Question about 2007 Dodge Ram Truck

Open Question

Where is the low pressure switch on a 2006 dodge 2500

I need to jump the low pressure switch on my air condition on a 2006 dodgem2500 in order to service the system. clutch will not engage

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2006 dodge ram diesel a/c quit comprssor clutch

I have the same truck with the same exact problem. Mine also stopped blowing while pulling a camper and indeed it is the clutch on the A/C. I was told if you can find someone in your area that can actually rebuild the compressor and not put a new one in you can come out alot cheaper! Also if you crank your truck and turn the A/C on look under the truck on the passenger side at the compressor and take a tool of small hammer and tap the compressor in the middle and it should come on and run the a/c for a little while! I did this until it finally went out and it worked! Might buy you some time!

Posted on Jun 02, 2009

  • 1 Answer

SOURCE: air conditioning clutch

I have the same problem with my Durango AC. I called the dealer and they do have clutch for my compressor available. I wonder how big of a job it can be. I got my A/C Charged thinking I am low on compressor gas only to find out after 135 dollars that it is my clutch that is not engaging. Cost of new compressor and labor factor added to it get to be a scary sum of money for 1998 model. Any one knows how to replace this clutch? Is it the front bold that is holding the entire clutch? Help amin

Posted on Jun 16, 2009

  • 2 Answers

SOURCE: 2005 Dodge Durango Front AC won't blow cold, back air works great

Did anyone find the answer for this?

Posted on Aug 30, 2009

  • 83 Answers

SOURCE: 2006 Dodge Ram 2500 diesel truck----need inside fuse box diagram

If you are looking for the fuse box diagrams or any other diagrams for your Ram, check promanuals.net for a factory service manual for around 20 bucks or so. It's an invaluable tool for my Ram 2500.

Posted on Sep 26, 2009

01fordeb
  • 1033 Answers

SOURCE: What should the high and low side freon pressure

The re-fill kit for the r-134 will only fit on one of the sides. You want to fill the low pressure side, but be sure you have a gauge not to overfill. he high pressure will be the larger side. But the gauge will only fit on one of the inlets for safety precautions.

Posted on Jun 07, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the low pressure switch on my 2006 Dodge Ram Diesel


The low pressure switch would be around the air dyer system.

If line drier is cool on one side and warm on other you have a line restriction. Is compressor cycling on and off.?.. be careful jumping low pressure switch...The high pressure on low side is restriction going to evaporator coil in firewall... check for a filter in cab for evaporator coil it may be stopped up

May 16, 2014 | 2006 Dodge Ram 2500

2 Answers

I have a Dodge Ram 2500 Hemi and the Air Condition cools only when the truck is moving but does not cool when the truck is idling


could be low on freon, and it might just need to have the front of the truck cleaned with a hose (cleaning the condensor with a hose if it is blocked up with dirt and bugs/dust). Dirt greatly affects the efficency of the system, and also check on the radiator fan to see if it is running at idle with the air on.

Jun 10, 2011 | 2006 Dodge Ram 3500 Truck

5 Answers

My ac compressor on my dodge 2500 want engauge?


This could be a few things. The freon could be low, one of the switches (high or low pressure) could be bad, or you could have a bad compressor clutch. You can test the clutch by checking for battery voltage and ground at the two pin connector with the A/C on if you have both power and ground, then the clutch is bad. You really should start by hooking up pressure gauges to the A/C ports to check the pressures, and these vary depending on ambient temperature and whether the A/C compressor is engaged or not. I am willing to bet that the freon is low though and may be just as simple as recharging the system.
Hope this helps. Good luck!

Apr 09, 2011 | 2006 Dodge Ram 2500

2 Answers

2006 dodge 2500 code P0533 How do i fix


P0533 A/C Pressure Sensor High.

It could be low on refrigerant, or it could be a bad sensor. Back-probe the pressure sensor connector (on the discharge line, near the compressor - it's a 4-way connector) on the dark blue wire with the engine running and the A/C turned to max. If you get no volts, or 5 volts, the sensor is bad. 4.5 volts indicates a properly-operating system, while less than 4.5 indicates low pressure, and anything above indicates high pressure. If low or high pressure is suspected, verify with a set of refrigerant gauges.

If warranted, the sensor can just unscrew. You won't lose refrigerant - there's a valve built in to the line to prevent that. Make sure to use a new O-ring and lube it with the proper oil if you do change the sensor.

Sep 09, 2010 | 2006 Dodge Ram 2500

1 Answer

What causes P0533 & P0532 trouble codes on 2006 Dodge 2500 SLT air conditioner. The codes are for too high of voltage & too low of voltage for the A/C sending unit. So my compressor pump clutch...


P0533 A/C Pressure Sensor High.

It could be low on refrigerant, or it could be a bad sensor. Back-probe the pressure sensor connector (on the discharge line, near the compressor - it's a 4-way connector) on the dark blue wire with the engine running and the A/C turned to max. If you get no volts, or 5 volts, the sensor is bad. 4.5 volts indicates a properly-operating system, while less than 4.5 indicates low pressure, and anything above indicates high pressure. If low or high pressure is suspected, verify with a set of refrigerant gauges.

If warranted, the sensor can just unscrew. You won't lose refrigerant - there's a valve built in to the line to prevent that. Make sure to use a new O-ring and lube it with the proper oil if you do change the sensor.
Add a comment

Jul 08, 2010 | 2006 Dodge Ram 2500

1 Answer

2007 dodge 5.9 l diesel AC blow hot air we have recharged the system but still no cold air any ideas


does the compressor clutch energize? this can be determined by listening in the engine compartment for the clutch to engage. there will be a clicking sound along with the engine adjusting rpm's for the added load of the compressor. check fuses and relays. if it is not engaging. the low pressure switch also may be faulty. it tells the compressor to turn on when pressure drops. which is normal. you can test it by using a paper clip to jumper the two terminals in the connector. it is located on the same a/c line as the low pressure fill port, between the evaporator, which is in the passenger compartment, and the compressor. if the fuses and relays are good, and the compressor doesn't cycle when the switch is jumped, change the low pressure switch. fuses and relays can be found in the owners manual. if you haven't got one, download one at dodge.com.

here's more info:

http://www.aa1car.com/air_conditioning.htm

Jun 09, 2010 | 2007 Dodge Ram 2500 Mega Cab Laramie

1 Answer

What should the high and low side freon pressure be on a 2006 dodge ram 2500 diesel?


The re-fill kit for the r-134 will only fit on one of the sides. You want to fill the low pressure side, but be sure you have a gauge not to overfill. he high pressure will be the larger side. But the gauge will only fit on one of the inlets for safety precautions.

Jun 07, 2010 | 2006 Dodge Ram 2500

3 Answers

I have a 2006 dodge pick-up with a 5.9 deisel . My


Compressors do go bad, and if the clutch goes out, you are better off getting the whole thing replaced. Make sure to check for leaks. They are bad about the evaporator core leaking.

Jun 04, 2009 | 2006 Dodge Ram 2500

1 Answer

Looking for a wiring diagram / pin out on the air conditioning electrical connections for the pressure transducer on a 2006 dodge diesel


your local public library should have great resources online for free you can access with your library card just a suggesrion because online i find wiring diagrams to be expensive.
0423b4e.jpgdoes this diadram help? ihad to reduce the size for the forum hope it is readable

Apr 24, 2009 | 2006 Dodge Ram 2500

Not finding what you are looking for?
2007 Dodge Ram Truck Logo

Related Topics:

101 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...