Question about 2001 Pontiac Aztek

Open Question

The temp gauge in my 2001 pontiac aztek is not working and my fans are on when i start my aztek?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
GM Elec
  • 1000 Answers

SOURCE: Temperature sensor problem?

There are 2 different circuit that control the cooling fans.
The engine controller turns the low speed fan circuit on to control temperature and turns on the high speed fan circuit if the engine and A/C is running.
It sounds like your low speed fan function is not working.
Find your fan 1 fuse located in the under hood fuse panel and make sure it is not blown. If OK go to next step.
Find your fan 1 relay located in the under hood fuse panel. Find another relay in the fuse panel that matches and swap the two. If the fan then works you know you have a bad relay.
If both are check good, let me know and we will go from there.
Below, I have attached the wiring diagram for your cooling system, hope it helps.
Regards,
38228c4.gif
moz-screenshot.jpgmoz-screenshot-1.jpg

Posted on Mar 27, 2009

Ad
  • 74 Answers

SOURCE: 2004 pontiac aztek cooling fans not working

relays control fans high and low. does fan come on with a/c on?hot wiring only will create more expensive problems in future!!!!! 2004 not 84

Posted on Aug 26, 2008

losflip
  • 94 Answers

SOURCE: Fuel gauge in 2001 Aztek 140k miles doesn't work.

Hi, Sounds like it has a bad fuel gauge sender, location is in the fuel tank.

Posted on Dec 03, 2008

  • 1 Answer

SOURCE: 2001 pontiac aztek egr vavle replacement

Hello. I used to work in a GM dealer. It is seldom the EGR valve that is the problem. If it is code P1404, the problem is a PCM calibration. Take it to a local dealer and they can reflash the PCM. If you want to get technical about it, the PCM is and emission control device and should be covered by warranty for 8 years or 80,000 miles.

Posted on Apr 16, 2009

  • 14036 Answers

SOURCE: overheating 2001 pontiac aztek

remove coolant.remove thermostat remove bottom radiator hose to water pump.put a empty container under the radiator.take a water hose put it where thermostat goes flush out the rust in block.watch the water as it come out the water pump .if stream water is small keep flushing until you get a study sream of clear water. also flush out radiator. lower water pressure dont flush radiator it with high water pressure you could burst it. make clean the over flow jug .make sure it not stopped up.put in a new thermostat and radiator pressure cap. fill radiator with half antifreeze and half water.bleed the coolant system.

Posted on Apr 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Temperature gauge not working


If you know that the radiator is full of coolant, and the temp gauge is not accurate, the sending unit for the gauge may be faulty.

Jan 26, 2013 | 2005 Pontiac Aztek

1 Answer

The service vehicle soon light is on and the temp gauge is below cold, but it sounds like the fan is still running after the engine is shut off also. What could cause this?


the fan is the temperature sender is or could be faulty ,as for the service light this vehicle isnt listed in a europeon alldata book

Dec 25, 2010 | 2001 Pontiac Aztek

1 Answer

The temp gauge is not showing any heat but fan air is warm not hot .changed the temp sensor but still no gauge reading .the cooling fans on the rad are going all the time for about 5 mins even after i stop...


I am having the same problem with my 2001 Aztek. I changed the temperature sensor. It worked for a while and now its doing it again. One mechanic told me it problably needs a new thermostat. I might try that. Will try and report. If you have found a solution please let me know.

May 21, 2010 | 2001 Pontiac Aztek

2 Answers

Temp gauge goes to hot and engine looses power.


hi.. your coolant temp sensor may be getting a bad reading, it also opperates as a compensator so it may effect the power of the vehicle.. check that the engine is actualy hot when it says and your car will probably run alot better if you change it anyway..

Feb 10, 2010 | 2001 Pontiac Aztek

1 Answer

Aztek over heating cooling fans not coming on the


temp gauge working proprely?turn on ac both fans should kick on after a few if not replace it

Jun 20, 2009 | 2001 Pontiac Aztek

1 Answer

Cooling Fans


Hello dc8jimmy...did you check the voltage to the fans? The Aztek is a known overheater...Run a diagnostic scan to see if you have a cooling fan relay circuit open short. Will be easier to correct the problem when you know where to look. I think Haynes has a publication on the Aztek that covers the 01-05 year models.
Good luck...i hope this helps.

May 17, 2009 | 2001 Pontiac Aztek

1 Answer

Fuel gauge in 2001 Aztek 140k miles doesn't work.


Hi, Sounds like it has a bad fuel gauge sender, location is in the fuel tank.

Dec 02, 2008 | 2001 Pontiac Aztek

Not finding what you are looking for?
2001 Pontiac Aztek Logo

Related Topics:

128 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8759 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...