Question about 2003 Honda Civic
My sons heater blower is not working and he said a wrist band of beads broke and some of the beads fell down the window vents. How do i fix, Could it have burned out the motor
The blower is located under the passenger side of the dash. There is likely a trim panel that will need to be removed to gain access to the blower motor. Once the panel is out of the way the three screws that hold the blower to the housing can be removed and the blower motor will drop out. You can then inspect and/or remove the parts that are blocking it.
Posted on Nov 07, 2012
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
you need to remove your glove box assy.(beleave only 2 screws and pivot clips) make sure its not anything from glove box that has slipped behind. once box is out uf way you can access easier the blower motor assy. it actually attaches into blower box from bottom side. when looking at you will find three screw/bolts fastening motor to casing. remove those and then slowly lower motor and fan cage(attached to motor shaft) out from housing. sometimes it takes a little convincing to come out but not real tough. once out you most likely find the object causing noise in fan cage or resting up on lip area of housing unit. once found install in reverse order. let me know if this helps or if we need to dig a little deeper into! good luck!
Posted on Feb 02, 2009
SOURCE: heaters not blowing out any air
most likely the blower resistor is burnt out, this controls the speed of the air blower, low,medium,high. The blower and the resistor are located behind and to the right of the glove box under the dash on the passenger side, u will need various screwdrivers and a few different wreches t fix it yourself.
Posted on Jan 06, 2009
I had this problem as well as 33 others I've spoken to online. The main floor harness runs thru the drivers side front fender and plugs into the drivers door. The harness in 1996 civics are an inch or 2 too short so after a few years a few of the 25 thru 27 wires in the plug #C556 either break off or pull out of the plug. Since the drivers door contains the master power window and lock switches and the power mirrors can also be affected it can seem like everyones problems are in different parts of the car but they are all part of the same default. So I went to ebay and purchased a floor harness with full power options and installed it myself. Until my part came in I just went to a junk yard and cut off a good plug then spliced it into my existing floor harness. Hope this helps. It took me 4 months to figure this problem out!!!
Posted on Feb 17, 2010
Tips for a great answer:
Sep 14, 2012 | 2003 Honda Civic
Mar 20, 2011 | 2003 Honda Civic
Oct 16, 2010 | 2003 Honda Civic
Jan 31, 2010 | 1991 Honda Civic
Jan 24, 2010 | 1998 Honda Civic
Aug 27, 2009 | 2001 Honda Civic
Jan 22, 2009 | 2003 Honda Civic
Jan 06, 2009 | 2002 Honda Civic
477 people viewed this question
Usually answered in minutes!