- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Pump the tank dry of the fuel using the electric fuel pump, just jump the fuel pump relay to get the pump to run and remove the supply line to the injectors and attach a hose. Use extreme caution around gasoline, no sparks, ground the container to the truck.
Had a problem like this before and it was the computer..But you could faintly smell something like burnt wires..The computer should be down by the kick panel on the driverside..See if you smell anything on that side
Turn the key to the ON position without starting the engine. You should hear the fuel pump running for 5 seconds if working. This primes the gas to the injectors when doing this. If not heard running check the oil pressure switch for the 12 volts needed to run the fuel pump starts there on that harness. When the engine starts and the oil pressure reaches the normal pressure the computer shuts off that circuit and turns on the fuel pump relay to run the pump. The relay stays on till you shut the engine off
you may need a new fuel injector. or a intake gasket. here is a tip ;with the engine running spray starting fluid or a carb cleaner around the intake at the #5 cylinder if there is any change in idle you need to replace the intake gasket if no change replace the fuel injector
Have you checked the 'inertia switch' which in the event of an accident shuts off the fuel supply to prevent a fire . It's usually located in the cab on pass. side. Some models have one reset button, some 2 which have to be pressed at the same time. If that's not it, here's how the power to the pump SHOULD work, you will have to follow the path to see where it stops. When you turn the key on it turns on the EEC power relay on, this relay then provides power to the PCM (power control module) and the control side of the fuel pump relay. Power for the fuel pump is supplied through a fuse link or high current fuse attached to the starter solenoid (battery side). From the fuse link or high current fuse current flows thru the fuel pump relay and inertia switch to the fuel pump. The fuel pump relay is controlled by the PCM. When the ignition switch is turned on the fuel pump will operate, if the switch is NOT turned to start position, the PCM will shut off the fuel pump off after 1 second. This is to avoid flooding the engine when it is not running, just key on. So check out to see if you have a fuse link or a high current fuse and if they are blown.