Question about 1999 Chevrolet Lumina

1 Answer

Were is the theft deterrent module on 1998 chevy lumina

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 2,101 Answers

Take off the glove box and reach in the dash just in front of the passenage air bag will be a green or black. it is about 3 inches by 3 inches

Posted on Nov 07, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 113 Answers

SOURCE: My 1997 Chevy lumina won't start (anti theft)

use the valet switch that most systems have and that will over ride it

Posted on Jul 21, 2009

MNfisherman
  • 11896 Answers

SOURCE: 1998 chevy lumina, shifter on steering column,won't shift

Either the pin that connects rod to tranny is broken off, or there is internal transmission problems.

Posted on Aug 12, 2009

canbruce75
  • 1776 Answers

SOURCE: replace front disc pads on 1998 lumina

Visit the autozone.com website and register the car information. It's free and will give you access to an online repair manual for the car. The steps for replacing the brake pads should be available there. It's a handy resource. Hope this helped and best wishes.

Posted on Sep 11, 2009

  • 1 Answer

SOURCE: my 01 chevy malibu theft deterrent light is on and

turn the key to the "acc" position. you will notice the theft light flashing. leave the key in this position for exactly 10 minutes. the light should stop flashing. turn the key back to the off position and then start the car as you normally would. Works every time!

Posted on Jan 19, 2010

  • 5 Answers

SOURCE: How do I reset the anti theft module in my 99 silverado 1500

leave the key in the on position for 10 minutes, then take it out and do it again for a total of 3 times..... occasionally it only takes once for 10 minutes but it shouldnt take any more than 3 times.

Posted on May 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the starter relay on a 1998 Monte Carlo located


It's not called a starter relay , it's theft deterrent relay and it's controlled by the theft deterrent module.
When the ignition switch is moved to the START position (and the theft deterrent module recognizes the key code), battery voltage is applied to starter solenoid (through the theft deterrent relay). Both solenoid windings are energized. The circuit through the pull-in winding is completed to ground through the starter motor. The windings work together magnetically to pull in and hold the plunger, which moves the shift lever. This action causes the starter drive assembly to rotate as it engages with the flywheel ring gear on the engine. At the same time, the plunger closes the solenoid switch contacts in the starter solenoid. Full battery voltage is applied directly to the starter motor, which cranks the engine.
Theft Deterrent Relay
Behind RH side of I/P, above I/P compartment

Jan 08, 2017 | 1998 Chevrolet Monte Carlo

1 Answer

98 chevy lumina wont start replaced starter and VATS relay only get click no crank what next?


Hey Todd how's it going ? How's the battery ? battery connections ? Are there any lights lit on the dash , security , check engine ? Because your getting a clicking there is nothing wrong with the theft deterrent relay ! Take a volt meter on the 20 volt scale an put negative lead at the negative battery post , then take your positive lead an put it on s terminal small wire on the starter solenoid an have someone turn the key to start position , you should see battery voltage . If you see battery voltage there is nothing wrong with the theft deterrent relay ! or the crank circuit. You need to do a voltage drop test on the starting system ! I'm thinking possible battery cable ! Starter Voltage Drop . you do know that you replaced a starter for no good reason !

Mar 21, 2015 | 1998 Chevrolet Lumina

1 Answer

2003 chevy s10 code p1626 no start


that is a theft deterrent code, loss of communication with the vehicle theft deterrent module (BCM), try cleaing the code if it comes back on the next key cycle you are probably going to have to replace the BCM, (bod control module)

Jan 17, 2013 | 2003 Chevrolet S-10

1 Answer

Can not get car to start cause of the security light


The security light is a visual indication that something in the car's antitheft system is failing. In most
GM cars and trucks there is a hidden system that most people are unaware even exists. From the moment you
put your key in the ignition, there begins a constant line of communication between your key's security
chip or transponder, to the ignition's lock cylinder, and then to the car's TDM (Theft Deterrent Module).
These 3 parts are in CONSTANT communication. If the key is in the ignition, then these parts are sending
signals to each other. The security light illuminates when that signal gets broken, even just for a second.
When the signal breaks, the car misinterperates this as an attempt at theft and goes into antitheft mode.
The car thinks its being stolen or hotwired because it is not getting that signal from YOUR specific key.
This is why the security light turns on and shuts down your vehicle. This link explains it pretty well.
http://vatspasslockpasskeysecurityhelp.yolasite.com/

Sep 04, 2012 | 1998 Chevrolet Lumina

2 Answers

Anti thief device


Check the help links mentioned below :---Relearn Theft deterrent module? http://technoanswers.blogspot.com/2012/01/relearn-theft-deterrent-module.html
---------theft deterrent module Relearning? http://howtobyme.blogspot.com/2012/01/buick-theft-deterrent-module-relearning.html
--------Engine will not crank after relearning Theft deterrent module? http://howtobyme.blogspot.com/2012/01/engine-will-not-crank-after-relearning.html
--------Can car radio code block Passkey anti theft system ?

http://schematicsdiagram.blogspot.com/2011/12/can-car-radio-code-block-passkey-anti.html
Car Factory Alarm will go off? http://repairhelpcenter.blogspot.com/2012/01/toyota-avalon-factory-alarm-will-go-off.html
---------Car will not start security lock out? http://technoanswers.blogspot.com/2011/12/car-will-not-start-security-lock-out.html
---------Alarm will not disengage? http://technoanswers.blogspot.com/2012/01/ford-pickup-alarm-will-not-disengage.html
--------This will help.For more info keep updated.Thanks.

Feb 09, 2012 | 1998 Plymouth Voyager

1 Answer

What is a TDM on a 2001 lumina


TDM IS (Theft Deterrant Module) VATS system

Dec 07, 2011 | 2001 Chevrolet Lumina

1 Answer

Security button to resetm pass key is located where?


your vehicle is equipped with Personal Automotive Security System (PASS-Key II(R)).
This security system is designed to prevent vehicle theft by disabling fuel system and starter unless an ignition key with a specific electrical resistance is used in the ignition key lock cylinder. PASS-Key II(R) system operates using sensing contacts, which are located in the ignition key lock cylinder. These contact a resistor pellet located in the ignition key. When lock is rotated, battery voltage is applied through appropriate fuse and resistor pellet to theft deterrent module (except Century), or body control module (Century). Pellet resistance is then compared with programmed value in the theft deterrent module or Body Control Module (BCM).
System components include ignition key, ignition key lock cylinder, theft deterrent module (except Century) or BCM (Century), theft deterrent relay and Powertrain Control Module (PCM). The PASS-Key II(R) system can also be supplied as a special equipment option on some vehicles

It will reset itself after about 10 minutes. You just have to wait until you hear a click and the pass key light goes off.
Be sure to clean the little metal strip on your key while you're waiting...


Dec 05, 2010 | 1999 Chevrolet Lumina

1 Answer

My dad owns a 2003 CTS. While driving the car he gets the displayed message "starting disabled remove key" and the car shuts off. He puts the car in NEUTRAL and WITHOUT removing the key, starts the car...


STARTING DISABLED REMOVE KEY
Refer to Theft Systems Description and Operation in Theft Deterrent

STARTING DISABLED REMOVE KEY
The radio illuminates the STARTING DISABLED REMOVE KEY message when the VTD system has disabled the starting system. The radio receives a message from the theft deterrent control module via the serial data circuit requesting illumination.

Your best bet ,take it to Cadillac dealer and have it checked . Could have DTC'S - diagnostic trouble codes
DTC B1015
DTC B1016
DTC B3031
DTC B3055
DTC B3060
DTC B3090
DTC B3935
DTC B3976
DTC P1629
DTC P1630
DTC P1631

The theft deterrent module or the insturment cluster or the ECM is not seeing correct info.
The vehicle theft deterrent (VTD) system functions are provided by the theft deterrent control module. When an ignition key is inserted into the ignition lock cylinder and the ignition is switched ON, the transponder embedded in the head of the key is energized by the exciter coils surrounding the ignition lock cylinder. The energized transponder transmits a signal that contains its unique value, which is received by the theft deterrent control module. The theft deterrent control module then compares this value to a value stored in memory, learned key code. If the value is correct the theft deterrent control module sends a random generated number to the transponder, this is called a challenge. Both the transponder and the theft deterrent control module perform a calculation on the challenge, if the calculations match the theft deterrent control module sends the fuel continue password via the serial data circuit to the Engine control module (ECM). If either the transponders unique value or the calculation to the challenge is incorrect the theft deterrent control module will send the fuel disable password to the ECM via the serial data circuit. The components of the VTD system are as follows:
• Theft deterrent control module
• Engine control module (ECM)
• Ignition key (Transponder)
• Ignition lock cylinder
• Security indicator

Aug 08, 2017 | 2004 Cadillac CTS

1 Answer

Chevy lumina, lost keys, broke ignition, need to fix the wires


Solder and shrink tubing work fine for that. That is for the pk2 theft module that tells the car that you are using the correct key with the chip in it.

Apr 26, 2009 | 1995 Chevrolet Lumina

Not finding what you are looking for?
1999 Chevrolet Lumina Logo

186 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...