Question about 1992 Honda Accord
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
4 or 6 cylinder engine.
It's the rear O2 sensor,the one behind the catalytic converter.
Clear the code with OBDII scanner or remove negative cable for 2 minutes.
Wait until the exhaust cool for 1 hours
Disconnect the connector and clean the contacts with CRC electrical contact cleaner the contacts.
reconnect negative battery cable
Start the car and let the motor warm up.
If the code keeps coming back then you will need to purchase a O2 sensor socket + O2 to change it out.
Please rate my answer if it's helpful to you.
Posted on Dec 12, 2009
the blower motor is located behind and under the glove box. its held to the blower housing by three screws. remove the three screws and the motor will slide down and towards you. to test the motor. apply power to the yelllow/black wire and ground to the blue/red wire. the motor should run. if not you prob have a faulty power resistor.
Posted on Mar 17, 2010
Yes, most likely the VSS (Vehicle Speed Sensor). Not too hard to do. It's on top of your transmission, kind of near the back of it.
Posted on Apr 29, 2010
Testimonial: "Yes; very much appreciate the quick response."
SOURCE: check engine light is on,
Could be as simple as a loose gas cap or cap seal or a bad o2 sensor. A falty cat. converter will also cause the check engine light to come on. Either way, you need to go either to a dealer or some auto parts stores will plug in the dioegnostic sensor and can tell what is wrong. your gas milage will suffer until you get this fixed. Your engine computer uses the inputs from your o2 sensers to adjust the fuel air mixture of the engine for optimum engine performance.
Posted on Sep 18, 2010
you will need fill up screw driver and a flat head remove the 2 screws that hole the BLK panel . then you use your flat head gently push up and out on the lower left and right coroners . be very carefull make sure you got time no rush. NOTE : make sure you go pick up the LIGHTS I USED sylvania lights part #74 LL YOU WILL NEED 14 OF THEM COST 4.99 FOR A SET OF 2 AND IF YOU HAVE AUTOMATIC CAR YOU WILL NEED CALL A HONDA DEALERSHIP AND FIND OUT IF THEY HAVE THE ONES THAT LIGHT UP WHEN YOU CHANGE GEARS.
Posted on Jan 06, 2011
Tips for a great answer:
Aug 24, 2013 | 2002 Honda Accord
Jun 02, 2012 | 1992 Honda Accord
Oct 07, 2009 | 2002 Honda Accord
Jun 18, 2009 | 2002 Honda Accord
Mar 30, 2009 | 2001 Honda Accord
136 people viewed this question
Usually answered in minutes!