Question about 2006 Buick Rendezvous

Open Question

P0030 error code on a 2006 buick rendezvous - 2006 Buick Rendezvous

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ajkill
  • 2035 Answers

SOURCE: What would cause the AWD light to come on in a

There could be alot of problems if the AWD lights comes it could either
transmission oil is old or the oil filter is dirty ,these interact with onboard
computer and produces false signal which causes the car to be AWD mode
or this could be the problem with selector switch ,first try to replace the oil and check if its AWD light goes......



Good luck...

Posted on Feb 18, 2009

  • 436 Answers

SOURCE: Buick Rendezvous 2002 need codes?

the BCM needs to be programmed to operate the computer. a GM techII is now required to calibrate BCM to airbag, stereo, keyless entry, and control pcm data. This is required to make it all work. a gm service should have it done within an hour or less just call and ask them how much it would be to program new BCM. it might cost @$75 to $125 but it is needed, to allow the BCM to work properly.

Posted on Sep 11, 2009

Testimonial: "ok...i bought the bcm on line (used)...but the gays in the dealer says i have to buy a new one..because the used cannot be to reflashed...or recoded."

c17hydro
  • 2984 Answers

SOURCE: How to change the fuel filter in fuel tank 2006

3.4L & 3.5L Engines

  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Relieve fuel system pressure.
  3. Remove or disconnect the following:
    • Negative battery cable
    • Quick connect fittings at the inlet/outlet sides of the in-pipe fuel filter
    • Fuel filter mounting bracket nut
    • Fuel filter and drain any remaining fuel

61788c9.gif
The fuel filter is located on the frame rail near the tank—with 3.4L and 3.5L Engines

To install:
  1. Install or connect the following:
    • Fuel filter to the bracket
    • Fuel filter assembly to the side rail near the fuel tank. Torque the nut to 89 inch lbs. (10 Nm).
    • Inlet/outlet quick connectors to the fuel filter
    • Negative battery cable
  2. Start the vehicle and checks for leaks, repair if necessary.

Posted on Oct 11, 2009

Testimonial: "Thank you for your reply, but my car is not the fuel filter in the fuel line underneath the body."

  • 743 Answers

SOURCE: Can I charge the battery for 2006 Buick

By disconnection one of the battery wires...if it is a side post, you will need to go to your auto parts store and get a post that screws in so you can attach the charger cable...the reason that you don't charge with everything hooked up is because you can get a surge and damage the components in the computers.

Posted on Oct 29, 2009

Testimonial: "Wire "+" connect to "positive (+) jump starting terminal" or to terminal " + " battery?"

  • 491 Answers

SOURCE: I want to change the battery in 2006 Buick

On most cars after 2000 it is recommended to keep a minimum of 9 volts in the system when disconnecting the battery.
You can buy a 9 volt battery unit to plug into your lighter socket.
Otherwise....if you have a battery charger....attach it to the alternator output and put it on its lowest setting....that should keep voltage in the numerous memory circuits while you change the battery.

When changing the battery.....(removing voltage from the system) it's a 50% chance of putting the radio into theft mode.
The codes to take it out of theft mode are available online.....just google.

Posted on Oct 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 Buick rendezvous traction control alarm going off periodically and service traction control system soon lights turn on. Also lights indicate that my abs and parking brake have been disabled


Need to get the codes read. Probably a bad wheel speed sensor which will require a replacement wheel hub assembly. All of those systems rely on the wheel speed sensors to operate properly. The brake light is not indicating that the parking brake is disabked, rather that the is an issue with the braking system

Sep 09, 2016 | 2006 Buick Rendezvous

1 Answer

2006 Buick Rendezvous labors when n park & o in idle. Slight vibration & feels like engine is straining. Up running it seems fine, plenty of power.Fuel injectors or? Plugs good, wires new a year ago


Do you have a check engine light on? If so have you had the PCM fault codes read? It sounds like you have a misfire in one or more engine cylinders, and that is most noticeable at idle and in drive.

Jun 09, 2016 | 2006 Buick Rendezvous

2 Answers

Where is the oxygen sensor on a 2006 Buick rendezvous 3.5 engine


There are four O2 sensors on your vehicle. Two for each bank of the engine. There will be one between the exhaust manifold and the catalytic converter and one near the end or just after the catalytic converter for each bank. If you are receiving a DTC indicating a sensor is bad, you need to see which sensor the code indicates. It will say something like bank 2 sensor 1.

Jan 25, 2016 | 2006 Buick Rendezvous

1 Answer

Vacuum hose diagram 2006 buick rendezvous


I believe that the 2006 Buick (if it is a U.S. version) is required to have a vacuum routing diagram posted at the engine (usually on top of the fan shroud). Check there.

Jul 19, 2014 | 2006 Buick Rendezvous

2 Answers

2006 buick rainer obd code30


in 2006 there is no obd system even code 30 your system is obd2 and code start with P????
obd system stop in 1995

Oct 14, 2013 | 2006 Chevrolet Trailblazer

1 Answer

2006 Buick Rendezvous cxl broken rear hatch strap!


I believe there is a recall for that feature. but i am not 100% sure. it was recalled on 2004 rendezvous

Jan 12, 2009 | 2004 Buick Rendezvous

Not finding what you are looking for?
2006 Buick Rendezvous Logo

Related Topics:

115 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...