Question about Cars & Trucks

Open Question

2000 f250 fuse #28 keeps blowing

The fuse that runs the back up lights and the heater control keeps blowing. I can replace the fuse and it runs fine for a couple hours then blows again.

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 840 Answers

SOURCE: No parking lights, fuse keeps blowing.

There is a ground not connected or a wire open that is causing it to blow

Posted on Mar 08, 2009

  • 158 Answers

SOURCE: the engin control fuse keeps blowing on my 2005

your fuelpump could be causing the fuse to blow as it may be seizing up

Posted on Apr 19, 2009

  • 97 Answers

SOURCE: Blows fuses when parking lights are turned on. Headlights work fine even running lights.

If it only happens when you turn the switchto the parking lights then it is most likely the swich that is the problem. Light swich failure appears to be a common fault with fords

Posted on Apr 23, 2009

  • 538 Answers

SOURCE: 2000 Ford Excursion brake and tail light fuses keep blowing out.

If you have a trailer light hook-up where take the harness apart and put in an after market trailer light harness by the rear bumper. Those connectors get corroded and can cause a short especially if you are in an area where road salt is used to melt ice. Take it apart, if it's all crusty in there you might be able to clean it with WD-40 or electric contact cleaner. When you put it back together put some electrical grease in the prevent moisture from getting at the contacts.

Posted on Dec 05, 2009

  • 524 Answers

SOURCE: Fuse#28 (5A, air-conditioner, blower, heater)

maybe you have caused a short somewhere when replacing the overflow bottle... what i would do is run a 5 amp higher fuse NO MORE THEN 5 and if this blows then you have a bigger problem

Posted on Mar 19, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2000 f250 powerstroke..... Truck blew the 30 amp fuse that controls PCM coil relay,Fuel Heater,Waste gate Solenoid,Injector Driver Module,Relay Coil,after driving 20 mins.

Did you replace the fuse ? If yes, does it blow after driving ? Sounds like you may have a main power wiring problem, could be shorting to ground. Do you have any codes or an engine light on ?

Nov 25, 2016 | Ford F-250 Cars & Trucks

1 Answer

I got 2000 f250 that has started blowing fuse 1

I have run into the trailer plug harness and the plugs themselves getting severely corroded cause a back feed issue which will blow fuses as the system is directly tied into the truck lighting system. Check the trailer plugs both the four wire and the seven and see if they are all green. The four wire is usually the the bad one.

Sep 29, 2014 | 2000 Ford F250 Super Duty Crew Cabs

1 Answer


You need to check each component that is on that fuse for a short. You can disconnect them all and put a fresh fuse in. If it doesn't blow immediately, plug the components back in one at a time (with the key on) and check the fuse each time. When it blows, you will know which component is faulty.

Jun 15, 2017 | 2000 Ford Taurus

1 Answer

Can you tell me why the # 28 fuse under the hood keeps blowing when starting vehicle?

Your owners manual should have the info in the back of the book.
If fuse number 28 is a 15 amp fuse, it could be the cruise control and brake lights.

Jan 04, 2013 | 2001 Ford Taurus

1 Answer

Radio, ignition coil, antitheft and climate control fuses keep blowing

try looking for a short in the wiring harness and do they run to the same fuse

Feb 16, 2012 | 2000 Ford Expedition

1 Answer

Fuse#28 (5A, air-conditioner, blower, heater) keeps blowing on my 2001 BMW 325i. It kills the whole A/C, heater, blower console. I replaced my fuse twice but it's blown again after a few days. These...

maybe you have caused a short somewhere when replacing the overflow bottle... what i would do is run a 5 amp higher fuse NO MORE THEN 5 and if this blows then you have a bigger problem

Mar 19, 2010 | 2001 BMW 325

2 Answers

I have a 2000 F250 7.3 diesel, I keep blowing the #30,30 amp fuse, fuel heater fuse. Why?

most likley the fuel heater is bad and shorting out happend to me replace the heater

Jan 07, 2010 | 2000 Ford F250 Super Duty Crew Cabs

2 Answers

I have f-250 diesel. keeps blowing fuse #22,glow plug controller. what might be the problem

You should start with the glow plug relay/timer.Check it to see if may be shorted.Remove the smaller wires going to it and turn the key back on,if the fuse does'nt blow then replace it,if it does then you need to unplug the fuel preheater in the filter housing and try the key on thing again,pretty sure it's one or the other.

Dec 08, 2009 | 1995 Ford F250

1 Answer

Fuel pump fuse blowing

fuel heater in the fuel / water bowl was bad so it kept blowing fuse #30

Nov 20, 2009 | 2000 Ford F250 Super Duty Crew Cabs

1 Answer

95 f250 #7 fuse keeps blowing under hood what does this controll

you have a short its almost impossible to find..i would take it to a dealer

Dec 11, 2008 | 1995 Ford F250

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

78289 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14405 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides