Question about 2002 Chevrolet Blazer

Open Question

Instructions on how to remove radiator in 2002 chevy blazer

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 122 Answers

SOURCE: how to remove rear door panel on 2002 chevy blazer

usually two screws one at the armrest and one under the power window console , this console usually pops out to let you at the screw.

Posted on Oct 27, 2009

Ad
  • 225 Answers

SOURCE: how to replace a radiator on a 2002 chevy blazer?

radiator needs no special tools wrenches and ratchet i would replace all hoses connecting to the radiator and thermostat would be a good idea to ensure no overheating

Posted on Nov 03, 2009

  • 172 Answers

SOURCE: need diagram for removal and installation of

auto zone will have a book for your car that has some info in it for that

Posted on Apr 15, 2010

ryanlutton
  • 1142 Answers

SOURCE: How to clean throttle body on 2002 chevy trail

Instructions for doing it without removing the throttle body.

1. Disonnect the battery....very important so your stepper motor isn't ruined when moving the butterfly.
2. Remove the plastic resonator on the top of the engine (The black piece that says 4200 on it)
3. Remove the large rubber hose from the throttle body.
4. Clean away, with throttle body cleaner or Seafoam, I just use the blue shop towels to clean in there. Could use a plastic bristle brush also for more elbow grease. Be very careful, as the butterfly will cut you very easily, very sharp edges. Make sure you get all the gunk out of there, including any edges of gunk that may have formed, preventing the butterfly from opening and closing properly. Needs to be nice and shiny.
5. Hook the resonator and hoses back up, don't forget the little pcv hose on the front right corner of it.
6. Hook the battery back up and drive around for 20 minutes or so with all accesories OFF. The computer will relearn a properly functioning throttle body at that point.
7. Enjoy a little bettery gas mileage and horsepower.

Posted on Feb 21, 2011

  • 560 Answers

SOURCE: transmission line 1999 chevy blazer

yes

Posted on Jun 04, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you remove the rear speakers in a 2002 Chevy blazer extreme


Get a Haynes or Chiltons Manual for diagrams and instructions for your vehicle.

Nov 23, 2014 | 2002 Chevrolet Blazer

2 Answers

How can I get a free chilton repair manuel for a 2002 Chevy S10 Blazer


Chilton and Haynes books are never free. You may get lucky and find a used one for a decent price. Your best bet may be to go online at "alldatadiy.com". This will cost about $30 a year but it is very vehicle specific. You input the year,make ,model, engine and transmission and they provide detailed repair instructions complete with diagrams.

Sep 14, 2014 | 2002 Chevrolet Blazer

1 Answer

No heat


I had the same problem with my 2002 Chevy Blazer. The problem with mine is it was out of antifreeze due to a leak in my radiator.

Nov 09, 2012 | 2002 Chevrolet Blazer

1 Answer

A diagram of the flushing of a radiator and block of a chevrolet blazer LS 2000


Theres no such thing as a diagram, here are the draining instructions, hope this helps...
  • 1-Place a large drain pan beneath the radiator drain plug. The drain plug is located on the passenger side at the very bottom of the radiator on the engine side.

  • 2-Make sure the engine is cool. Open the hood of the truck and remove the radiator cap.
  • 3-Loosen the drain plug. On the 2000 Blazer, the drain plug is a wing-nut type of plug. Twist it with your fingers until the coolant begins to drain.

  • *To flush the block, once you have drained the radiator, run the engine for a bit untill the temp gauge goes up to normal, then the coolant will have been evacuated from the block. DO NOT leave the engine on, once it reaches normal temp, (this will happen quick) turn off right away, otherwise you'll be forking out a few hundred $$$ to fix the worped heads.
    4-Tighten the drain plug with your fingers once the coolant has drained fully from the radiator. Remove the drain pan and dispose of the used coolant properly.
    Some service stations will take and recycle your used coolant.
    Hope this helps...



  • Read more: How to Drain a Radiator From a 2000 Chevy Blazer ' eHow.com http://www.ehow.com/how_6357264_drain-radiator-2000-chevy-blazer.html#ixzz1VS4RBufX

    Aug 19, 2011 | 2000 Chevrolet Blazer

    1 Answer

    Replace water pump


    u need a special wrench to remove the fan from old pump the rest is pretty much like old chevy 350

    Mar 20, 2010 | 2002 Chevrolet Blazer

    1 Answer

    Where is the coolant temperature sensor located in a 2002 chevy blazer?


    the sensor should be located near the thermostat housing. top radiator hose going into the engine

    Mar 20, 2010 | 2000 Chevrolet Blazer

    1 Answer

    How to replace a radiator on a 2002 chevy blazer?


    radiator needs no special tools wrenches and ratchet i would replace all hoses connecting to the radiator and thermostat would be a good idea to ensure no overheating

    Nov 03, 2009 | 2002 Chevrolet Blazer

    1 Answer

    How to remove rear door panel on 2002 chevy blazer


    usually two screws one at the armrest and one under the power window console , this console usually pops out to let you at the screw.

    Oct 27, 2009 | 2002 Chevrolet Blazer

    1 Answer

    Removing the radiator from a 2000 chevy blazer 4.3 4x4 4door???


    it is not that hard to replace the radiator. you can do it. remove negative cable from battery,drain radiator,remove top and bottom radiator hoses,remove transmission lines from the radiator, remove bolts in plasticradiator cover,remove all hoses connected to radiator, after everything is disconnected radiator will pull up and out

    May 19, 2009 | 2000 Chevrolet Blazer

    Not finding what you are looking for?
    2002 Chevrolet Blazer Logo

    Related Topics:

    159 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chevrolet Experts

    yadayada
    yadayada

    Level 3 Expert

    76673 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22219 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8531 Answers

    Are you a Chevrolet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...