Question about 2005 Ford Ka 1.3
Tyre pressure for front and rear wheels
If ever in doubt . Just put 30 psi in until you can get to a ford garage or tyre service centre as they will have the charts on the wall of all tyres.
It also makes a difference if normal load or fully loaded vehicles..
Posted on Sep 21, 2014
Posted on Nov 06, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
look on the sidewall of the tire. will show max inflation press, and you should run about 5psi below that unless you have a heavy load. then run the max.
Posted on Jul 22, 2009
You have a bad ball joint or strut most likely. The strut may of collapsed that is why the car is sitting low. I would lean more toward a strut problem than a ball joint.
Posted on Aug 31, 2009
SOURCE: ford ka rear spoiler
You need to look on under side of spoiler, and match studs. (two way threaded bolts) to the wholes. after that mark where the stud wholes need to go through the trunk then drill wholes a 16th bigger than the studs. After drilling wholes through the trunk get sillicone sealer around wholes. Install spoiler and install bolts on the underside of your trunk.
Posted on Nov 17, 2008
if wheel is offline then the person who done the tracking is responsable and take the car back to them and get them to put it right .the correct way is to adjust each track rod end a little bit not all the adjustment on one track end ,which throws out the wheel alignment .this means that you lose steering lock on one side .THIS IS COWBOY BODGE JOB .If they cant or wont put it right then take it to someone who can and report them to the office of fair trading and make a legal claim for the job to be put right
Posted on Sep 01, 2009
Testimonial: "cheers thanks for the advice."
yes it is one big nut, however it looks like 4 individual nuts due to the fact that they are a thinly stacked layer or thin nuts held together by what you called the tab washer............only way to replace is to get a new one from ford........
Posted on Sep 19, 2009
Testimonial: "Thank-you for that, I have ordered a new one from the ford dealers. I just wonder why the 4 nuts were fitted in the first place? thank you"
Tips for a great answer:
Mar 22, 2015 | 2007 Toyota Camry
Apr 28, 2014 | Ford F-150 Cars & Trucks
Aug 31, 2011 | Ford Festiva Cars & Trucks
Jul 25, 2011 | Ford Escort Cars & Trucks
May 13, 2011 | 2001 Mercedes-Benz C-Class
May 18, 2010 | 2003 Jaguar X-Type
May 26, 2009 | 1994 Honda Civic
627 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: