SOURCE: Do you know where or if a 2000 Mazda 626 has a
Hello, I am going to make a few assumptions here. The vehicle has an electric fuel pump and you replaced it. The vehicle has fuel injection. The engine is actually cranking, just not starting, when you say "car still won't crank". You are getting fire to the spark plugs at the plug ends. You checked the fuel pump for power at the pump. No power, then you back traced the wire to the fuse block and checked the fuse to see if it was blown. If the fuse is good back trace the power to the ignition switch and/or ECM for power. You have power at the pump, check the ground and make sure it is connected properly. Will the pump run when someone turns the key on? Pump runs, check fuel manifold for pressure. No pressure, check the fuel filter for blockage, or replace it. Fuel pump doesn't run, new replacement pump is defective. There is usually some type of control module for the fuel pump on fuel injected vehicles. Good Luck, RAC
SOURCE: Locating oil filter on 2000 Mazda Protege
on the backside of the motor, towards the firewall. look above the drive shaft. it's about haft way up the motor.
SOURCE: How to Replace a Fuel pump on a 2000 Mazda 626
yes it isn't that much if you buy them.they slide inside the coupler and release the line.
Testimonial: "Thank you didn't know if there was a tool for this."
SOURCE: mazda protege fuel pump 02
to take the seat out you have to pull up on it hard. before u start connect the neg. side of the battery. open the gas cap to help to let the or some of the pressure out of the tank.remove the fuel pump cover and unplug the electrical connector and disconnect the wire on top of the fuel pump. disconnect the fuel supply and return hoses from the pump. be careful when trying to unscrew to screws you might have to tip on them to loosing up the lock tight that was put on the screws from the factory. than carefully lift the pump out. disconnect the electrical and move the hose clamp clear the pump fitting. remove the band securing the pump to the bracket and bracket at the bottom of the pump with the rubber mount. remove pump and always remember that gasoline is extremely flammable so take extra precautions when you work on any part of the fuel system. good luck.
SOURCE: how to replace a timing belt on a 2000 Mazda Protege
Here is a website that a free manual can be down loaded for your vehicle
http://ezinearticles.com/?Find-the-Free-Auto-Repair-Manual-You-Need-Online&id=92717
357 views
Usually answered in minutes!
×