Question about 2006 Chevrolet HHR

Open Question

2008 hhr remote wont work

I changed the battery now it wont work what am i doing wrong

Posted by Anonymous on

6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: rear defroster not working on 2008 hhr

found solution at

Posted on Dec 08, 2009

  • 1796 Answers

SOURCE: 2008 Chevy HHR headlight will

Try switching the headlights from Low Beam to High Beam when they cut off. This is to find out if the problem is on the Low or High Beam Circuits. They both have separate fuses and relays and are hot at all times, just controlled by the headlamp switch and the BCM. If both circuits cut off, check the Black Wire (Ground - ) on both head lights. 80% of the electrical problems on an automobile are due to a faulty Ground. Check for tight connections and broken wires.
Check the following Fuses/Relays on the engine compartment fuse box : # 63 - 10A, # 65 - 10A, # 66 - 10A, # 68 - 10A and # 31 - 10A. and Relays #71 Low Beam, #72 High Beam and #28 DRL. If all the above checks out OK, then your BCM could be defective. USE THIS HEADLIGHTS WIRING DIAGRAM TO TROUBLESHOOT THE CIRCUIT. 5983d19.gif
Keep me posted!

Posted on Oct 14, 2010

  • 1 Answer

SOURCE: just changed the battery in

blown power stering fuse, same thing happened to me.

Posted on Dec 22, 2010

  • 159 Answers

SOURCE: 2008 HHR LS can't get to drivers side headlight bu...

This video will show you how to replace the headlight and also the bulb in the headlight of your HHR">

Posted on Feb 03, 2011

  • 2 Answers

SOURCE: 2008 chevy hhr key and remote will not unlock car doors

get a new one

Posted on Aug 30, 2012

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to replace 2008 HHR lock switch

If it uses FOB that uses 1 switch for lock/unlock, check if the switch is not stuck at 'ON'. If you have a spare key, try using that one with the first key kept away from the car. Or you can remove the battery from the first FOB.

May 14, 2014 | 2008 Chevrolet Hhr

1 Answer

My 2008 chevy hhr only has one front wiper working. The arm is connected, and the driver's side works fine on all settings. The passenger side doesn't move. Whats wrong?

There is a link bar under the cowl (plastics under wipers) the bar has plastic sockets on each end that connects the left side(where the motor connects) to the right, so...when the left wiper moves it transfers the motion to the right

Oct 17, 2013 | 2008 Chevrolet HHR 2.4

1 Answer

Car battery went dead and now my keyless remote won't work

Try pressing and holding the lock and unlock buttons at the same time for 15 seconds and see if the remote will 'resynchronize' with the vehicle.

Feb 11, 2013 | 2008 Chevrolet Chevrolet HHR LT

1 Answer

My remote start do not work the fob only works the panic button but the door lock button dose not work nor the start button and i have installe new battery in remote any help would be wonderfull

I had the same problem only the panic button didn't work, I had to get the key FOB reprogrammed it took them 15 minutes and cost me $150.00.

Feb 06, 2013 | 2008 Chevrolet HHR 2.4

1 Answer

Where is coolant temperature sensor located on 2008 hhr 2.2l engine

This is confusing, My battery is located next to the spare tire in the rear of the car. I have a 2008 HHR. My AC also quit working at the same time the temp sensor did.

Dec 13, 2012 | 2008 Chevrolet HHR 2.2

1 Answer

How do I change the headlight bulb in a 2008 Chevrolet HHR?

Access to change the headlamp bulbs is through the wheel well. The recommended method is to remove the front tire and then the plastic inner fender liner. Once removed, you'll have easy (more or less) access to the rear of the headlamp housing.

Dec 19, 2009 | 2008 Chevrolet Hhr

1 Answer

Oil percentage reset

Remove battery heads and replace after 5 minutes.

rate this fixya

Apr 03, 2009 | 2008 Chevrolet Hhr

Not finding what you are looking for?
2006 Chevrolet HHR Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides