Question about 1998 Jeep Cherokee

2 Answers

Where do I find a diagram of where things are located on my Jeep? I'm looking for the alternator..wondering if its accessible to the layman(or woman in this case) or am I going to have to take it in to be replaced.

Posted by on

  • bbrennan_7 Jan 06, 2009

    Hey, thank you very much! Looks like I'm going to have to give it a go.



    Pray to the car Gods for me!!

  • Anonymous Feb 16, 2009

    have a 2000 spot rebuilt eng i need to find the route for the serpentine belt haynes has 2 diag. and both dont match my eng.

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 17,970 Answers

Check this info...
XJ-2000-08w-Wiring-Diagrams

Good luck!!!

Posted on Feb 16, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 51 Answers

The alternator kinda sucks to get to. its all the way to the bottom left when looking at the engine. you need to remove the battery and battery tray to get at some of the bolts and have to get under the vehicle to get the rest of them

Posted on Jan 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Alternator diagram


possible hose leak, after the car cools down take a look under the car to see if there is any antifreeze dropping down on the ground.

Sep 26, 2013 | 2002 Chevrolet Impala

1 Answer

My clutch "went" on my


all clutches require the removal of the gearbox ,sorry but i would not recomend this job to anyone unless a trained mechanic with a four poster ramp and proper support stands for the gearbox

Dec 07, 2010 | 2000 Jeep Wrangler

1 Answer

Removing alternator on a 2006 ford fusion v6


the alternator probably is accessable from the underside of the car without removing the compressor, which would require extensive knowledge and expensive equipment. the best thing to do is purchase a repair manual. this inexpensive investment has detailed procedure and pictures to help you tackle this repair.

May 25, 2010 | 2006 Ford Fusion

1 Answer

2001 jeep Tj pdc diagram trying to locate fuse for


sounds like it is either flasher or switch assembly.

Oct 08, 2009 | Jeep TJ Cars & Trucks

1 Answer

Replacing alternater. jeep


  1. Disconnect the negative battery cable.
  2. Remove the drive belt.
  3. If necessary, remove any splash shielding for easier access to the alternator
  4. Tag and disengage the alternator wiring. It may be necessary to remove the alternator and mounting bracket from the vehicle as an assembly.
  5. If equipped, remove the front alternator assembly mounting plate.
  6. Unfasten the alternator mounting and pivot bolts and remove the alternator.
  7. If installing the original alternator assembly, push out the pivot bushing as illustrated.
These are the removal instructions per Chilton's Auto repair guide. Here is a link to help replace the drive belt when you're done. Just insert the year,make,model and engine to get the belt part number and the "Routing diagram".
Best of luck on your repair.
Greg

May 29, 2009 | 1994 Jeep Grand Cherokee

2 Answers

I need to replace the map sensor in my 06 jeep liberty diesel...i was wondering if you know the location of the map sensor...i think it is location inside the airbox


The Manifold Absolute Pressure sensor is located on top of the cylinder head, right side, about 2/3 of the way back. there is one screw holding it in. You will need to take off the plastic engine cover off to access it. The sensor in the airbox is the MAF sensor.

Jan 24, 2009 | 2006 Jeep Liberty

1 Answer

Cant find a relay for indicators, is there one?


i take it they come on but wont flash. there should be a flasher located on or behind fuse panel(driver side kick panel)

Dec 06, 2008 | 1993 Jeep Grand Cherokee

1 Answer

I need a wiring diagram for the jeep cherokee's temperature sender unit for a an m Registration 1994 model have you got one?


The temperature sending unit is located on the right rear of the head. Next to the valve cover gasket. It is blocked from good access by the MAP sensor. If you remove the MAP sensor, the black flat thing mounted to the upper center of the firewall, you can access the temp sending unit with a deep well socket. Make sure the engine is cold, or the pressure of removing the TSU will send coolant everywhere.

Sep 09, 2008 | 1993 Jeep Cherokee Country

Not finding what you are looking for?
1998 Jeep Cherokee Logo

Related Topics:

272 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...