Question about 2004 Toyota Camry

Open Question

My 2004 Toyota Camry horn does not beep when I lock the doors with the remote. The doors lock, but it does not beep to give me confirmation.

When I use the remote to lock the doors, the horn does not beep, nor do the lights flash

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 1999 toyota camry horn beeping when i replace the battery

I put a new started in my 99 camry the alarm went off and I didn't know how to stop it ,now my car doesn't have any power the battery is new but its not giving my car any power.Help...

Posted on Oct 09, 2008

alzhane
  • 1 Answer

SOURCE: Need to reprogram door locks for 2004 Toyota Camry

I recently replaced the battery on my 2004 Toyota Camry. When I installed new battery the door locks will not stay unlocked once opened with remote. How do I reprogram?

Posted on Apr 07, 2009

  • 88 Answers

SOURCE: remoe dont lock or unlock the doors. hazard lights, indicators and horn dont work.

You might have a blowen fuze. I would check that first. If it is blowen and continues to blow after replaceing it, then you have a short somwere in the wiring.

Posted on May 19, 2009

co7196
  • 3433 Answers

SOURCE: need to disarm factory installed alarm in 1996 toyota camry..help

It's possesed! Kidding. Turn the radio off and disconnect the battery for a little bit. Then reconnect. It soulds like you theft alarm is having a bad day.

Posted on Jul 29, 2009

  • 1810 Answers

SOURCE: 2004 Toyota Sienna - keyless remote will unlock

sounds like a bad reley
there are usualy 2 releys 1 for open and 1 for close but the drivers door is for some reason on a private circut without reley or reley is locked in

Posted on Dec 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to stop beep when locking and unlocking camry le 2010


When Horn chirp is enabled, the vehicle horn will chirp on locking and unlocking the vehicle, to enable or disable the horn chirp:

1. Turn headlight switch "OFF"

2. Cycle the ignition switch from "LOCK" to "ON" three times (within 5 seconds) leaving it "ON"

3. The vehicle security indicator will illuminate continuously for 5 seconds

4. During the time the indicator is illuminated, operate the horn(for 1 second). The turn signals will flash once to confirm successful programming.

5. Turn ignition switch to "LOCK" and test system with the remote controls.

To disable horn chirp, repeat the procedure for enabling.

The user manual actually declares customizations of the smartkey must be done by the dealers using special equipment. However, the above procedure works on a variety of years and models. And I see no where in the user manual that refers to the horn and door lock even being a customizable setting.

Aug 10, 2017 | Cars & Trucks

2 Answers

When I press the unlock button, why doesn't the horn beep?


I have a 09 kia spectra, The only time the horn will honk. is when I lock the doors with the remote. Unlocking just makes the lights flash! God-Bless! and hope this helps you out.

Mar 14, 2016 | 2013 Nissan Rogue

1 Answer

How do I reactivate the wireless remote control transmitter for a 2004 Toyota Camry XLE? I replaced the battery and the transmitter still does not work.


To Program Wireless Remote Transmitters:
Begin with:
The driver's door open and unlocked.
Key out of the ignition.
1.Insert and remove the key from the ignition switch 2 times within 5 seconds.
Steps 2 and 3 should be performed within 40 seconds.
2.Close and open driver's door TWICE.
3.Insert the key into the ignition and remove it.
Steps 4 - 6 should be performed within 40 seconds.
4.Close and open the driver's door twice.
5.Insert the key into the ignition.
6.Close the door.
7.Turn the ignition switch from "Lock" to "On" and back to "Lock" at about 1 second intervals to select the desired mode:
1 time for ADD mode.
2 times for REWRITE mode.
3 times for CONFIRMATION mode.
5 times for PROHIBITION mode.
8.Remove the key from the ignition.
9.To confirm your mode selection, the power locks will now cycle "lock" to "unlock" a number of times corresponding to your key cycles in step 7.
If Confirmation or Prohibition modes have been selected, opening the door will complete the procedure.
10.For Add or Rewrite modes do the following within 40 seconds of Door Lock confirmation:
A.Press both transmitter Lock and Unlock buttons simultaneously between 1 and 1.5 seconds and release.
B.Within 3 seconds of step A press the transmitter Lock button for more than 1 second and release.
^If the transmitter has been successfully programmed, the power locks will cycle "lock" to "unlock" once at this time.
^If there are problems with the transmitter or the procedure up to this point, the locks will cycle twice. If this occurs, verify that you have received the correct transmitter, and then repeat the above procedure.
C.If multiple remotes are to be reprogrammed, repeat steps A and B.
11.Open the driver's door to conclude programming mode.

Sep 02, 2010 | 2004 Toyota Camry

1 Answer

99 jeep cherokee, horn sounds when locking with remote. Checked all door switchs and seem to be working fine?? any ideas?


Its supposed to beep once when the doors are locked, giving an audible confirmation that your anti theft is armed. The parking lights will most likely flash as well to give a visual confirmation. If you have the over head computer in this model the horn confirmation option can be turned on or off in the normal settings menu.

Mar 11, 2010 | 1999 Jeep Grand Cherokee

3 Answers

Driver side door doesn't lock or unlock with the remote. The rest of the doors work fine.


Does the Driver side door lock and unlock from the lock switch inside? If not then you have a bad motor or bad connection to the lock/unlock motor inside the door.

Jan 08, 2010 | 2004 Toyota Camry

1 Answer

Need to reprogram door locks for 2004 Toyota Camry


I recently replaced the battery on my 2004 Toyota Camry. When I installed new battery the door locks will not stay unlocked once opened with remote. How do I reprogram?

Feb 21, 2009 | 2005 Toyota Camry Solara

1 Answer

Automatic door locks will not work


Probably the door actuator - a part inside the door that activates the lock, particularly if neither the interior lock switch or the remote do not lock the door.  Once the doors lock the horn will beep again - the lack of beep indicates the vehicle is not secure.

Nov 17, 2008 | 2004 Honda Pilot

2 Answers

1999 toyota camry horn beeping when i replace the battery


I put a new started in my 99 camry the alarm went off and I didn't know how to stop it ,now my car doesn't have any power the battery is new but its not giving my car any power.Help...

Aug 20, 2008 | 1999 Toyota Camry Solara

Not finding what you are looking for?
2004 Toyota Camry Logo

Related Topics:

216 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...