Question about 1998 Jaguar XK8

Open Question

Scan codes jaguar p1111,p1643 - 1998 Jaguar XK8

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

johnthejag
  • 286 Answers

SOURCE: 2002 Jaguar X-Type slipping of trans, GEARBOX FALUT displayed.

Hi

Gearbox is a sealed unit now, from the factory, so no topping up possible.

Sounds like major problem in transmission.

Time to say goodbye, while it is still driving !

Good Luck !

A FixYa Rating would be appreciated thanks !

John.

Posted on Feb 11, 2009

  • 1 Answer

SOURCE: failsafe engine mode light comes on, codes

Just a quick mention - for about a month my XK8 low coolant light came on intermittently. This week with no notice while driving normally I got Stability Control Fail and FailSafe Engine Mode and wtih great difficulty got the car back to where I started from (less than a mile). Two days later (when got time) and after a bit of research, I tried it again - same problem and a very unhappy engine. I then disconnected the battery for 15 minutes (probably more) to clear the engine codes as well as check all the wiring and vacuum stuff I could under the hood (at a Jaguar master mechanic's recommendation). No problems found but the car would start and immediately stall with the air intake hose disconnected from the intake butterfly. After I reconnected the air intake hose, she started and purred like normal. The problem is the BATTERY... It is low - I've known it for a LONG time BUT it always started right up and never skipped a beat. I intend to replace it tonight but fully expect that's the issue. I've had the car 6 years (it's a 98) and had NO problems except a dead taillight asembly.

Hope this is of value...

Posted on Apr 22, 2009

jonathancole
  • 127 Answers

SOURCE: my 97 xk8 had that stability problem. now it will not start,

code p1111 is system pass code p0333 is knock sensor 2 high input (bank 2) code p1643 is can link engine control module/transmission control modual circuit/ network also see if your car has a fuel pump shut off switch also other safety features on cars to protect against damage trans and oil fluid pressure also ckeck your neutral safety switch

Posted on Aug 13, 2009

  • 2 Answers

SOURCE: what is an P1647 AND P1111 OEM CODE ON A JAGUAR

go to auto zone and look in the repair manual and it has all the codes...

Posted on Aug 30, 2009

  • 24 Answers

SOURCE: Ihave detected an error code P1647 and P1111 on my

Code P1347 can be set for either a short to ground, short to power, high resistance or open circuit on Oxygen Sensor for bank 2, (HO2S21). Bank 2 is on your right when standing at the front of the engine facing the crank, and this sensor is the first in line; before the converters.
Code p1111
- Intake Air temperature (IAI) intermittent high voltage-low temperature condition.
Probable Cause:
1. Open circuit to IAI-Check connector
2. Failed IAI
3. Open Circuit Condition

Hope this helps

Posted on Jan 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What does code p1111 mean on a 1999 jaguar van den plas


P1111 Intake Air Temperature (IAT) Sensor Circuit Intermittent High Voltage

Apr 10, 2013 | 1999 Jaguar XK8

1 Answer

2003 jaguar x-type 2.5 p1111,p1603,p1796


My jaguar gearbox light has came up some one help please

Sep 24, 2012 | 2003 Jaguar X-Type

1 Answer

P1111 code


The P1111 unlike the P1000- the P1111 means the ECM has completed a drive cycle with no faults stored. The P1000 means the ECM has not yet completed the drive cycle. They are basicly drive cycle readiness codes doing a system check...this is a natural code..not to worry its checking the car all over between drive cycles for any malfunctions..

Dec 09, 2011 | Jaguar X-Type Cars & Trucks

3 Answers

What does code P1111 mean


Hi.

P1111 is not a fault code. It is a special designator Jaguar uses meaning system ready, drive cycles completed after the last fault event.

May 20, 2011 | Jaguar X-Type Cars & Trucks

1 Answer

What does the service code p1111 mean?


Copied directly from a Jaguar forum:

P1111 is not a fault code. It is a special designator Jaguar uses meaning system ready, drive cycles completed after the last fault event. P1000, on the other hand, means system not ready, or drive cycles not completed after the last recorded fault event.

Some OBD II Basics - All P0xxx codes are generic and uniform across all manufacturers and mean the same on every car. All P1xxx codes are manufacturer specific codes. You cannot use a generic code chart to analyze P1xxx codes for a Jaguar.

Next time your car displays an engine fault light, try reading the codes then. If you have a CEL illuminated and the only code read is P1000 or P1111, then you probably have a fault that generic code readers cannot see. Could be a chassis code, for example.

One last thing - Neither P1000, nor P1111 can be erased.

Hope this helps you.

May 20, 2011 | Jaguar X-Type Cars & Trucks

2 Answers

The car is in limp mode and the code its throught at me is p1643


P0163 O2 Sensor Circuit Low Voltage (Bank 2 Sensor 3) most likely a faulty sensor

Apr 17, 2011 | 2003 Jaguar X-Type

1 Answer

My car has the code p1643 and p1745 and nose they mean, others want to know how can I fix it? and as I will be very expensive?


p1643- fuel pump monitor circuit low input / p1745- line pressure solenoid system. this is starting to sound like a ecu issue. i would verify fuel pressure and double check your fuel filter. start there.

Jan 23, 2010 | 2002 Jaguar X-Type

1 Answer

My 97 xk8 had that stability problem. now it will not start,


code p1111 is system pass code p0333 is knock sensor 2 high input (bank 2) code p1643 is can link engine control module/transmission control modual circuit/ network also see if your car has a fuel pump shut off switch also other safety features on cars to protect against damage trans and oil fluid pressure also ckeck your neutral safety switch

Aug 13, 2009 | 1999 Jaguar XK8

1 Answer

2002 Jaguar X-Type slipping of trans, GEARBOX FALUT displayed.


Hi

Gearbox is a sealed unit now, from the factory, so no topping up possible.

Sounds like major problem in transmission.

Time to say goodbye, while it is still driving !

Good Luck !

A FixYa Rating would be appreciated thanks !

John.

Feb 10, 2009 | 2002 Jaguar X-Type

Not finding what you are looking for?
1998 Jaguar XK8 Logo

Related Topics:

106 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

74896 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

455 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...