Question about 1992 Buick Park Avenue

1 Answer

Broken tail light 92 park ave

How do iget to all the screws and how do u change the gasket

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 404 Answers

Places to look, in the trunk, behind the bumper or up behind the back wheel

Posted on Jan 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Buick Park Ave Lighting/Electrical Problem


the common system problem look like the headlights switch
and cluster back bulbs .... remove front panel cluster and remove headlight switch look for burn wire or connector terminal. test light
fuses all
hope it helps

Mar 22, 2014 | 2001 Buick Park Avenue

1 Answer

92 Buick Park Ave with blower control module problems where is it located?


1993 Blower Resistor Module

Print


0900c1528004a95a.jpg enlarge_icon.gifenlarge_tooltip.gif

Fig. Fig. 1 Blower resistor assembly is underneath the fuse block


REMOVAL & INSTALLATION

  1. Disconnect the negative battery cable.
  2. Remove the rear sight shield.
  3. Remove the fuse/relay block assembly and bracket.
  4. Disconnect the resistor module connector.
  5. Remove the retaining screws and remove the resistor module.

To install:
  1. Inspect the gasket and replace or repair as required.
  2. Install the resistor module and secure with screws.
  3. Connect the resistor module connector.
  4. Install the bracket and fuse/relay block assembly. Install the sight shield.
  5. Connect the negative battery cable, and check the climate control system for proper operation

Aug 14, 2012 | 1992 Buick Park Avenue

1 Answer

Replacing tail light lens on 2003 camry after a parking lot incident.


if you remove the rear carpet in the trunk area that the broken tail light is you should see 4 or 5 10mm screws attaching the tail light assembly unplug the bulbs it should take only about 20 minutes

Mar 16, 2010 | 2003 Toyota Camry

1 Answer

'92 Suzuki Sidekick. No tail or dash lights.


it could problem with main connector of headlight or combi switch, pls clean it and re fix it.

Jan 29, 2010 | 1992 Suzuki Sidekick

1 Answer

2006 Toyota Sienna Taillight will not work I had remote start installed and when you remote start the tail light and parking light will flash indicating car is remote started. Problem: When I put the key...


Bypass the fuse? Bypassing a fuse is a fire hazard in the first place. When they worked on that everything should work normally plus the added feature. Not compromising anything. Take it back there and have it done properly or put it back the way it was, and have it done somewhere else. You work hard for your money so you deserve a good job on your car.

Nov 14, 2009 | 2008 Toyota Sienna

1 Answer

92 buick park ave security light on car wont start


Someone put the wrong key (resistor value) in the ignition lock, you will have to disconect the battery for 3 min. Make sure you have the right key. Very important! Make sure the climate control is off before disconecting/conecting the battery.

Apr 18, 2009 | 1992 Buick Park Avenue

1 Answer

Lic.Plate Bulb Change


look in your trunk there should be a cover on the back of your tail lights in the trunk. Look under it

Nov 24, 2008 | 1999 Buick Park Avenue

Not finding what you are looking for?
1992 Buick Park Avenue Logo

Related Topics:

96 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...