Question about 2000 Chevrolet S-10

1 Answer

2000 s10 cranks, won't start, but tries to start when you let off the key, any ideas

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chevrolet Master
  • 74,945 Answers

The following are the general instructions on the start of diagnosing any electronically controlled engine or transmission problem.

The engine and the automatic transmission (transmission control is only for automatics, engine is still computer controlled no matter the transmission type) in this vehicle are computer controlled and in most cases when a fault occurs a fault code is stored in the memory of the computer control module. There are exception to this, such as the Mass Airflow Meter and fuel pressure problems. What must be done is to have all the basic testing done such as a scan of the system for fault codes as well as a check with a live data scanner tool for engine functions that are not within range of normal, a trained technician is required to know what is correct and what isn't, then based on careful diagnostics done from a factory repair manual the correct part is replaced or the wiring repaired or the computer replaced (known as the PCM or ECM,ECU), which is very rarely the problem. Other basic checks must be done as well such as mechanical problems with the engine as well as engine state of tune and mileage on the engine. The transmission can have mechanical issues as well such as no gear engagement at all or a failed pump or other pressure related problems. Also engine mechanical problems can and do cause many drive-ability related problem such as rough idle and other symptoms.

Posted on Nov 07, 2012

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1992 4.3 v6 tbi s10 starting problem. Won't squirt


Are the injectors getting power and a ground signal from the computer ?

Sep 06, 2013 | Cars & Trucks

1 Answer

98 Pontiac Bonneville intermitanly stalls & won't restart.


If you have a vats system (anti-theft) it needs to be reset

May 05, 2017 | 1998 Pontiac Bonneville

1 Answer

My 2000 Dodge Caravan won't start


Are you saying the engine will not crank, or crank but will not start ?
None of the engine sensors come into play until after the engine is cranking.
Cranking problems can include the neutral safety switch and other factors with the crank circuit back to the key switch.

May 04, 2013 | 2000 Dodge Caravan

1 Answer

2000 sable won't start. Battery good, gets fuel, tries to start, but won't fire.


Does the vehicle gets spark? if yes check with scanner whether is there any problem with crank or cam sensor failure.

Sep 16, 2012 | 2000 Mercury Sable

1 Answer

Driving in 105 degree temp, truck quits! What happened?


If the engine won't crank with compression in the cylinders, either the head gasket has blown or something else major has happened.
You will have to get it towed to a shop.
If it cranks normally but won't start, you have to figure out if it is a fuel or ignition problem.
Did the temp gauge show it was overheating before it died ?

Jun 30, 2012 | Cars & Trucks

1 Answer

2000 jeep wrangler wont start


If it won't crank, check clutch safety switch and cables for the starter.
If it cranks but won't start, you'll need to find out if it is ignition or fuel to know where to look next.

Jun 26, 2012 | 1994 Jeep Wrangler

1 Answer

The 'theft system' light does not turn off with the key in the run position on my 1999 chevy cavalier. car won't start, it won't even crank over. the battery and the starter are brand


try locking your car with the key and unlocking it with the key, leave it for 30 second or so between the locking and unlocking , the car thinks some one has tampered with it

Mar 18, 2012 | 1998 Chevrolet Cavalier

1 Answer

I was driving my 94 toyota p/u & it just died like it stopped getting gas. i think something may have come loose.any idea on what to check?


Check your battery and alternator connections for tightness. Does it crank over, but won't start? If it won't even crank over, then likely some connection did come loose, like an alternator connection, possibly your fusible link (near the battery).
If it does crank, but won;t start: You'll just have to start from scratch to find the problem. Try to determine if it's fuel or ignition-related. Check for spark at a plug wire. If you have spark, then ignition is not the problem. Check if your fuel pump works. When you turn key on, you should hear the pump buzz on for a couple of seconds. It should also be on when cranking and running, but you can only hear it, or should, when you first turn key to on. If your toyota has a schrader valve on the fuel rail (a valve for checking pressure-it looks like a typical air valve, like on your tire, but is for attaching a fuel pressure gauge) if it has one punch the center with a little screwdriver-gas should shoot out if you have any fuel pressure, If not, have your fuel pressure checked.good luck.

Nov 01, 2011 | Cars & Trucks

2 Answers

My epc and engine light came on and won't star in a 2006 2.0t passat any ideas


First of all you need to access the Engine Control Module (ECM) using suitable diagnostic equipment connected to the data link connector of the car, in order to pull out all DTC's memored. DTC = Diagnostic Trouble Code. Then you will bu full informed about the root cause of the problem, and you will be able to repair & replace bad pieces and reset the ECM. Then the EPC (Electronic Pedal Control) yellow light will turn OFF.

The check engine light:
tdisline_743.jpg

The check engine light & EPC light:
tdisline_744.jpg

Oct 11, 2011 | 2001 Volkswagen Passat

2 Answers

Dear sirs, I have a 2000 Ford Explorer which won't start. All light in the dashboard turn on but the engine won't crank. We've tried to crank the engine direct from the battery and it cranked....


yea got get you more troubles
just check the alternator is charging well and no battery light on dashboard it indicate the bad alternator
monitor your battery if it got old and cannot hold the charge any more
you said when you used another one your car turned on

Jun 06, 2011 | 2000 Ford Explorer

Not finding what you are looking for?
2000 Chevrolet S-10 Logo

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...