Question about 2005 Chevrolet Silverado

1 Answer

Left turn signal turns on hazard lights intermitently on 2005 2500hd silverado

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Light stay on

Posted on Jan 08, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
Molson02536
  • 3854 Answers

SOURCE: Constant clicking from flasher unit

The flasher unit has gone bad and needs to be changed. The flasher module is a part of the hazard module also. The clicking is the unit is still working but there is not enough voltage to activate the lights to flash. It's common on the Malibu's and other GM product cars similar to the Malibu like Grand Am's Ect. I believe Auto Zone has the replacement part for you car and is more reasonable in price then the dealer and the y also have the step by step instructions to replace the flasher module. Good luck and keep me posted, be glad to help.

Posted on Jun 03, 2009

  • 52 Answers

SOURCE: Left turn signal blinks fast in rear and regular in front

the bulb is blown out. you need to change it. also if the bulb is not blown out or if the blinker still blink fast after you change the bulb then you have a ground problem. just remove that blinker light and check the ground wire on it. if you need to replace it and find a good groun on the car. you should be fine. this is all it is .

Posted on Jun 04, 2009

  • 1 Answer

SOURCE: Chev Cavalier 2003 only one rear turn/brake/hazard light

I have a 2002 Chev Cavalier that had the same exact problem. I replaced the bulb harness (purchased from a chevy dealership for around $5) which was fairly easy to do. I have had zero problems with it since.

Posted on Dec 03, 2008

polarcycle
  • 1392 Answers

SOURCE: My turn signals/hazard lights aren't working, fuse--Chevy Tahoe

look for your short somewhere in the wiring harness.

Posted on Jul 23, 2009

  • 4 Answers

SOURCE: 99 Chevy Tahoe... Rear turn signals, brake lights, and hazards

I had this problem, and to be honest, it happened to the left side about a week later...it's the board that the bulbs plug into...it's a very common problem with this model. So popular that you can normally get the socket board off the shelf at a parts store! it's extremely simple to replace, and I replaced all the bulbs at the same time!

Posted on Oct 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 Silverado, turn signal activating hazards


check your turn signat bulbs . probably an intermittent bad ground circuit .

Feb 26, 2014 | Cars & Trucks

2 Answers

2002 silverado blinker issue


you can go to the car service center , buy a new one for your car ,remember the year and the model of your car for compare .

May 23, 2013 | 2002 Chevrolet Silverado 1500

1 Answer

I have an 02 kia sportage. my signal lights come on but dont blink outside. no lights for the signal lights come on on the dash at all. also, no hazard lights.


If the 15A HAZARD fuse in the passenger compartment fuse box is OK, power is getting to the hazard function of the flasher unit. Pressing the hzard switch should cause the hazard lights to flash. HOWEVER, there is an electronic time and warning indication system module connected to to the hazard switch lead and that may be affecting things. If the 10A TURN fuse is OK, power is applied to the turn switch (with the engine in START or RUN) and you state you can select a right or left turn. HOWEVER, the RED/WHT and RED/BLU outputs from the flasher unit connect directly to the front and rear turn lamps and the instrument cluster turn indicators so you are not getting any flasher output. Again, that electronic time & warning indication system module could be affecting things

Oct 26, 2012 | Cars & Trucks

1 Answer

Trun signals intermitently work, checked bulbs wires, fuses, i believe this problem is linked to the hazard lights. Is this posible? where is the hazard relay located?


yes it is linked with the hazard light in a way. when you turn the hazard light on do they seem like they work fine?? if they work good, i would say your need a turn signal flasher, of course the hazards run off of a flasher unit too.. they very from vehicle to vehicle, but most of the time they are under the dash on drivers side... turn your signal on and listen for the clicking, you should find it fairly quickly and easily, that is where your problem most likely is. hope this helps

Dec 07, 2010 | 2002 Jeep Grand Cherokee

1 Answer

Signal lights work intermitently on an audi a4 2001, possible/probable cause? hazards work all the time


if you have any problem with hazards lights you has to change the hazard switch this control left and right signal lights to.

Nov 25, 2009 | 2001 Audi A4

2 Answers

My turn signal works intermitantly. It works a


Seems your flasher is going out. If i am correct the switch for your hazard lights is also your flasher. One way to find out is when it stops working tap the hazard light switch and see if it starts to work again. If so there is your problem. Hope this helps

Oct 30, 2009 | 2001 Chevrolet Impala

1 Answer

Checked all fuses-good, swapped bulbs-good, hazard lights-good, head lights good, turn signals-good but no brake lights. 1995 chevy silverado


Does the turn signals or hazards work in the rear?? Yes... it may be the brake switch or the turn signal switch (power goes from battery, to the brake switch then to the turn signal switch, then to the lights. No? .. again.. possibly turn signal switch or the wiring between cab and bed.

Jun 04, 2009 | 1996 Chevrolet K1500

1 Answer

2005 Silverado - Hazard lamps come on when I use right turn signa


It is your flasher module. It is on the backside of the fuse box under the dash. You need to remove the panel below the steering wheel, above the peddles. The replacement part number is 10383321. Once you have the panel off it just pulls out and replace it with the new one. I got one on ebay for about
$30 shipped.

Mar 23, 2009 | 2005 Chevrolet Silverado

Not finding what you are looking for?
2005 Chevrolet Silverado Logo

144 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...