Cars & Trucks Logo

Related Topics:

Sandra Mitchell Posted on Nov 07, 2012

I have a 2000 Ford Windstar, how would I disconnect the bell that dings when I put my key in the ignition?

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that hasĀ over 10 points.

  • Contributor 1 Answer
  • Posted on Nov 07, 2012
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that hasĀ over 10 points.

Joined: Nov 07, 2012
Answers
1
Questions
1
Helped
14
Points
13

Find fuse box, look at cover pull that fuse out

5 Related Answers

Anonymous

  • 116 Answers
  • Posted on Apr 11, 2009

SOURCE: 1998 Ford Windstar Transmission to 2000 Ford Windstar

while it is possible to perform that swap, the newer 2000+ transmissions will have updated internals and such.

so will it work............. yes.

is it optimal.................no.

Ad
jbass706

Jon Adamson

  • 167 Answers
  • Posted on Oct 24, 2009

SOURCE: 2000 ford windstar transmission jumps when i put

If the mounts are okay and you are getting a hard slam it could be the TFT (Transmission Fluid Temp sensor in the trans pan) or the Pressure control solenoid in the valve/control body.

Anonymous

  • 246 Answers
  • Posted on Feb 20, 2010

SOURCE: transmission slipping ford 2000 windstar any kind of lube you use

Tru Lucas Oil transmission lube.

Anonymous

  • 2 Answers
  • Posted on Feb 20, 2010

SOURCE: 1998 Ford Windstar GL minivan

Hi, My 1998 ford wind-star van 3.8 lit. started smoking under the steering column. Just a small amount. I turned the van off and now it won't start. I took the panels off but didn't locate any bad wiring. The battery was low so I charged it up but it wasn't the battery. I turned the key several more times and it finally started. When I got home and turned it off it wouldn't start back up again. Please HELP!!! Greg

Anonymous

  • 41 Answers
  • Posted on Aug 02, 2010

SOURCE: 2000 Ford Windstar LX. Won't

you need a new computer


Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Dinging bell on dodge caravan wont turn off even if key is removed lights out and door closed.

Check for play in ignition switch.If too much weight on keyring ignition switch may become damaged allowing key to be removed when switch is not actually fully in "off" position.
0helpful
1answer

How to turn off door ajar chime on a 1998 Ford Windstar

your door switches are probably dirty spray them with wd40 then scrub them with a tooth brush
0helpful
1answer

My 95 Ford Windstar has just developed a rather distressing problem. In the morning, I get in my van and everything is fine. A few hours later, when I get in my van and start it, there is a warning bell...

one of the door ajar switches are sticking. needs to be put on the computer to find out which one. only other way is to go around and unplug the switches until your light shuts off.
0helpful
1answer

When I open the drivers side door without a key in the ignition the bell dings. I have a 2000 ford excursion limited.

try wiggling the ignition switch and see if it stops if it does it is the key in the ignition warning switch persoally i wouldn't worry about it if it is if it does you will have to replace it and ign tumble most likley
2helpful
1answer

Seriously annoying and hazardous malfunctions from out of the blu

You need a door pin switch in the drivers door. It must have gone bad, and this is very common. Usually it is hard to find out what door it is that is causing it, but in your case with the dinging bell- it thinks the drivers door is open- thast why the dome light stays on. The door pin switch is a little sensor that is installed on the latch assembly with a wire going to it and it is supposed to sence if the door is open or closed and turn the dome light on/off. you have to remove the door pannel and reach back to the latch. They are VERY tricky to get out without taking the whole latch assembly out. The part shouldnt be that expensive though.
0helpful
1answer

Doors locking and dinging sound while driving

One of your door sensors in the door jam is loose or worn out, or a door is out of adjustment, and not closing all the way.
0helpful
1answer

1998 Saab Bell will not stop dinging, even when key is removed.

the lights are most likely the third brake light on the decklid... small line of led brake lights small unit.. i would clean the ignition switch with some quick start and cycle the key in and out to clean up the contact on the bottom some times soda or coffe gets in there and makes the car think that the cars key is in the ignition
6helpful
4answers

1998 Ford Windstar GL minivan

the key buzzer switch in the ignition is bad .It is part of the ignition switch.
Not finding what you are looking for?

24 views

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29492 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...