Question about 2005 Dodge Dakota
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: can't remove spare tire on
the way to let the tire down is insert the jack handle in the hole above the license plate at the top left .the turn counter clockwise to let the tire down by means of the cable......hope this helps
Posted on Jan 06, 2009
To change the sparks on a 2005 4.7L Dodge Dakota you will need the following:
Note you will have to remove the air intake located at the top of the engine, and will have to move some of the coolant lines out of the way.
At the top of the engine there are 4 sparks on each side. The coils are held in place with a 10mm bolt. Undo the 10mm bolt and unclip the coil. Next pull out the coil.
Insert the socket, with extension into the spark plug hole.
Remove spark plug.
Check the gap on new spark plug, it should match stock.
tighten to approximately 25ft.lbs. (check spark-plug packaging for exact torque requirements).
repeat this process with all other sparks.
be sure that no dirt gets into the spark plug holes.
Posted on May 11, 2009
It's really not that difficult to access and remove your car stereo. If you do plan on pulling / making new connections it's important to disconnect power to the vehicle first. This can be done by pulling the negative (black) terminal from the battery. A quick google query on your vehicle actually came across some very good pictures of the process LINK . While the work done on that site is not specifically addressed to your need, it should be useful for what to expect and how things will look. It looks like there are two screws located near the base of the trim that need to be removed first. Next, you need to carefully pry the trim piece back as it is held on by some retainer clips. It is important not to be too forceful as the trim, the clips, or even worse things could get damaged. Try to find a small spatcula or plastic scrapping tool to help guide the trim away from the dash. Once you get the trim off the radio looks to be held in place by four black #2 phillips head screws. Take those screws out and gently pull back the radio head just far enough to access the wires in the back. The wires will plug into the back of the radio with a plastic harness. Again use care in trying to remove the wires so as not to cause any damage. Do not pull on the wires themselves but rather the plastic harness. There should also be one small jack that is for the antenna connection. Remove this also. Then there you have it! Your radio should be out allowing you full access to it. As for the iPod accessory, that may be another story on installation. Good Luck!
Posted on Jul 07, 2009
Tips for a great answer:
Aug 24, 2015 | 2006 Dodge Dakota Quad
Mar 14, 2014 | 2005 Dodge Dakota
Oct 09, 2012 | 2004 Dodge Dakota
Feb 26, 2011 | 2005 Dodge Caravan
Feb 23, 2011 | 1993 Dodge Dakota
Apr 27, 2010 | 1992 Dodge Dakota
Aug 08, 2009 | 1997 Dodge Dakota
Jun 25, 2009 | 2005 Dodge Dakota
Aug 14, 2008 | 2005 Jeep Liberty
359 people viewed this question
Usually answered in minutes!