Question about Subaru Cars & Trucks
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Hello, whenever the check engine light comes on the cruse light will flash as well, that is normal. The check engine light will not come on if fluid levels are low or if the temp is getting to high, I am pleased to know that you checked all of the fluids, most wouldn't have even the slightest thought to even try checking them. The On Board Diagnostics or OBD-2 for short only sets a check engine light when the ECM or Electronic Control Module reads a sensor value either too high or too low, but it has to read that same fault 3 consecutive times in a row to turn on the check engine light (w/ flashing cruise). Otherwise your check engine light would be going on and off all the time. I would go to your local parts store and have them check the codes for free because a dealer will have to charge you labor for them to check due to the knowledge needed to use the highly sophisticated scan tool they use. That way you can go either to an independent shop or a dealer with what the other scanner says is wrong which cuts down on the cost of repairs. They will probably ask you if you fueled up just before the engine light came on, in which that would be code P0440:EVAP leak(very small leak), that means the fuel tank sensor doesn't like how you put the fuel cap on. Subaru recommends AT LEAST 3 clicks when tightening your fuel cap. But until that code is checked you won't know whats wrong, if nothing went boom or bang you'll probably be ok. If it does end up being a fuel cap leak, then just loosen the cap put it back on and just make 1 full revolution, and just keep driving it. The light will go off within 3 full warm up cool down cycles or (drive cycles). I hope this info helps...(subyguru)...
Posted on Apr 04, 2010
one of your abs sensor is bad or the abs motor,go to local shop to diagnose which sensor,shop usually charge $ 60 to diagnose abs system,good luck, let me know ..
Posted on Jun 04, 2009
I had this occur on my 2007 Subaru Tribeca. ABS, Traction Control, Check Engine lights were solid, Cruise Control light was blinking and "Er SS" (commonly misread as Er 55) displayed on Trip Odometer. All lights were cleared after 10 or so miles. It appears this is a Speed Sensor (SS) reading error whereby the computer notices an irregularity with the readings taken from the four wheels. Most often it is a temporary and harmless glitch and sometimes a result of debris that is impeding the sensor's reading at one of the wheels.
Posted on Nov 03, 2009
Tips for a great answer:
Apr 21, 2015 | 2007 Subaru Outback
Jan 30, 2015 | 2005 Subaru Outback
Jul 11, 2014 | 2011 Subaru Outback
Jul 05, 2014 | 2006 Subaru Outback
Jan 09, 2014 | 2004 Subaru Outback
Oct 25, 2011 | 2008 Subaru Outback
Aug 01, 2011 | Subaru Outback Cars & Trucks
Dec 08, 2010 | 2008 Subaru Outback
Jan 01, 2009 | 2002 Subaru Outback
Dec 22, 2008 | 2006 Subaru Outback
215 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: