Question about 1992 Buick LeSabre

1 Answer

Runnin bad car again

I have aleady cheacked all my fuel lines and changed my ingectors also , still runs bad like what i meantioned earlyer. any other suggestions

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 409 Answers

Check your MAF or MAP sensor. The sensor is in your air intake and works off of a 5 volt reference signal from the ECU. Make sure your ref signal is thier and that the voltage increases and decreases with throttle opening and closing while the car is running.  I don't think I ever saw your first post so tell me what its doing if the checks on the sensor are good.

Posted on Jan 05, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1991 Chev Suburban 4x4 5.7L Injectors aren't firing. Fuel pump runs, gas line clear filter clear. When it died on street acted like out of gas. was able to feather the foot feed to get home, but now...

Check your fuses .also use a rubber hose to check each fuel ingector.also clean out your carburator also check your mass air flow sensor.clean it do not touch it.also use some fuel cleaner.

Jan 09, 2018 | 1991 Chevrolet Suburban

1 Answer

Missing, rough idle

check for vacuum leak or intake gasket spray starting fluid around vacuum line if it speeds up check that line also I believe that is carb. check base gasket

Oct 19, 2013 | Dodge Dakota Cars & Trucks

1 Answer

I have a 1990 jeep cherokee it will start and run for about 5 seconds and then cut off, I have replaced the fuel pump and still no luck, help please.

have you blead the fule systym easy open eny ingector and turn it over till you see fuil then close ingector should be good at that good luck

Jan 22, 2013 | Ford Festiva Cars & Trucks

1 Answer

My chevy have spark but no fuel come out from the ingectors

I would say you need a new fuel pump or relay but most likely pump.Turn your key to on position and see if you can hear the pump come on.You puzzle me when you say you have fuel on the lines but none at injectors.Can you explain that to me.

Nov 24, 2011 | Chevrolet 1500 Cars & Trucks

1 Answer

My 1989 crx si is not pushin fuel out the fuel ingectors what is my problem

The fuel injectors are leaking at the top where the injectors connect to the fuel rail,or the seals are bad where the injectors go in the engine.

Oct 28, 2009 | 1989 Honda CRX

1 Answer

1997 blazer fuel pump problem.....

ya the fuel pump wont pump with the lines off but the pump is going bad they will work and wont work

Mar 06, 2009 | 1997 Chevrolet Blazer

1 Answer

1990 camry will not start

this is just a shot in the dark, but wiggle the wires on the top of the air filter canister...i had this same problem (though i never got in to check if the engine plugs) after I changed the air filter.

I had started to take that sensor off bove the air filter because i thought i had to, turns out i didn't need to do that. I put the air filter in, and my car wouldn't start...I unscrewed and screwed back in the tiny screws that hold that plug into the top of the airbox sensor thing (no idea what it's called)...and wiggled it around and it started fine again.

I will not change my air filter again!!

Feb 02, 2009 | 1990 Toyota Camry

1 Answer

Ruough runnin jetta

Did you check the timing? Also make sure the injectors are putting out the correct amount of fuel. By oxygen sensor I'm assuming you replaced the MAF (mass air flow) sensor? Are all the vacuum lines in good shape and is the EGR vavlve actuating correctly (they can get gunked up)? Is air getting into the fuel lines somewhere? Is the engine not getting enough air when the turbo isn't on? Maybe your intake is clogged up but this isn't extremely likely since you'd notice power loss at higher speeds. What was done recently to the vehicle that might have caused this?

Aug 24, 2008 | 2001 Volkswagen Jetta TDI

Not finding what you are looking for?
1992 Buick LeSabre Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts


Level 3 Expert

78010 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides