Question about Cars & Trucks

1 Answer

Why no spark in a dodge 150? - Cars & Trucks

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 76,848 Answers

Have you checked for fault codes? If not do so by reading the instructions here.

Posted on Nov 07, 2012


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

I have a 1990 Dodge Ram 150 with the 318 engine that the coil isnt sending fire to the dist...But the coil is good. Could someone help?

Could be a bad coil, or a bad pickup coil inside the distributor, or worst case a bad pcm.

You said the coil is good, but didn't mention if you had tested the coil's primary and secondary circuits with an ohmmeter to see if they are within specs? And the pickup coil is like a crank position sensor: it tells the pcm crankshaft position and rpm so the computer can determine spark timing.

Dec 19, 2014 | Dodge Cars & Trucks

1 Answer

My 93 dodge Dakota. 3.9 cuts out. I replaced rotor and cap and spark plugs and wire. Not sure what's going on.

These trucks have corrosion issues in the wiring connections as they age. I would start at the left fenderwell and unplug the starter relay and check those plug contacts first. When my 1992 150 did this, I ended up unhooking and cleaning all the plug in connections on that side of the truck, including the computers. I added di-electric grease to the terminals as well. The problem has not come back. You did not say if the truck restarts hard or not. The ignition pick up inside the distributor may also be a problem, but those normally will just stop working all at once.

Dec 24, 2012 | 1993 Dodge Dakota

1 Answer

1987 dodge van 150 /302 cid./wont start

As with any no-start issue, you will need to figure out if it is a spark or fuel problem to proceed.
Could be the ASD relay, a faulty coil, or list of other components.

Aug 11, 2012 | Dodge Cars & Trucks

1 Answer

I have a dodge ram 1500 It cranks but wont start it does not have Spark from coil to distributor

Bad ignition module.
Go to, become member, will give you repair manual,location of parts,diagrams.

Jul 12, 2012 | 1991 Dodge Ram 150

1 Answer

I have no spark or injector pulse sometimes it

You got a crank sensor at back,on top of bellhousing.
Injector pulse, I believe is controlled by hall effect sensor in distributor, as well as spark

May 16, 2010 | 1991 Dodge Ram 150

2 Answers

Dodge 1991 d 150 moter will crank but not satart

I had the same problem with my 91 dodge truck. I checked everything and found the problem to be in the fuel pump relay, it was not making good conection, spayed some WD40 on the conecters and have not had any problems.

Mar 21, 2010 | 1991 Dodge D150

3 Answers

1992 dodge 318 engine turns over, but no start. No spark present. Replaced ignition coil and pickup coil, still no spark. 1992 dodge ram 150 full size truck 318 engine. starts sometimes then wont start...

if truck has a ceramic ballist resistor near and connected to coil this could be problem or the crk posistion sensor could be too, i would change ballast first if you have on your truck appx cost $10

May 09, 2009 | 1992 Dodge Ram 150 Club Cab

1 Answer

Need a distributor wiring diagram for a 1989 dodge 150 van 3.9L

The firing order is 1-6-5-4-3-2 in a clockwise direction. Number 1 should be marked on the cap. 1 3 5 are on the driver side, 2 4 6 on the passenger side. I hope this helps.

Apr 10, 2009 | 1989 Dodge D150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides