Question about Dodge Cars & Trucks

1 Answer

I have a 1991 dodge dakota 6 cylinder, it runs good at idle but when I take off it looses power and spits and spudders. If I floor it then the truck will eventually cut off. I have already replaced the pick up coil. What should I look at next?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 190 Answers

SOUNDS LIKE THE FUEL PUMP MAY BE WEAK

Posted on Nov 07, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 1995 Dodge Dakota Pick up

go to Didgeforums.com.

I had a similiar problem, found the solution there. It was the wiring harnes on the drivers side under the hood, just above the wheel well. there are a cluster of wires in a bundle. I unpacked the bundle carefuly and sure enough the were two or three wires all coroded, had wite powder from corosion. repaired the connections and bingo. I posted details at dodgeforums.com. browse around there. I posted pictures as well. this is a common problem.

Posted on Sep 05, 2008

  • 1118 Answers

SOURCE: Intermittent starting problem/shutdown problem - 1991 Dakota

did you replace ignition madule? I see you chg. everything else but that. they can be fine when cold, but when they get hot quit working.

Posted on Feb 01, 2009

cj5470110
  • 41 Answers

SOURCE: what kind of oil do i use in my 06 dodge dakota, 6

most dodges take 5 quarts of 5w30. but to be sure it will say in your owners manual which grade and how much to use.

here is a nice instructional video to assist you iin changing your oil on a dodge dakota if you are inexperienced in doing so.

http://revver.com/video/183724/dodge-dakota-oil-change-repair-vide/

Posted on Jul 11, 2009

arauzvictor1
  • 466 Answers

SOURCE: misfire on number 6 cylinder have replaced

If you changed and the injector and the coil and does not work change the spark that cylinder and see if comes to that coil voltage (positive and negative) and is less negative than if the PCM does not work that coil. Thanks good luck and opinions please

Posted on Jan 29, 2010

  • 1024 Answers

SOURCE: how to test a crankshaft on a 1993 Dodge Dakota

check your catalytic converter for clogged up.
disconnect the exhaust pipe before the cat and run the engine to see if it still cut off.
if it run better, then that's the problem

Posted on Mar 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

TPS 94 Dodge Dakota 2.5l keeps losing power.


Have you checked your ground to the engine block itself? Many times this is the culprit.

Jun 02, 2017 | 2001 Dodge Dakota

1 Answer

How do I fix a 2002 Dodge Dakota V6 engine that is misfiring on Cyls. 1,3,5?


you need to check the plugs for those cylinders and the fuel injector that feeds that side of the engine it may not be working or is plugged with dirt. then it could be a vacuum leak around those cylinders. just some places to start.

Sep 21, 2014 | 2002 Dodge Dakota Club Cab

1 Answer

Truck is not firing on 3 cylinders yet it runs.. Runs really rough, back fires, under powered.. Plugs are Wet, Firing order is correct. New Spark plug cables. Don't know that is wrong! Please Help


Check for spark at the plug ( may have coil problem).
If spark is good then do a compression check. Pressure shouldn't be less than 75% of known good cylinders.

Apr 17, 2013 | 1995 Dodge Dakota

1 Answer

98 dodge ram 1500 the truck idles funny and spits and spudders and misses when you give it gas. if you put it in drive and give it gas it does not go anywhere it backfires out the exhaust and intake. But...


Code 1683 is for a problem with the EGR solenoid which controls the EGR valve, and code 597 is for the IAC valve not being able to keep idle speed at the correct setting.
A leaking EGR valve could cause the symptoms you describe.
I assume you looked at the cap and rotor and they are ok.

Jan 15, 2013 | 1998 Dodge Ram 1500 4WD

1 Answer

Need to know fuel pressure for 91 dakota 3.9


Have you cycled key to obtain any fault codes?

Nov 22, 2012 | 1991 Dodge Dakota

1 Answer

Some of the spark plug wires on my 1991 Dodge Dakoa Sport V8 inadvertantly got removed from distributer cap and I'm not sure I put them all back in the correct order. If anyone can provide information on...


For the 1991 Dodge Dakota 318 cubic inch = 5.2L V8

Firing Order:
1-8-4-3-6-5-7-2

Cylinders:
..........(back)...........
|...8...|..........|...7...|
|...6...|..........|...5...|
|...4...|..........|...3...|
|...2...|..........|...1...|
..........(front)

Distributor:
............3
....4..............6...
.......................(+)-screw: rounded-end of Cap
8......................5
(+)-screw: square end of Cap
.....1...............7
..............2
.........(front)

Rotation: Clockwise

Let me know if this helped, or if you have additional information questions. Feel Free to contact me at FixYa.com!

Aug 26, 2010 | 1991 Dodge Dakota

2 Answers

Need pics of firing order for 91 dodge dakota 3.9


If you are looking at your engine from the front of the truck, here is the cylinder layout:
6 5
4 3
2 1
The distributor rotates clockwise and the firing order is:
1-6-5-4-3-2
You can find a picture of this at:
http://autorepair.about.com/library/firing_orders/bl-fo-9158.htm

Sep 12, 2009 | 1991 Dodge Dakota

2 Answers

When car is at stop light or when i start it it


it could be the throttle positioning sensor.

Jun 04, 2009 | 1991 Dodge Dakota

1 Answer

Truck Cuts off Only in Drive


I have the same truck and have had the same problem, this is what fixed it,, clean the idle speed control valve and throttle body with the CRC throttle valve cleaner and disconnect the battery for 5 minutes, that should cure the problem

Mar 06, 2009 | 1997 Dodge Dakota

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...