Question about 2002 Nissan Quest
If you can get it going some how, Like buy boosting it, Most auto parts supply stores ,Have testers end will check it out for you,No charge for doing it for you.
Posted on Nov 06, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The camshaft sensor is located inside the distributor and is part of it, in order to replace it you must replace the distributor,to replace remove the dist cap. mark the location of the rotor,by marking where its pointing to, then mark the dist housing, so now theres a mark on the rotor and housing to show where rotor points, next mark the location of dist going into housing, mark the shaft and the block,because it spins in block this way you can line back up.next remove hold down bolt and pull out,mark the new dist in exacat same spots as the old so you can install back the same,you may have to put it in and pull it out until your marks are lined up,this way the timing will be dead on, when done you can check timing. good luck
Posted on May 09, 2010
Take the VSS unit out as described. Need two people. Have the unit out of transmission but hook up the electrical wire. Turn the ignition ON but do not start the engine. Turn the gear while someone watches the speedometer. If you get a response then just replace the gear and try it. The gear may not look worn or broken but just a little wear and it looses contact with the transmission worm gear. This may cost you about $6 instead of over $60.
Posted on Jul 09, 2009
SOURCE: How can permanently disable the
If you're ok about messing with the wiring on your vehicle, you can connect the factory disarm wire permanently to a body ground, to disable the factory security. The factory disarm wire is;
Factory Disarm Red/Black (-) Driver's Kick Panel
Posted on Sep 08, 2011
SOURCE: I have 2007 nissan quest.
If you follow the positive cable (right at the post in most cases) there is a 50 amp fuse. You may have blown that fuse whicgh is common when changing the battery unless you remove it. Connecting the positive cable first when installing the battery helps prevent this. Also there are several other fuses that you may have blown which connect to the theft system going to the body control module which will prevent the vehicle from stating. If the fuse on the posive cable isn't blown (which I bet it is) in the fuse panel in the vehicle check fuse number 3, 4 , & 19 . See layout diagram below. Also in the fuse panel in the engine comapartment you can check fuse number J and 25 . See layout diagram below. I hope this helps and good luck.
Posted on Sep 22, 2011
Tips for a great answer:
Nov 09, 2012 | 1994 Nissan Quest
Sep 16, 2012 | 2008 Nissan Quest
May 29, 2012 | 2004 Nissan Quest
May 01, 2017 | 1993 Nissan Pickup
Sep 22, 2011 | 2007 Nissan Quest 3.5 Minivan
Sep 07, 2011 | 1996 Nissan Quest
Aug 30, 2011 | 1999 Nissan Quest
May 11, 2011 | 2004 Nissan Quest
May 06, 2009 | 2002 Nissan Quest
275 people viewed this question
Usually answered in minutes!