Question about Cars & Trucks

1 Answer

Grand cherokee 1996 2.5 deiselengine

Driving on motorway with no problems.engine check light come on and speedo stops working.did fault scan and shows 11 and 12. checked batttery connections. are fault codes for deisel engines same as petrol.maybe old fault

Posted by on

  • Robert Sparasci Nov 10, 2012

    Yes Steve, I think your right and thank you very much for your help .... what I don't understand is why isn't the valid code [15 I think] showing instead of these?

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,150 Answers

11 and 12 are not valid fault codes however if the speedometer stops working when the check engine light is on I would say you have a failing vehicle speed sensor.

Posted on Nov 08, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 726 Answers

SOURCE: 1996 Jeep Grand Cherokee - Will Not Start or Run

ok it has nothing to do with the gear box
no ower to your injectors check engine fuse
if and wen u took the gear box out did take the positive lead off?
if u did unplug the computer or try the reset so the computer can no the car is back togeather

Posted on Jul 19, 2008

  • 29 Answers

SOURCE: Check Engine Light

It sounds like you may have a failing Mass Air Flow sensor, seems like Ive been seeing these tied together quite often. Its a little tricky but a good repair shop should be able to test this sensor. I dont want to tell you to replace it without having it tested cause they are a bit pricey but check around, you never know. Hope this give youu another idea where to look.

Posted on Oct 02, 2008

emissionwiz
  • 75051 Answers

SOURCE: 1996 monte carlo fault codes po300, 441, 705,

THESE ARE FROM THE GM CODE DIFINITION MANUAL, U NEED TO TAKE THIS TO THE DELAER, U HAVE SOME SERIOUS PROBLEMS TO GIVE THIS MANY CODES.

P0300 - Engine Random Misfire Detected
P0441 - Evaporative Emission Control System Incorrect Purge Flow
P0705 - Trans Range Switch Circuit
P1106 - Manifold Absolute Pressure (MAP) Sensor Circuit Intermittent High Voltage
P1133 - Heated Oxygen Sensor (HO2S) Insufficient Switching Bank 1 Sensor 1
P1441 - Evaporative Emission (EVAP) System Flow During Non-Purge
P1662 - Cruise Lamp Control Circuit
P1672 - Low Engine Oil Level Lamp Control Circuit
P1870 - Transmission Component Slipping

Posted on Mar 24, 2009

  • 221 Answers

SOURCE: my 2000 jeep Grand Cherokee engine light came on and stayes on

Here's a link that give's jeep check engine light code's,
http://www.engine-light-help.com/jeep-check-engine-light.html

hope this help's.

Posted on Apr 03, 2009

  • 1 Answer

SOURCE: 1991 olds cutlass supreme with a 3.1 v-6 the engine

I am having a similar problem, but there is no check engine light. It seems that mine dies at the light or running, if the rpm's drop. I am wondering if the Idle air control valve is bad or possibly the ERG valve?

Posted on Feb 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

96 grand cherokee starts& runs fine but then it goes into pig mode & over fuels dumping black sout out of exhaust


1996 jeep grand cherokee stalling at lights or stop signs - Forums ...

www.cnet.com > Forums > Car Tech

CNETJun 11, 2015 - My jeep grand cherokee 1996 has started stalling when at lights, stop signs, in park or ... It starts and drives but after stoping at the stores and parking when I came out I ... Mechanic changed already crank sensor, distributer pick up, fuel pump, idle .... Symptoms like the Jeep running fine, then stalling without warning usually ... 97 Jeep Grand Cherokee Laredo keep dying upon ignition
Jun 11, 2015
1996 Jeep Grand Cherokee just stopped while driving.
Jun 10, 2015
More results from www.cnet.com
Missing: pig

Nov 23, 2015 | 1996 Jeep Grand Cherokee

1 Answer

1994 Civic D16A8. Why does the engine check light come on while driving & speedo stops working?


run the fault codes
engine light fault can also refer to transmission fault which is indicated by the speedo problem

Jun 06, 2015 | 1994 Honda Civic

1 Answer

1996 jeep grand cherokee transmission slips in 2nd and drive


Drain fluid into a clean plastic bowl, check for brass cuttings or metal shavings in sunlight. If present get complete trans overhaul.

Oct 21, 2012 | 1996 Jeep Grand Cherokee

1 Answer

JEEP STOPPED RUNNING WHILE DRIVING WILL ONLY CRANK


The Engine and Automatic Transmission (not applicable to manual transmissions) in this vehicles drive train are fully electronically controlled by a computer called the PCM and TCM (Power Train Control Module, Transmission Control Module). When a problem like this or other drive-ability related problems occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM. Also always check fuel pressure for correct spec for your make and engine type.


Sep 28, 2012 | 1996 Jeep Grand Cherokee

2 Answers

How can i reset a check engine light without taking the jeep to a shop. the code was for a emmissions problem i changed all the hoses that were cracked, now i just want to stop the check engine light to...


Your system goes through self-diagnostics every fifty miles or so. If you just drive it, once the system sees no faults the light should go off. You can also clear codes using a scan tool.

May 15, 2011 | 2003 Jeep Grand Cherokee

2 Answers

1996 jeep grand cherokee- while driving all gauges stopped working and all dash light were flickering on and off. then all went back to normal but since then passenger side windows and door locks will not...


I would start by scanning the engine control module and the body control module and the antilock brake control module and the transmission control module and the airbag module to see if there are any fault codes that indicate a loss of power to the modules. It may tell me which circuit malfunctioned. If that does not give me a clue, I would then start to diagnose the window circuits by first checking for power at the master switch and move to the rest of the power window system from there.

As for fuses or where to start...I think you should probably read these articles before doing anything:

Where's The Fuse?

What Else Could Be Wrong?

May 08, 2011 | 1996 Jeep Grand Cherokee

2 Answers

My engine light came on, i checked the oil and i


It depends on which light you are referring to. If it was the oil pressure light and the oil level was low, then adding the oil to the right level should have made the light go out unless there is another issue. If the light you refer to is the check engine light, however, then I would suggest taking the vehicle to an autoparts store and have them scan the computer for any fault codes stored. The check engine light is to alert you that the computer has noted a fault in one of the car's systems and getting the codes will show what the computer has identified so corrective action can be taken. Hope this helped and best wishes.

Sep 30, 2009 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

73 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...