Question about Nissan Pickup

Open Question

W163 ml270 wont ref over 300rpm

I already checked the fuel filter and the fuel tank and it is clean but it wont ref over 3000 rpm. When you starts it up and is cold it sometimes ref up

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

latoss101
  • 47 Answers

SOURCE: gdi 1800 cedia wagon-odometer 80,000km exact, starting, no power

yes

Posted on Jan 03, 2009

  • 1 Answer

SOURCE: cold start problem on ml270

Hello,
I had a similar problem. Would take 5-6 attempts to start of a morning when cold. It was caused by air in the fuel lines. Once the fuel line seals were replaced problem went away.

Posted on Jun 21, 2009

  • 850 Answers

SOURCE: 2001, Duramax Deisel 6.6 won't "restart"

fuel pump is obviouslynot working !
check it & its wiring!!!!!

Posted on Jul 20, 2009

  • 169 Answers

SOURCE: 91 Jeep wrangler New everything idles rough, no Power then dies

you check for miss how is compression

Posted on Aug 29, 2009

  • 1 Answer

SOURCE: 4g93 gdi engine starts wont rev above 3000

Hey have you tried disconnecting and re connecting the battery? my mitsi carisma startd doing that so i rang up dealer and aparently they do it when the computer thinks there is something wrong with the engine, so it enters slow mode (or turtle mode or something) so that minimal damage is done while you drive it slowly to yr mechanic. Could be complettly wrong tho. Good luck.

Posted on Jan 17, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

After replacing fuel pump in tank the rev. counter can't reach 3000 rpm and engine has no power in Jeep Liberty ltd 3.7 2006


remove the pump again check for anything restricting the pumps inlet and make sure when the pump is put bacl that none of the pipes has a twist or bend that will restrict the flow of fuel

Jan 26, 2016 | Jeep Cars & Trucks

1 Answer

1993 isuzu bighorn diesel engine holds revs to 3000 rpm for about 30 seconds and then dies


Do you think the primary fuel filter under the tank could be blocked or water is in the fuel?

Mar 25, 2014 | 1993 Isuzu Trooper

1 Answer

First this isuzu dmax just stop suddenly,i clean the fuel filter then clean the cencor in the tank,then the cencor connceted to the pump then it manage to start and idle properly but the engine check


to whom it may concern. my dmax model 2006 3000 cc lately having problem like engine suddenly stop especially when it slow,fuel filter already new fuel line been check but the problem still there.anyone been encountered this problem before what is the problem?

Jul 01, 2012 | Isuzu i-280 Cars & Trucks

1 Answer

Won't start unless spray fuel change fuel pump did'nt help when it starts idel rough throtle up slowly it go about 3000 rpm start trying to die if you floor it from idel it will die but spray fuel...


Then its got to be a problem with the fuel delivery. You need to check that you're getting fuel from the tank.


1) Does fuel get to the filter? If not, is there an airlock or debris in the fuel pipe
2) Does fuel get past the filter? - If not, replace the filter.
3) I'm not sure if you have a carb. or injectors, but one or more of the injectors could be blocked. If a carb., fuel inlet jet may be blocked.
4) Finally, is the air filter good and clean.

Jul 01, 2011 | 1990 Ford Bronco

1 Answer

1991 geo metro car misses at high rpm


try this first. the older the car; the more problems the ethanol gas is causing. replace the fuel filter. you'll probably see what you think is dirty gas; it is; in a way. it's the ethanol goop that stays and ruins engines, and fuel systems. install the new filter. add a whole can of SEAFOAM to at least a half tank of premium gas. replace fuel filter before next 500 miles.add can of SEAFOAM every 3000 miles after that, and that will clean the valves, the goop, the carbon and keep your tank and lines free of moisture, It might take afew miles(depending on the clogging), but it should work. I hate ethanol gas.

Aug 30, 2009 | 1991 Geo Storm

5 Answers

Jaguar x type 2004 2.5 petrol V6, 38500 miles, codes P0171, P0174


Have exactly the same issue on 04 jag x type 2.5. So far have replaced fuel filter, air filter k&n, plugs ngk. Codes cleared, same issue. Seems to appear when air temp is cold and eng is warm.
Am replacing upstream O2 sensors and cleaning MAF next. Will keep you posted if it clears up. Did you ever find the cause?

Aug 25, 2009 | 2002 Jaguar X-Type

2 Answers

Cold start problem on ml270


hello,good day,check all line for diesel leaking, or your fuel flow back to your tank, try to check your fuel filter,renew if necessary,ty

May 11, 2009 | Mercedes-Benz ML-Class Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...