around this.

Posted on May 19, 2010

DrSpeedo
  • 294 Answers

SOURCE: 2005 Chevy Silverado 1500 LS, Speedometer dial

The motor behind the gauge is wearing out, very common on silverado instrument clusters for this to happen.

I can rebuild the gauge so it doesn't happen again, check my site out here www.DrSpeedometer.com

Posted on Sep 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove rear axle in a 2002 Chevy Silverado 2500 HD 4x4


remove the drive shaft then remove the brake hoses and e brake cables remove the breather hose then remove the bolts at the springs or links which ever it has

Nov 22, 2013 | 2002 Chevrolet Silverado 2500HD

1 Answer

How do you bleed the brakes on a 2002 chevy silverado? Tried the old fashion way and no go


you have to bleed them all, starting at the passenger side rear,, then the drivers rear, up to the passenger front, and finally the drivers side front. and it takes forever unless you have a bleeding tool, autozone and a couple of other parts stores have a reversal tool that you can borrow or rent,, it comes with a pump and you have to buy brake fluid for it,, you attach it to the bleeder valve on each brake, and instead of using the master cylinder to force air out at the brake itself, it goes the other way,, it fills the lines from the brake to the master cylinder, forcing the air to the master instead,, but I would try doing them in the order I stated first ,

Aug 25, 2011 | 2002 Chevrolet Silverado 1500

1 Answer

2002 chevy silverado 4wd will not start acts like it is in drive does not know that it is in park


that could be a bad, loose or misadjusted "neutral safety switch" .. in some the brake has to be applied before starting .. that would involve a brake safety switch ..

Feb 27, 2010 | 2002 Chevrolet Silverado 1500HD

2 Answers

2002 chevy silverado 4x4, brakes


did you bleed the brakes in the proper order? RR LR RF LF. check rubber lines for deterioration or BULGING when you apply brakes.

Sep 22, 2009 | 2002 Chevrolet Silverado 1500

1 Answer

Power steering and brake line location2002 Chevy Silverado 2500HD


the power steering lines are very short hoses approximately 8 inches long that go from the power steering pump down to the steering box, which is located on the frame, just below the pump. The brake lines run from the master cylinder(where you fill it with fluid on the drivers side firewall) down to the frame, and then follow the frame both directions; both to the front end and the rear end, along the drivers side frame rail, just on the inside of it. The fuel line runs along the same path to the rear.

Mar 03, 2009 | 2002 Chevrolet Silverado 2500HD

2 Answers

2002 chevy silverado 2500HD (automatic)


the power brakes are a hydrolic system ran off of the power steering pump. therefore if you have a busted power steering hose the power brakes will not work.

Feb 28, 2009 | 2002 Chevrolet Silverado 2500HD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

297 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

fordexpert

Level 3 Expert

5572 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...