Question about 2006 Ford Explorer

Open Question

How to adjust parking brake 2006 ford explorer xlt

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Handy Mike
  • 6 Answers

SOURCE: how do i replace the pcv valve on a 2000 explorer xlt v6 sohc?

On the passenger side of the intake manifold, coming off the bottom about the center of the engine front to back, you'll feel a hose that comes off a nipple. That hose makes a 90 degree bend and goes around to the rear of the motor. Where that hose meets the Y-connector from the other side of the intake you'll find the PCV valve. It's almost impossible to see it with the hood installed, and even tougher to reach it.

A good source of information for Ford Explorers can be found here

Posted on Oct 25, 2008

chuck943
  • 783 Answers

SOURCE: 2006 Ford Explorer XLT the Blower Fan only works on 4 and 3 Sp

Look under the dash on passenger side and just to the left of the blower motor housing you will see the 4WD control module.Remove the 2 screws holding the module and let it hang down and your resistors are behind this.Remove the 2 screws holding the resistors and remove.
Now I am assuming you have manual climate control and not electonic.

Posted on Feb 26, 2009

  • 25 Answers

SOURCE: 1996 Ford Explorer XLT abs light comes on on

The ABS light is for the Anti-lock Braking System. The MIL will illuminate if there is a difference in wheel speed sensors signals to the PCM. So you might have a wheel speed sensor that is going out on you. Does the light come on at low speeds, or just higway speeds? You could take the vehicle to a local parts store and have them pull the codes for you and that will tell you which speed sensor is out of whack. Also road grime, dirt and gunk buildup can cause speed sensors to give false readings. Hope tihs helps you out.......

Posted on Oct 22, 2009

  • 416 Answers

SOURCE: 2007 FORD EXPLORER XLT

need to set tires at correct pressure you can find a sticker on the inside of drivers door to tell you the correct pressure after you do that it sould reset the light after you drive

Posted on Feb 02, 2010

  • 1 Answer

SOURCE: how to replace rear turn signal light bulb

I just changed my rear turn signal. Really easy. There is two 1/4 inch bolts visible when you open the tailgate. Take both of those out and gently lift the light housing out towards the outside of the vehicle. There is two small clamps on the other side of the fixture that just slide right out when you pull on it. There you go

Posted on Feb 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Location for fuel line on a 2006 ford explorer xlt 4.0 shoc


Geronimo, Normally the fuel lines run from gas tank, along frame rail, then up to fuel rail into injectors.
Check the attached links,
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
2006 ford explorer xlt fuel line routing Google Search

Ford Fuel Filter Replacement Change How to Do it yourself

Fuel Filter Replacement 2006 Explorer

Fuel pump replacement Ford Explorer 2005 2010 Install Remove Replace...


Mar 04, 2016 | 2006 Ford Explorer XLT

1 Answer

I have an Automatic 1994 Ford Explorer and the gear slector will not change out of park. This has happened before and I got it to move by jiggling the steering wheel and the gear selector. That isn't


the 1997 explore wont come out of park sometimes until you put your foot on the brake

FOOT ON THE BRAKE THE MOVE GEAR

its a safety feature in case your on a hill & for children if left in the car / wagon 4x4 it wont roll away on you

very smart really .

that\'s a floor shift not Colum shift but still might be the same . it still gets me to this day THAT LOL good luck

Mar 14, 2014 | 1997 Ford Explorer AWD

1 Answer

My 03 ford explorer wont go into park. It taks the other gears but not park. please help


Check the brake lights, if they don't work the system will not come out of part. if the brake lights are not working check the brake light switch connector, the wire breaks inside the connector and although the switch is connected there is not any actual electrical connection just plastic insulator over broken wires. The dealer sells repair connectors.

Nov 01, 2012 | 2003 Ford Explorer

1 Answer

I have a 96 ford explorer xlt 4wd with ABS. When I bought it it had a broken back break line. I replaced the line blead the breaks and the breaks are spongy. I googled the issuse and found out it could be...


Check your parking brake. if it goes down to the floor or does not hold, then your back brakes needs adjusted. bad master cylinders bleed off slowly to the floor while pushing on the brake pedal. If you need assistance on adjusting let me know.
Randy

Nov 09, 2010 | 1996 Ford Explorer

1 Answer

How do I adjust the handbrake in 2000 ford explorer


parking brakes are self adjusting. I suspect you rear brakes are not self adjusting. too much clearance to the brake drum to brake shoes. May need to replace rear brakes and self adjusters. (hardware)

Sep 04, 2010 | 1997 Ford Explorer AWD

1 Answer

Sorry on 2004 ford exploer xlt 2 wheel drive. cant get rear rotor off.


most likely the parking brake shoes on the inside drum of the rotor are hanging up you can grind the heads off the nails that hold the assembly together and decide after you get it all apart if you want or use your parking brake most people throw them away.

Jul 31, 2010 | 2004 Ford Explorer

2 Answers

2000 Ford Explorer-shifter deos not go fully into park


You'll need to get under the truck on the side of the trans (driver side) there will be an adjustment, looesen it move leveler all the way to park and tien nut.

Dec 18, 2009 | 2000 Ford Explorer

1 Answer

What tools do you need to replace the rear caliper brakes on a for expedition xlt 2006


Standard repair tools except for a rear caliper compression tool. This is needed because rear calipers screw in due to parking brake.

Jul 11, 2009 | 2006 Ford Expedition

1 Answer

How do I adjust the parking brake?


Loosen the cable nut at the rear brake, pull the cable until the tension is tight, then tighten the cable nut. Since the parking brake only operates on the rear brakes, your rear pads may be too worn causing the parking brake not to hold. Check the pads first to see if they need to be replaced. Also, the parking brake cable can stretch or break over time. Verify that isn't case since you may need to install a new cable rather than adjust it.

Apr 30, 2009 | 2000 Ford Explorer

Not finding what you are looking for?
2006 Ford Explorer Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...