Question about 2007 Chevrolet Cobalt Coupe

Open Question

2009 cobalt 2.2ltr P0014

Exhaust side bank 1

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

P0017 and p0014 cobalt 2009


So, I hate to be the bearer of bad news but the codes are as follows.

P0017-Crankshaft Position - Camshaft Position Correlation Bank 1 Sensor 'B'
Possible causes
- Mechanical timing fault
- Blocked oil passage
- Low oil level
- Faulty Exhaust ('B') Camshaft Position (CMP) Sensor
- Faulty Crankshaft Position (CKP) Sensor

P0014-Camshaft Position 'B' Timing Over-Advanced or System PerformancePossible causes
- Dirty Oil
- Low engine oil level
- Faulty Exhaust Camshaft Position Actuator Solenoid
- Exhaust Camshaft Position Actuator Solenoid harness is open or shorted
- Exhaust Camshaft Position Actuator Solenoid circuit poor electrical connection
- Faulty Engine Control Module (ECM)
Bank 1

So in short, you can try the oil change if its been a while, always a good practice, however the fact that its throwing both of these codes together, makes me heavily suspect that your car is experiencing the worst of the possible causes, all your symptoms are tell-tale signs of your cars timing being off, meaning a timing belt job is needed. I highly recommend trying your best not to drive that vehicle, if the timing belt grenades on you while your driving, it will cause catastrophic damage to your motor. I cannot stress to you enough to limit your driving. Timing belt jobs as a general rule of thumb, are anywhere from $700-$1000 depending on the shop, anything more and they are ripping you off. I hope this helps, Good Luck!

Dec 04, 2016 | 2009 Chevrolet Cobalt

1 Answer

OBDII Codes


P0014 - Exhaust Camshaft Position System Performance
P0973 - Shift Solenoid A Control Circuit Low
P0700 - Transmission Control System Malfunction

Dec 18, 2013 | 2010 Chevrolet Cobalt

1 Answer

Not working right


code p0014 refers to camshaft position(CMP) actuator . exhaust /right /rear bank 1--timing over advanced/system performance===causes valve timing--engine mechanical fault--CMP actuator . If you have done no work on the engine then I would be replacing the exhaust cam actuator (CMP actuator)

Nov 17, 2013 | 2002 Oldsmobile Bravada

2 Answers

Code p0014 exhaust and code p0015 exhaust


The code P0014 is for Camshaft Positon Sensor Actuator Bank 1. The possible causes are incorrect camshaft timing, wiring problems (harness/wiring) in intake timing control valve solenoid system; continuous oil flows to VCT piston chamber or failed timing valve control solenoid(stuck open).
The code P0015 is for Camshaft Position -Timing Over-******** (Bank 1). Your problem will probably be that the timing will be slightly out, due to wear (stretch) of the timing chain; this will all be linked to the overall cold start issue and the timing position. Get that timing checked, or push for the full fix for the cold start timing issue.

Jul 25, 2013 | 2007 Mini Cooper

1 Answer

Check engine light code p0014 exhaust and p0015 exhaust


P0015: Camshaft Position, Act B - bank 1, timing over

P0014: Camshaft Position, Act B - bank 1, timing over advanced
Check oil level and quality.
Remove n clean exhaust camshaft vanost actuator.
Do not refit to exhaust cam, but swap with inlet actuator.
clear codes...if eml on again see if fault moved to inlet cam. If so replace the actuator.

Jul 25, 2013 | 2007 Mini Cooper

2 Answers

What is code p0014


P0014 : Camshaft Position Actuator

Dec 19, 2010 | 2003 Chevrolet TrailBlazer

1 Answer

I have an 2006 Pontiac G6 with 4cyl and automatic. I got a p0014 camshaft position actuator B-bank 1, timing over advance. could it be the sensor or do you think the timing belt needs to be replaced?...


hi, this is due to oil pressure send to the exhaust camshaft position sensor,, before u change this sensor or checking engine timing,, change the positon of sensor a to sensor b and check the dtc if it is still p0014, if other dtc will send to ecmit means that the sensor is the problem, if P0014 still the code, you may now check bank 1 timing

Jul 27, 2010 | 2006 Chevrolet Trailblazer

Not finding what you are looking for?
2007 Chevrolet Cobalt Coupe Logo

Related Topics:

152 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...