Question about 2002 Chevrolet Monte Carlo

1 Answer

Car wont start

Starter wont turn but after several tries it finally turns over and starts

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

  • Expert
  • 76 Answers

It sound like a bad starter if you take it off autozone will check it for free good luck..

Posted on Nov 08, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 56 Answers

SOURCE: car wont start. turns over but wont stay running

your cars antitheft system is trying to prevent the car from being stolen so it is shutting it offf after it starts. go back over step by step you installation instructions make sure the ring around the ignition that comes with the remote starter is taped into the exact loacation it needs to be, or the cars own anti theft system will not notice it and will try to shut car off. its an anti theft feature. if this doesn't wotk you will not be able to use this remote starter. i ran into the same problem finally got it to work poperly.

Posted on Jan 24, 2010

  • 2 Answers

SOURCE: 1997 Chevy Cavalier intermittent starting

I had the exact same problem on my 1998 Chevrolet 1500 c/k pickup. I also tried a new starter motor and solenoid assembly, but to no avail.

After weeks of searching for the problem, I found that corrosion had built up between the car battery terminals and the power cables extended from the car battery to the starter motor. I'm not sure if this is your problem, but it's worth a try. Also, check all other electrical connections, because these types of intermittent problems are often electrical.

Posted on Oct 19, 2008

MrScary66613
  • 1990 Answers

SOURCE: clicking noise when trying to start car,battery is ok, wont start

That Clicking is the Battery causing it not to Start. You need to Replace that Battery or at Least put a Charger on it for a Couple of hours to see if you can Salvage it for a While.

Posted on Jan 19, 2009

aaangie220
  • 202 Answers

SOURCE: 97 chevy cavalier z24 2.4L wont start

sounds like a fuel pump. check for the car losing fuel pressure and you probably needed to turn the key a few times on off on to build enough pressure to start it. it wouldn't hurt to check the fuel pressure regulator as well a good throttle body cleaning won't hurt as well.
But worst case scenerio would be a timing chain with too much slack. those motors are known for it.

Posted on Feb 09, 2009

  • 2 Answers

SOURCE: Camaro wont turn over

best bet is the starter.pull run wire to it if it jumps its ok

Posted on Jul 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 Ford Expedition el limited sometimes starts great but most times does nothing when try to start everything still comes on and has power but does not turn overrun less I keep turning keys off and back...


Could be the key switch, or the starter, or another component.
You would need to check for power at the starter terminals when the key is in the start position.

Mar 25, 2015 | 2008 Ford Expedition Limited

1 Answer

Problems washing engine will not start or turn over


hopefully you just fried your starter have someone tap it while you try to start it and if it starts then the solenoid is fried and you need a new starter but dont turn it off untill you get to your finall destination beacuse it wont start back up again

keep me updated

May 07, 2014 | Toyota Cars & Trucks

2 Answers

Wont start after replacing starter


Obviously you had a fuel or ignition problem. If engine turns over then no need to replace starter. Now it sounds like starting problem has occured. Is the battery fully charged?

Mar 04, 2014 | Volkswagen Cars & Trucks

1 Answer

Santa fe 2007 wont start makes a single click noise


May be ab bad starter solenoid, or corroded/loose connection at starter, or (ground). Could also be a bad ignition switch. Start from the load; the starter. Test for 12V at starter, OK. Connect short wire from starter and touch sylenoid connection..

Nov 09, 2013 | 2003 Hyundai Santa Fe

1 Answer

2005 jeep wrangler unlimited starting [problem, replaced the starter, ignition switch but problem is still there. Starter will stay ingaged but not long enough to start the vehicle. After several tr


There are several things you need to check. Start by checking the alignment between the pinion gear of the starter and the flywheel. If that is loose or binding the starter will do this. Next, check teh starter relay to make sure it isn't faulting out. finally, if you have an Alarm installed, cut the power wire to the alarm or pull the fuse to make sure it isn't the Anti-Theft circuit malfunctioning and stopping it from starting.

Oct 25, 2011 | 2005 Jeep Wrangler

1 Answer

How do I change the starter on a 99 avalon


Could be your starter, sounds like your starter soloinoid(pulls starter gear into flywheel) might be defective. First it will not pull gear in, then if it sticks in your car could keep starting even if the key was turned off .
without looking at the car I could'nt say how hard it would be to change. It has been my observation that newer cars are much more difficult to change

Jul 26, 2010 | 2000 Toyota Avalon

1 Answer

2001 grand caravan starting problem


You must be sure that the connections at the starter are sound. If they are o/k then check the current draw at the starter when the problem occurs.This can be done with a voltmeter attached to the battery and watch the voltage when someone is tryihg to start engine. If voltage drops to 10 volts or less that means the starter wants to turn. If voltage does not drop then it means the starter has a bad internal connection. Probably bad brushes. If this is what is wrong then starter replacement should occur

May 09, 2009 | 2001 Dodge Grand Caravan

2 Answers

1995 Cavalier Z24 Car Wont Start


You either have a bad solenoid on your starter OR a bad ignition switch as these are the only two things that can cause the symptom you describe... I lean to the solenoid first, RARELY does an ignition switch sieze up in the start position but it is a possibility. Several national chain parts stores can test the starter for you (GM starters have the starter solenoid mounted directly to the starter and you need to remove the starter to get to it, so you would take the whole unit in to test it... REMEMBER to disconnect the battery first!)

Apr 13, 2009 | 1998 Chevrolet Cavalier

Not finding what you are looking for?
2002 Chevrolet Monte Carlo Logo

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...