Question about Hyundai Motor 2004 Sonata

1 Answer

Check engine light is on

Sonata 4cyl
check engine light came on at the same time the rpm gage started acting irratic, upon scanning the car we discovered the code indicating the crank angle sensor was bad. I replaced it and the check engine light remains on and upon cleaing it the check engine light came back on with the code indication the crank angle sensor wasn't working.

Posted by on

  • earl96 Jan 05, 2009

    I forgot to mention car is running smoothly.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Remove positive battery for five minutes to re set the computre hook it back it should go out

Posted on Jan 05, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Code read p0011 the check engine light went out but the temperature gage still goes up rapidly on 08 Hyundai sonata


Timing is to far advanced causing vehicle to run hotter than normal you'll need to take it to a dealer it can be a few items causing this ecu unit faulty sensors or oil valve hope this helps

Mar 17, 2015 | 2008 Hyundai Sonata

1 Answer

2002 jeep Cherokee 2.5crd engine cuts after removing foot from accelerator pedal . no warning lights come on. let the vehicle stand for 10 minutes then it starts up again. can it be injectors or ignition...


check all fuses.
cuts out hot or cold engine.????????
if it wont start and car gets 60k tuneup (?)
then connect scan tool and crank for 5 seconds.
see if you get scan DTC errors , cranking (release key) see em?
stalls are caused by over 50 reasons. guessing is impossible or very expensive.
enter: Diagnosis,
you take measurements, and find the failure path then work that path like bird dog.
2.5L 4cyl engine. I just sold min last week. with 5sp M/T
cuts out, does that mean the engine stalls?
we need to know what it really does.
1: stalls (engine rpm drops to 0 RPM)
2: engine rpm drops to 300rpm and shakes.
3: power loss from engine?
4: only stalls at stop signs...?
5: bogs all them time, same as #3
6: engine misfires (shake)
7: bogs only on throttle TIP-IN then recovers.
8: bogs only on hills.

i wait.
when dead, is spark lost?

Aug 21, 2013 | Jeep Liberty Cars & Trucks

2 Answers

Engine light on rpm gage not working


cylinder 1 misfire change spark plugs i just had that problem. you can still drive it it wont hurt the engine.

Apr 25, 2010 | 2004 Kia Optima

1 Answer

Idiot lights come on.


could be a poor ground wire cable or body ground for ecm. Clean battery cables. (check condition of battery. A bad battery (below 9.0v) will cause irratic engine performance. Usually engine will stall. You did not say. check body ground straps. you'll need a digital ohm meter to test further.

Feb 27, 2009 | 1995 Chevrolet Cavalier

1 Answer

I have a 2000 ford expedition the problem i have is that in the morning when the truck is started the RPM gage is bouncing around. once i drive the truck and get to a traffic light and have foot on the...


first of all if you have over 60,000 miles the car is asking you for a tuneup but take it to auto zone and they will put it on the tested for free so you know what you are dealing with.

Jan 17, 2009 | 2000 Ford Expedition

3 Answers

I want to know how much oil I need for an oil change


start with 4 quarts and then check it
good luck ray

Jan 17, 2009 | 2006 Hyundai Sonata

1 Answer

Engine light is on


from 96 on you need a scanner to turn off code light, go to auto zone and they will turn it off for free, just tell them the problem.with the light still on the computer thinks it still has a problem.

Jan 05, 2009 | Hyundai Motor 2004 Sonata

1 Answer

2004 sonata 2.4 engine


The filter may be on the firewall or under the car by the fuel tank.The studering wouldtell me that it needs plugs and wires.If it is running smooth but no power up hills or hard take off I would have the fuel pressure checked.

Aug 02, 2008 | Hyundai Motor 2004 Sonata

Not finding what you are looking for?
Hyundai Motor 2004 Sonata Logo

274 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

63801 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...