Question about 2002 Chrysler Sebring

1 Answer

My car runs hard and when it get warmed up it stalls out and wont start back i have replaced so much on this car please help

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 689 Answers

There are 15 or more sensors on it,Depens on how it is equip.

Posted on Nov 08, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

dealt_soul
  • 296 Answers

SOURCE: 2003 chrysler sebring

Could be starter, or neutral switch in the tranny.

Posted on Jan 18, 2009

dustyboner
  • 331 Answers

SOURCE: 2000 chrysler sebring conv

this is the diagnostic procedure for your problem. (this is actually from a 3.0L engine but the procedure is exactly the same for the 2.5L)

click for full size
3f6ba68.jpg
2627050.jpg

5e54c06.jpg

Posted on Jan 24, 2009

motor1258
  • 6674 Answers

SOURCE: CODE P0420

Check for any exhaust leaks, hopefully your not burning oil, or losing coolant, and have exhaust checked for possible plugged catalytic converter.

Posted on Apr 27, 2009

pippall
  • 1486 Answers

SOURCE: 2003 chrysler 300m o2 sensor and camshaft position sensor

SOUNDS LIKE YOU HAVE CAMSHAFT DAMAGE.

Posted on May 30, 2009

  • 64 Answers

SOURCE: 97 Chrysler 2.5L runs bad when warm stalls and knocks no MIL

It sounds like you did not change those intake manifold gaskets and they are not completely sealing the intake and causing a vacuum leak and the MAP sensor will read high in voltage and cause the bad idle.

Posted on Oct 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Starts right up but once it warms up it dies have messed with the air gas screws that's fine don't know what the problem is


My car runs good when it's cold but stalls once it warms up ...

www.badasscars.com/index.cfm/page/ptype...id.../prd289.htm
My car runs good when it's cold but stalls once it warms up? ... In this situation, you can usually re-start the engine once it has hada chance to cool back ... it'll fill-up and exits fuel right up and out the vent tube which dumps it down the middle of ...

Car starts and after warmed up.. it dies!! HELP! - Honda-Tech

honda-tech.com/...del.../car-starts-after-warmed-up-dies-help-2797652/
Jun 28, 2010 - Car starts and after warmed up.. it dies! ... but if i let it sits for awhile till the engine is cool down it starts right up but after its warmed up.. it dies.

Troubleshooting an Engine that Stalls at Idle When Warm ...

www.gearheaddiva.com/.../troubleshooting-an-engine-that-stalls-at-idle-...

Dec 21, 2015 | Cars & Trucks

1 Answer

Car starts but will not stay running


I don't know what the other place did but it's almost always the idle air control valve that causes stalling and hard starting, the valve can stick due to excessive carbon deposits, it is located on the bottom of the throttle body, it has to be removed so the IAC valve can be replaced, so if the engine is running normally otherwise with no misfires then replace the IAC valve and clean the throttle body to solve this problem.

May 06, 2014 | 1999 Toyota Camry

1 Answer

My gmc 4.3 stalls when warm and wont start without ether. then it runs fine


I had the exact problem with my 1993 chevy c1500. I found that the IAC was sticking so the engine would die at idle after warming up and the ignition module was pulsing the ECM intermittently after the engine warmed up so the fuel pump wasn't being turned on after the engine died....I replaced the ignition module and the IAC valve and all is good. I don't know if testing the ignition module reveals that it isn't sending pulses to the ECM.

Mar 28, 2013 | 1991 GMC Sierra

1 Answer

1995 Ford Windstar has an intermittent stalling issue.


If it wont stall in neutral or park it may have a bad torque convertor clutch in the trans causing the engine to stall.

May 07, 2010 | 1995 Ford Windstar

1 Answer

1990 plymouth voyager stalls and I have a hard time restarting when engine is at running temp, Please help


A warm enigine takes more fuel pressure to start then a cold engine. Start by replacing the fuel filter. If that isn't the issue, then you might be looking at needing a new fuel pump.

Mar 04, 2010 | 1990 Plymouth Voyager

1 Answer

2005 ford f150 5.4 stalled and wont start easily.


Check crank shaft sensor and cam sensor.

Mar 24, 2017 | 2005 Ford F-150

2 Answers

Stalls when warm 95 camry


sound like your have the bad distributor, when you have trouble starting remove the distributor and have the auto part check it.

Nov 23, 2009 | 1995 Toyota Camry

2 Answers

97 bonneville intermitant stalling


leake intake manafold or bad vac line... try warm soapy water on running motor out of a spray bottle to find leak... the reason the censor seemed to hel is that the take time to set them selfs... after set back to square 1 leak in the air side of motor... typical in your car...

Jul 08, 2009 | 1997 Pontiac Bonneville

2 Answers

Changed the fuel injector on 95 Cavalier 2.2 moter. Car acts like it wants to start, but doesn't.


did you check you fuel filter and your fuel pump? i had the same problem and once i replaced the fuel filter its been fine since

Apr 18, 2009 | 1997 Chevrolet Cavalier

Not finding what you are looking for?
2002 Chrysler Sebring Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...