Question about 2004 Toyota Sienna

Open Question

Programming garage door opener 2004 toyota sienna

Setting garage door button

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Rear door

Here's a link to the detailed instructions for this repair. It's not too difficult, just a little tedious dealing with small parts.
Good luck!

http://www.findonefindall.com/toyota-sienna/siennareardoor.htm

Posted on May 21, 2009

  • 34 Answers

SOURCE: both manual sliding doors on my Toyota Sienna will not open

If you can remove the inner door panel you will see a maze of cables running to the various locking points on the sliding door. If the cable going to the FRONT latch on the sliding door is broken (or in my case, simply dislodged inside the door) the door acts as if it is frozen shut.

The front cable is short, and easily replaced even by a newbie mechanic.

Posted on Aug 11, 2009

  • 1861 Answers

SOURCE: how to program 2005 toyota sequoia garage door

Hello.I will be glad to help you out.

Choose which of the 3 buttons you wish to use, on the car.

Take the remote transmitter, depress the actuator button, and continue to hold it until advised to release.

Depress the button, on the car, of your choice, and hold it down until advised to release.

Hold the garage door actuator (while holding the actuator button down) above the car's 3 buttons.

Rotate the door transmitter until the red light above the 3 buttons starts to flash slowly.

Stop moving the remote around when the light flashes slow.

Within several seconds, the same light n the car will now flash rapidly.

Release the car's button, release the transmitter button.

Verify that the door now operates..

Posted on Nov 30, 2009

  • 28 Answers

SOURCE: I have a Raynor FliteStar

The flite star has an external receiver ( a box located on the back on the motor), Remove the name plate from receiver box and you will find the learn button on a circut board

Posted on Jun 09, 2010

swolfinor
  • 504 Answers

SOURCE: Need to know how to program garage door opener.

Sorry, the process is simple but too lengthy to post here.

Goto homelink.com

They make the system and have very complete instructions you can download.

PLEASE NOTE: MOST but not ALL Brands / models of opener will work with this system.

Posted on Jul 18, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace 2006 toyota sienna garage door button


ce8527cd-f3f4-4bf7-89eb-9c6f223bf9b4.gif

dead or physically broken, buy a new one if broken

Dec 25, 2013 | 2006 Toyota Sienna

1 Answer

How to program garage door opener on 2004 toyota sequoia


You may find that this porcess is with your GARAGE DOOR opener and not the car. Rolling code technology units require that you press a button on your opener motor, (get a ladder and a light, get up there and read it, have an assistant in the car to press). what you do is press the button on the opener, to accept input signals, then you press the button in the car. Usually you get a flash on the opener's lights, then that sender (car) is accepted.

Jul 26, 2010 | 2004 Toyota Sequoia

2 Answers

Programming garage door opener 2004 toyota sequoia


GOTO HOMELINK.COM
THEY HAVE THE INSTRUCTIONS FOR ALL OF THESE UNITS.

Jul 26, 2010 | 2004 Toyota Sequoia

1 Answer

'04 Nissan Altima can't be trained to open garage door.


Hello , you are probably not doing anything wrong. Some garage door openers will not accept some codes. My Toyota Tundra 2005 worked on my garage door , but my 2004 F250 would not. Quinn , Arizona

Jul 16, 2009 | 2004 Nissan Altima

1 Answer

Program garage door


go to our garage door motor at the house. put your just in frt of it hit the reset button. then the button in the car the light will sart blinking fast in the caar when set

Jul 09, 2009 | 2007 Toyota Sienna

1 Answer

Power door is not delatching


there is a door lock actuator that has failed, it releases the latches so the door can open. you need to remove the door panel. unbolt the window and tape it as to hold the window up then remove the window regulator assembley then unbolt the lock actuator from the back side.

Apr 23, 2009 | 2004 Toyota Sienna

1 Answer

Program 2004 mercury mountainer garage opener


Verify the hand-held transmitter is operative.
Prepare for programming the universal transmitter by erasing all three channels (hold down the two outside buttons until the red light begins to flash [20-30 seconds]). Release both buttons.
Select one of the three universal transmitter channels to be programmed by pressing the desired button
Hold the end of the hand-held transmitter 25-51 mm (1-2 in) from the front surface of the universal transmitter so that the red light can still be seen
Use both hands to press the hand-held transmitter button and the desired button on the universal transmitter. Do not release either button.
Hold down both buttons until the red light on the universal transmitter flashes, first slowly and then rapidly. Release both buttons when the rapid flashing begins. The universal transmitter has successfully learned the new frequency signal and can be used in place of the hand-held transmitter(s).
If the hand-held transmitter appears to program the universal transmitter but does not open the garage door, the garage door opener may have a code protected or rolling code feature.
To operate, simply press the appropriate button on the universal transmitter. The red light is on while the signal is being transmitted.
IF THE GARAGE OPENER HAS ROLLING CODES---
program as above then------
Train the garage door opener receiver to recognize the universal transmitter.
Remove the cover panel from the garage door opener receiver.
Locate the training button on the garage door opener receiver. Location and color of the button may vary by garage door opener manufacturer. Refer to the garage door opener instruction manual or owner literature.
Press the training button on the garage door opener receiver for 1-2 seconds.
Press the programmed universal transmitter button for as long as the universal transmitter red light flashes (1-2 seconds). Release the button and re-press the button to confirm that the universal transmitter is trained to the receiver.
The garage door opener should recognize the universal transmitter.

Apr 01, 2009 | 2004 Mercury Mountaineer

1 Answer

The buttons for garage will not program in my Lexus RX 330 2004


The buttons inside the vehicle are syncronized/programmed with the operatus that physically opens and closes your garage door, not the operner... The garage door opener needs to have a "programming" feature switch that must be set to "programming" before you can program the buttons inside the car...

There are step by step instructions in your owners manual... This could be a 2 person operation...

I have a 2004 RX and had the same problem, simply because I didn't follow the instructions precisely..

Good luck...Oz

Mar 22, 2009 | 2004 Lexus RX 330

1 Answer

2004 toyota sienna sliding door locking trouble


Sounds like something isn't right.Try to disconnect the battery for a few minutes and see if that helps.Some times the ecu gets haywired and disconnecting the battery might reset it.And if it is the original battery you might want to get it tested.

Dec 03, 2008 | 2004 Toyota Sienna

Not finding what you are looking for?
2004 Toyota Sienna Logo

Related Topics:

159 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...