Question about Cars & Trucks

1 Answer

How do I remove dome light

Dome light is blown ,need to replace

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 17 Answers

Not sure what type car you have but most dome light covers will just pop off with a small flat head screw Driver. Then take the bulb to your local auto pats store . They will help you with the right type bulb

Posted on Nov 07, 2012

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 Jeep Laredo continuous clicking sound passenger side under dash it runs battery down ignition is off continuous clicking please help thank you


A number of people in the link report the same problem on the Jeep Forum and there are a number of fixes.

I also found this for you.

The problem seems to be a short in one of the rear dome lights, which seems to be affecting two fuse circuits. The temporary solution was to remove one fuse and replace another (blown), and remove the bulb from the bad dome light. I had to remove "fuze#5-15 amps-Interior Lighting", this stopped the clicking noise, I replaced blown fuze#8-15 amp-Overhead Console, keyless Entry ..." This fuse also seems to effect the alarm system (contrary to the documentation), and I think that was what was killing the engine. The problem existed before fuse#8 blew. Removing fuse#5 may have solved the problem, but the other fuse blew while I was testing the dome lights, and the jeep will not start without it.

Found lots of wires bare or broken in all the door wiring harnesses ( in rubber boot that goes to the door)I first checked both fuse 5 and 8 but both o.k. After fixing the broken wires found fuse 8 had blown. Replaced that and all is well again. Thanks for the advise got me looking in the right direction.

. Fuse box located in passenger side door jam...check #8 fuse if its not blown check others...if it is blown, check your radio, and interior lights for good ground
Clicking noise under passenger dash Jeep just shuts down

Jan 10, 2016 | Jeep Cars & Trucks

1 Answer

What will cause the dome light not to come on


Probably a blown bulb or popped fuse. Sometimes the back of the dome light can ground against the underside of the roof, popping the fuse. Start by replacing the bulb.

Nov 02, 2015 | 1982 Ford F 150

1 Answer

Power windows dome light trunk light


Check owners manual for your fuse box location. Remove and replace blown fuse. Normally located under driver side dash, passanger side dash or under your hood

Mar 11, 2015 | 2005 Ford Taurus

2 Answers

How to remove the dome light assembly from a 2008 accent


It literally just pulls out, it's only held in via clips. I had to replace mine as well

Mar 06, 2015 | 2008 Hyundai Accent

1 Answer

Dome lights wont work on a 1999 dodge ram 1500 van


check in the fuse panel for a blown fuse or a time delay relay to be blown out. if this checks out to be good, then you have a short in the wiring to dome light. also you may look inside the dome light socket for a blown light bulb or a short in the socket.

May 02, 2010 | 1999 Dodge Ram

1 Answer

Dome lights wont turn on


A blown fuse is most likely the culprit. so all you need to do is find and replace that fuse. but if that isn't the case then the dome control switch may have gone bad. then you would have to replace it.

Nov 29, 2009 | 2001 Hyundai XG300

1 Answer

My dome light doesn't work


You probably have one of two problems...
1. The Bulb is blown and needs replacement... you can usually use a key to remove the light cover to expose the bulb. 2. You have a blown fuse locate your fusebox and locate dead fuse.

Nov 09, 2009 | 2000 Acura TL

1 Answer

I just bought a 1997 Pathfinder and the interior light doesn't come on when the door is open. All other interior lights seem to work. Would it just be a bulb that needs replacing. I'm assuming the switch...


yes it could be the bulb is just blown remove it and check that the filaments are still 2gether if they are fine it will be the fuse its usually in the group of fuses under your hood the fuse will be labeled dome or dome light this is the interior light it has its own separate fuse replace the fuse there are usually spares on the inside of the fuse box cover but make sure it is the same as the one that is blown

Oct 16, 2009 | 1997 Nissan Pathfinder

1 Answer

Just recently my 98 Toyota Corrolla has started blowing a fuse.


I would remove the dome light, and disconnect the wiring connector, and then put in another fuse. If it does not blow, I would think that the dome light switch is shorted to ground.

Jan 10, 2009 | 1998 Toyota Corolla

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

96 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...