Question about 2000 Buick Century
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: buick century 2000 wipers
I found the following description on the web, this covers a bunch of the questions I was going to ask...
I own a 2000 Silo and wondered the same thing and do see some GM vans with this problem.
When I bought mine I also bought the Haynes Repair manual (1997 thru 2001 all models GM) #38036 to learn how to fix this and a LOT of other components in/on the van.
For $20 it's worth it.
To answer your question: If the wipers stop at the position they're in when the switch is turned off (Fail to park), disconnect the multi-function switch electrical connector. (This is located under the dash next to the firewall and steering column)
If the wipers now park, replace the multi-function switch. If the wipers still do NOT park, check the wiring from the wiper motor to the switch for a short circuit. If the circuits are good, replace the wiper motor.
Note: There are other adjustments needed for proper operation than just bolting and new motor on.
You can have a look at this manual at any automotive parts supply store.
Posted on Dec 06, 2008
The coolant level sensor is located on the radiator. If you are looking at the engine from the front of the car it will be on the left side. There will some kind of clip holding it in the radiator. Removed the clip and pull the sensor out. You will lose coolant so try to swap it out quick or drain some of the coolant out. Once new sensor is installed, install clip to keep the sensor in place and reconnect the wires to the sensor. Crank the engine and make sure the coolant level is full. This should correct your problem.
Posted on Jan 04, 2009
You're either looking at a short in the wire that goes to the fuel sender, or a bad fuel sender. If it was just a broken wire, it would read empty instead. The fuel sender is a permanent part of the fuel pump, so that has to be replaced as a unit.
Posted on Oct 20, 2009
Tips for a great answer:
Apr 28, 2014 | 2000 Buick Century
Aug 06, 2012 | 2000 Buick Century
Jun 16, 2011 | Buick Century Cars & Trucks
Mar 09, 2011 | 2000 Buick Century
Feb 27, 2011 | 1993 Buick Century
Nov 10, 2017 | 1991 Buick Century
Mar 15, 2010 | 1997 Buick Century
Jul 02, 2009 | Buick Century Cars & Trucks
127 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: