Question about Cars & Trucks

1 Answer

My son's 1984 VW Rabbit, is there a spacer for the driveshaft and the front axel(s)?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 75,197 Answers

We do not have diagrams this old. You can buy the access to the factory repair manuals here It is a small fee.

Posted on Nov 06, 2012

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: 2005 ford ranger 4wd front driveshaft

NO when in 2wd the front tires will not turn. I have the same truck

Posted on Apr 15, 2009

toshiba1991
  • 32 Answers

SOURCE: fuse relay diagram for 84 vw rabbit gti

9_16_2012_11_33_09_pm.jpg i believe this is the diagram you're looking for

Posted on Sep 16, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is fuel pump relay on my vw rabbit


You didn't mention what engine you have. The location I am showing you in the picture below (Red arrow/relay 1) is the location for the 1.7 & 1.8 liter engine. If you have the turbo or the DSL engine, the location is different. Hope this helps....

48ec3f24-9a2d-450a-8e03-4e81fedf5020.jpg

Apr 02, 2013 | 1984 Volkswagen Rabbit

2 Answers

How do you make 1992 legacy rear wheel drive


There is a fuse holder in the engine compartment. If you install a fuse in it it will make it front wheel drive but not rear wheel drive.

May 02, 2010 | 1992 Subaru Legacy

1 Answer

1999 explorer in 4-high on slippery road there is clunking This was my original question. powernut suggest I check the U-joints and the front axle joints. I checked them and they are fine. Another said it...


Try raising the vehicle in the air, use jack stands to safely support it, all four wheels off the ground. Now with transmission in neutral, go under and turn the driveshafts by hand and try to detemine where the noise is coming from. If that truck has a double U-joint setup of the driveshaft(s) check those realy good and double check the axel U-joints. Turn the front wheels either far right or left and spin the wheels (by hand), both sides, is there any binding? Make sure the axel shafts are turning while you spin the wheels. Look for rusty powder around all the U-joints listen for squeaking too. If you can't find anything wrong like that then start the truck and put in "4 High" and "D", let it idle and go under and listen for the noise. Don't get caught up in the driveshafts!!!!!!!

Jan 10, 2010 | 1999 Ford Explorer

2 Answers

Other than not having 4 wheel drive, what would happen if i removed the forward drive shaft


You need to look at the yoke connections. If the ends look like they are sealed and only connected by U-joints then it should work. If one of the ends fits like a driveshaft in some auto transmissions then the yoke may not be bolted onto the output shaft and it would slide out like a driveshaft. This would leave a big hole and no seal.

Jul 10, 2009 | 2001 Jeep Grand Cherokee

1 Answer

Front right universal joint removel


no but you have to remove the driveshaft.

the bolts are 8mm on the driveshaft to rearend u-joint

Apr 11, 2009 | 2008 Dodge Ram Pickup 1500

1 Answer

2005 ford ranger 4wd front driveshaft


NO when in 2wd the front tires will not turn. I have the same truck

Mar 24, 2009 | 2005 Ford Ranger

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

132 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...