Question about Cars & Trucks

1 Answer

Engine fault light - Cars & Trucks

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 14,200 Answers

Go to Autozone,they will scan it for free.

Posted on Nov 07, 2012


1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How to get rid of a check light with out scan tool


Check light is a warning sign of something faulty, like sensors,relays,solenoids, and even a short. So to get rid of the check engine you must run codes with scanner and fix it. No other turn around possible. If you tamper with the function of the instrumental panel it will cost you more. Plus is unlawful mostly in the 51 States to modify such thing to pass emissions. Good luck

Dec 27, 2015 | Cars & Trucks

1 Answer

Reduce engine power light comes on 2005 buick lacross


The check engine light n or reduced power light comes on when the on-board computer detects a fault in engine driveability or performance, transmission control system or transmission, or the emissions system, and a fault code is set and stored in the computer. Faults that can set the check engine light can range from a vaccuum leak, engine mis-fire, low engine compression, faulty sensor such as O2 sensor or other engine sensor, hydraulic pressure loss in transmission, transmission shift solenoid, open/short in wiring harness, emission evaporative system leak, or one of over a hundred different reasons. The only way to know what set a fault code and turned the check engine light on is to have a diagnostic scanner hooked up to the on-board computer and read it for stored diagnostic fault codes. Many auto parts stores will do this service for free- (like auto zone)check with you local parts stores. If none in your area do, then you will have to take it to a shop and pay to have the computer read for stored fault codes. Without knowing the fault codes numbers, it would be irresponsible to guess as to the cause as there are hundreds of possible causes.

Nov 16, 2015 | Buick Cars & Trucks

1 Answer

I have a 52 plate Vauxhall zafira 1.6 and for some reason it wont go past 65 mph can someone please help me also engine management light on


run the fault codes to find the fault that put the engine light on. It is either an engine management light or a transmission fault light

Jul 20, 2014 | Cars & Trucks

1 Answer

Bmw x5 abnormal light engine fault light


In normal driving engine fault light abnormal light. Diagnosis diagnosis with BMW ICOM.Check exhaust pipe, air inlet pipe; check the sealing of the coking problem, is most likely to damage caused by oxygen sensor.Advised a change of oxygen sensor.

Dec 07, 2013 | BMW X5 Series Cars & Trucks

1 Answer

Computers ecu not working 89661-2B381


Pick-up after the inspection results are as follows: 1. Engine starts without high-pressure fire; 2 engine nozzle on the fuel injection pulse measuring less; 3 Turn the ignition switch, the engine warning light does not shine (under normal circumstances, turn the ignition switch, engine fault light should be lit. electronic control unit after starting the engine electronic control components for 4 ~ 6s self, confirmed there is a fault fault lights lit, no fault fault light goes out). Taking into account the car ignition and fuel injection are directly controlled by the ecu, ecu lack of work is likely to be unable to work due to voltage.
or you can ask the 24 hrs live obd vas5054a technical support, they will like to help you, good luck

Aug 17, 2013 | Toyota Corolla Cars & Trucks

1 Answer

Engine light still stays on


The check engine light comes only when the computer control unit (called the PCM) senses a fault in the electronic controls of the engine and/or the emission system, there are about 200 possible faults that turn the light on, to know what has developed a problem you must have the system tested, this is called an OBD2 fault code test, Kragen and Autozone parts stores do this testing for free. Until the fault that turned the light on is correctred the klight will remain on, u can disconnect the battery for 5 minutes to clear the light or ask the parts store to clear it for you, as far as the reverse light problem goes u most likely have a defective reverse light switch, replace it.

May 22, 2010 | 2003 Chevrolet Aveo

1 Answer

Engine managment light flashes (glow plugs light)


the car is going into limp mode due to an engine management fault. have to check what the fault is with a code reader. if the milage is high 100,000+ could be a turbo fault (overboosting), as this will put the car into limp mode.

Feb 21, 2010 | 2005 Volkswagen Passat

2 Answers

Check engine light on 1998 Z3 BMW


BMW engine light

Comes on if DME engine management system self diagnostic fault detected. Will stay on until codes are called up and memory erased.

With OBD read the code as follows. Turn on ignition key, press accelerator pedal to the floor five times within 5 seconds. The check engine light will remain on for 5 sec , blik off, come on for 2,5 sec, go off for 2,5 sec and fault code will begin to flash. If more than one fault exist 2nd fault code will be separated by 2,5 sec pause. after fault codes there will be a 0.5 sec flash and light will remain off. to read codes again do procedure again.

Canceling of codes. make sure fault code is present (short blink and light goes out for long period), depress throttle pedal for at least 10 sec. read fault codes again and check for code 1444 (no faults stored.)

Check also the following, fuel pump, oxygen sensor, fuel injectors, engine coolant temp sensor, idle speed control valve, mass airflow sensor and too many other things.

Jun 16, 2009 | 1998 BMW Z3 Roadster

3 Answers

The engine light recently came on and now the engine spurts at acceleration.BMW328


when the engine light comes on the defect on the engine can be a blocked exhaust system or an air leak to the manifold. the oxygen senser monitors the runnig condition of the car and will inform you that the engine is not run correctly. diagnostic can tel you the defect

Jun 13, 2009 | 1997 BMW 328

1 Answer

Codes for 1995 Mitsubishi eclipse


Engine-light-help.com

P1100 Induction Control Motor Position Sensor Fault

P1101 Traction Control Vacuum Solenoid Circuit Fault - Read Our Article On Automotive Circuit Testing For Help With This Mitsubishi Check Engine Light Code

P1102 Traction Control Ventilation Solenoid Circuit Fault - Read Our Article On Automotive Circuit Testing For Help With This Mitsubishi Check Engine Light Code

P1103 Turbocharger Wastegate Actuator

P1104 Turbocharger Wastegate Solenoid

P1105 Fuel Pressure Solenoid

P1294 Target Idle Speed Not Reached

P1295 No 5 Volt Supply To TP Sensor

P1296 No 5 Volt Supply To MAP Sensor

P1297 No Charge In MAP From Start To Run

P1300 Ignition Timing Adjustment Circuit - Read Our Article On Automotive Circuit Testing For Help With This Mitsubishi Check Engine Light Code

P1390 Timing Belt Skipped One Tooth Or More

P1391 Intermittent Loss Of CMP Or CKP Sensor Signals - Read Our Article On Automotive Circuit Testing For Help With This Mitsubishi Check Engine Light Code

P1400 Manifold Differential Pressure Sensor Circuit - Read Our Article On Automotive Circuit Testing For Help With This Mitsubishi Check Engine Light Code

P1443 EVAP Purge Control Solenoid '2' Circuit Fault

P1486 EVAP Leak Monitor Pinched Hose Detected

P1487 High Speed Radiator Fan Control Relay Circuit Fault - Read Our Article On Automotive Circuit Testing For Help With This Mitsubishi Check Engine Light Code

P1489 High Speed Condenser Fan Control Relay Fault - Read Our Article On Automotive Circuit Testing For Help With This Mitsubishi Check Engine Light Code

P1490 Low Speed Fan Control Relay Fault

P1492 Battery Temperature Sensor High Voltage

P1494 EVAP Ventilation Switch Or Mechanical Fault

P1495 EVAP Ventilation Solenoid Circuit Fault

P1496 5 Volt Supply Output Too Low

P1500 Alternator FR Terminal Circuit - Read Our Article On Automotive Circuit Testing For Help With This Mitsubishi Check Engine Light Code

P1600 Serial Communication Link

P1696 PCM Failure EEPROM Write Denied

P1698 No CCD Messages From TCM

P1715 Pulse Generator Assembly

P1750 Solenoid Assembly

P1791 PCM ECT Level Signal To TCM Circuit Fault

P1899 P/N Position/Transaxle Range Switch Circuit Fault - Read Our Article On Automotive Circuit Testing For Help With This Mitsubishi Check Engine Light Code

P1751 A/T Control Relay

P1791 Engine Coolant Temperature Level Input Circuit - Read Our Article On Automotive Circuit Testing For Help With This Mitsubishi Check Engine Light Code

P1795 Throttle Position Input Circuit To TCM - Read Our Article On Automotive Circuit Testing For Help With This Mitsubishi Check Engine Light Code

Mar 21, 2009 | 1995 Mitsubishi Eclipse

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

118 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...