Question about 2007 Toyota Highlander

1 Answer

Clunking into gear - 2007 Toyota Highlander

Posted by on

  • Michael Patton Nov 07, 2012

    standard or automatic trans.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 645 Answers

The clunking noises in a car could be caused by problems with the transmission. A mechanic can help you to diagnose your problem.

if you need an Car Key Programmer, click here: Car Key Programmer

Posted on Nov 07, 2012

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why my Volvo s70 clunks out from neutral into gear, runs fine above 1000 rpm


Putting in gear and clunks is usually a bad engine or transmission mount. If it goes in gear right away. If the engine has higher RPM's then hits gear. look to the transmission.

Jan 08, 2017 | Volvo S70 Cars & Trucks

1 Answer

I have a 2004 silverado 1500 and have clunking in rear end and was told I have excessive back lash in ring and pinion gears how do I fix that and how much would it cost?


suggest that you talk with a diff reconditioning specialist center
if you have excessive pinion to ring gear clearance the diff will be making terrible noises not a clunk
what you have is worn side gear washers in the diff carrier and that is not essential to repair unless you get diff noise on turning corners
All diffs have play in the diffs that most people say is pinion /ring gear problems when it is not
the clunk noise comes from engaging a gear and the diff housing reacts to the load ( radius rod bushes , stabilizer bar bushes etc), the side gears take up the clearance, and the
"U " joints or cv joints take any wear
Best advice is--- if all you have is a clunk ( check everything outside the diff first) and the diff runs quiet under acceleration or deceleration, DON'T fix what ain't broken

Jul 29, 2016 | Cars & Trucks

1 Answer

Gear box in my l300 4x4 ute is makeing a clunking sound in all gears apart from 4th and when clutch peddel is down it isnt makeing the clunking sound any ideas?


The bearings in the gear box are gone. When in 4th gear the input and output shafts turn at the same rate 1 to 1 ratio. In all other gears the shafts are turning a different rates and the clunking is a slight meshing of the gears. When the clutch is depressed there is no power (load) on the input shaft.

Jan 19, 2015 | Mitsubishi Cars & Trucks

1 Answer

1999 saturn sl2 transaxle shifts with a clunk all gears down shifts seem o.k???


The clunk is from an engine mount that is bad. Have them checked.

Dec 30, 2014 | Saturn Cars & Trucks

2 Answers

Loud Clunking when jeep starts moving in drive.


may be the gears in the rear end or check your motor mounts, ive had the noise and it was motor mounts

Dec 06, 2009 | Jeep CJ7 Cars & Trucks

1 Answer

1999 honda passport. clunks when stopping and a


have the rear chunk and front chunk checked out could have slack in gears.

Aug 28, 2009 | 1999 Honda Passport

1 Answer

TR6 Clunking


Does it go away or change when you depress the clutch. If so you will need to inspect the clutch pressure plate and bearing. You may need to remove trans. You may have a loose bolt on the flywheel that backed off a little.

Aug 14, 2009 | 2006 Triumph Tr 7

2 Answers

Tranny clunks when shifting gears


Check motor and transmission mounts.

Jun 15, 2009 | 1999 Buick Park Avenue

Not finding what you are looking for?
2007 Toyota Highlander Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...