Question about Oldsmobile Cars & Trucks
Engine runs rough
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
its just white cuz i too the cat off..
cuz i thought my proble could have been to do with the cat...
cuz i lost power driving up hills and on highways now it just will start the die right away
or start and idle really bad...
i was thinking crank sensor.. or injectors
Posted on Oct 01, 2008
it is on the passenger side on the back off the motor.there are two allen head bolts or 13mm.it goes into the transmission and normally has rubber at the opening.you should be able to gets this from the top follow middle of valve cover on pass. side the go strait back toward the fire wall.please rate this answer.
Posted on Jan 30, 2009
SOURCE: Camshaft sensor location
The cam sensor on the 4.7 is located toward the forward edge of the right cylinder head (passenger side). This has a 3 wire connector, tan/with yellow tracer is sensor signal, black / light blue tracer wire is sensor ground and the orange is the 5V supply.
Posted on Mar 22, 2009
ANSWER: CRANKSHAFT POSITION SENSOR - 4.7L V-8 ENGINE
The Crankshaft Position (CKP) sensor is located at the right-rear side of the engine cylinder block CKP Sensor Location/Removal/Installation - 4.7L V - 8 Engine the cranks sensor is positioned and bolted into a machined hole in the engine block
Disconnect CKP electrical connector at sensor.
Remove CKP mounting bolt CKP Sensor Location/Removal/Installation - 4.7L V - 8 Engine
Carefully pry sensor from cylinder block in a rocking action with two small screwdrivers.
Remove sensor from vehicle.
Check condition of sensor o-ring.
Clean out machined hole in engine block.
Apply a small amount of engine oil to sensor o-ring.
Install sensor into engine block with a slight rocking action. Do not twist sensor into position as damage to o-ring may result
CAUTION: Before tightening sensor mounting bolt, be sure sensor is completely flush to cylinder block. If sensor is not flush, damage to sensor mounting tang may result.
Install mounting bolt and tighten to 28 N·m (21 ft. lbs.) torque.
Connect electrical connector to sensor.
Posted on Jun 29, 2010
Tips for a great answer:
Feb 23, 2015 | Dodge Cars & Trucks
Dec 13, 2014 | 1989 GMC Sierra
Jan 28, 2013 | 1998 Dodge Dakota
Oct 21, 2012 | 1995 Dodge Dakota
Jun 16, 2012 | 1989 Mercury Cougar
May 04, 2011 | 1993 Dodge Dakota
Jan 18, 2010 | 1996 Dodge Dakota
Feb 16, 2009 | 1989 Dodge Dakota 2WD
Aug 13, 2008 | 1992 Dodge Dakota
82 people viewed this question
Usually answered in minutes!