Question about Ford Cars & Trucks

Open Question

1995 ford ranger rough idle - Ford Cars & Trucks

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
michigan man
  • 3533 Answers

SOURCE: rough idle

when was the last time you had a good tuneup sparkplugs,wires if needed and fuel filter and replace the drive belt and also make sure all of the vaccum lines are on and the one behind the throttle body

Posted on Feb 13, 2009

Ad
  • 1 Answer

SOURCE: 1995 xlt ford ranger

In my 1996 ranger xl my high idle problem was due to a bad ect sensor. After I replaced that I have had no problems with high idle. Not sure if yours is idleing high all the time like mine was but that sensor fixed the problem for me. Hope this helps!

Posted on Dec 23, 2008

  • 3 Answers

SOURCE: FORD WINDSTAR 3.8 V6 ENGINE IDLE ROUGH UP AND DOWN WHEN STANDING

Usually the fuel pressure regulator vac. hose pops off? If not listen for a slight whistling noise (vac leak).

Posted on Apr 23, 2009

Louie_3006
  • 79 Answers

SOURCE: 04 Ranger rough idle

I would check your crankshaft positing sensor this may be bad. I would also change your spark plugs and wires becuase they may have got water in them causing a short between them and the head. I would very carefully use air to clean the dirt from your engine compartment first. Autozone runs a free code check for you and this will tell you your problem. To clear your codes and to make the check engine light go off take off your battery cables and wait 30 minutes. You may also have a bad coil which will cause a misfire as well and a 306 error means a misfire to your 6th cylinder so it's probaly this. I hope this information helps.

Posted on May 20, 2009

  • 30 Answers

SOURCE: 01 ford ranger 4x4 4.0V6-- rough idle like it

I agree. Try replacing the spark plugs, install new spark plug wires, change the air filter, change the fuel filter, and test the battery and alternator. Run a bottle of fuel system cleaner and water remover through it. To replace the spark plugs you'll most likely have to go through the wheel wells cause of their hard accessibility from the top. The fuel filter is located on the inside of the frame on the driver's side. Hope this helps. God bless

Posted on Oct 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1992 ford ranger 3.0 idle rough and the tail pipe is black and bad gas miles


check for clogged air filter and oxygen sensor if check eng light is on

Feb 28, 2015 | 1992 Ford Ranger

1 Answer

2.8 v6 ford ranger runs rough at a idle how do I fix this


Being an 85, I would start by replacing all the vacuum lines and fittings, along with the pcv valve. Next would be a tune up, clean the throttle/carb and a fuel and air filter.

Aug 31, 2014 | 1985 Ford Ranger

1 Answer

Engine rough idle check engine flashing


run fault codes and check for o2 sensor problems and misfiring.

Aug 01, 2014 | 1995 Ford Ranger Supercab

1 Answer

1998 ford ranger idles rough, high then low


does car have engine codes? sounds like your idle air controle valve is sticking. or possible egr problem

Feb 18, 2010 | 1998 Ford Ranger SuperCab

1 Answer

I have a 2001 ford ranger ext cab 4.0 v6 4x4. the truck at times jerks and at stop signs runs rough then the speedometer bounces while stopped


Have you tired the Idle Air Control Valve? When was the last time you did a tune-up with new Spark Plugs and spark plug wires? Make sure you use Motorcraft Platinum spark plugs if you want the best performance for your vehicle.

Jul 30, 2009 | 1995 Ford Ranger Supercab

3 Answers

95 FORD RANGER NO INST. PANEL LIGHTS AND PARKING LAMPS


you might have blowed blulbs check that also there might be what is called a fuse link in the wiring

Mar 15, 2009 | 1995 Ford Ranger Supercab

2 Answers

1995 xlt ford ranger


In my 1996 ranger xl my high idle problem was due to a bad ect sensor. After I replaced that I have had no problems with high idle. Not sure if yours is idleing high all the time like mine was but that sensor fixed the problem for me. Hope this helps!

Oct 16, 2008 | 1995 Ford Ranger Supercab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

140 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...