Question about 2006 Ford Freestar

1 Answer

2006 FREESTAR HARD STEERING TO THE LEFT RIGHT IS WORKING GOOD

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 177 Answers

It is a common issue of this model of Ford. I think you should get it checked with the dealer.


Get A Performance Chip

Posted on Nov 07, 2012

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Cruise control on 2006 ford freestar is not

it was "activation switch" found under brake reservoir. Dealer replaced under warranty.

Posted on Apr 27, 2009

  • 2187 Answers

SOURCE: hard steering

Sometimes problems like this can be caused by incorrect tire pressure. Check also the tie rod ends if it is busted. Check for leaks on either side of the wheel if there are leaks on the steering linkages. If the car has been serviced the steering column may have been moved causing it to hit something under the dash.

Posted on Jun 04, 2009

SOURCE: ford 2006 freestar sel, violent

The job either wasn't done correctly or somehow the Wheel Sensor Harness, got involved in a way it shouldn't have.

Posted on Sep 28, 2010

SOURCE: 2006 FREESTAR CONTROLS IN STEERING WHEEL STOPPED

probably a connection plug got pulled out n u just need to plug it back in or u have broken fuses that u can easily replace. Good luck.

Posted on Sep 24, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace sliding door wire harness with chain fo 2006 ford freestar


ford sells parts at there parts counter brick and online
if you google there are 100s.
1st hit
i had to guess which of 8 submodels. SE , SEL, etc.
guess SES
right or left? guess, right.
wild guess, if this is wrong call them and ask for parts, they will find it and tell you, (any car made)
http://www.fordparts.com/Commerce/CatalogResults.aspx?y=2006&m=Ford&mo=Freestar#Search


base
http://www.fordparts.com/Commerce/CatalogResults.aspx?y=2006&m=Ford&mo=Freestar#Search

Jan 08, 2015 | Ford Cars & Trucks

1 Answer

2006 FORD FREESTAR HARD STEERING TO LEFT RIGHT TURN WORKS GOOD


That is a problem ,Where you just can,t wing it end stay what is causeing it to do that, With out checking the car out, It will have to be taken in to a shop. To find out what the problem is,

Nov 07, 2012 | 2006 Ford Freestar

1 Answer

2006 FREESTAR CONTROLS IN STEERING WHEEL STOPPED WORKING, AND HORN WONT WORK


probably a connection plug got pulled out n u just need to plug it back in or u have broken fuses that u can easily replace. Good luck.

Sep 24, 2011 | 2006 Ford Freestar

1 Answer

How do i remove the drivers side airbag on a 2006 Ford Freestar


On steering wheel ? first disconnect both cables on battery.Then remove the screws holding the airbag.Now diconnect wires and it should be free

Jun 11, 2011 | 2006 Ford Freestar

1 Answer

I need to know the procedure to reset, 'Change Oil warning' on my 2006 Ford Freestar.


On the right side of the steering wheel there is a button that says "setup". Turn the ignition key to the on position, push the setup button and hold it until the change oil warning shows 100%. There should be a message that pops up telling you to push the reset button to the right of the setup button. Push the reset button and hold until the message confirms the oil life has been changed to 100%. Release button turn off ignition key. Now start the engine to make sure the warning light does not come back on. If it does, try again.

Jan 22, 2011 | 2006 Ford Freestar

1 Answer

2004 freestar


the most common cause of this in your Ford based on my dealer related repairs would be a part called the rotating ribbon contact (Ford refers to this part as the Clock-Spring contact.) that connects the steering wheel airbag to the steering column wiring, this contact coils and uncoils as the wheel is turned left and right and makes a solid connection to all steering wheel mounted components and controls. To change this part you must dis-arm the airbag and remove the steering wheel, if u do this repair yourself it is very important that u dis-arm the SRS system before starting work, this can be done by disconnecting the battery for 1 hour.

Feb 03, 2009 | 2004 Ford Freestar

1 Answer

Steering system makes a whining noise when van turning left or right. Noise started when turning to left but now does in both directions and is getting louder. What partis causing noise?


This is caused by the power steering pump, the only way to correct it is to flush the power steering system and replace the pump

Oct 31, 2008 | 2004 Ford Freestar

Not finding what you are looking for?
2006 Ford Freestar Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...