Question about 1999 Chrysler Cirrus

Open Question

Change license plate light on 1999 chrysler cirrus

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
fischmilch
  • 96 Answers

SOURCE: 1999 chrysler cirrus

Check the coil packs, or the Ignition module. Disconnect the harness to the ignition module. And test the leads to see if there is current. I don't know what the specs should be, but it will be minimal. Never overlook fuses either.

Posted on Nov 07, 2008

Ad
Molson02536
  • 3854 Answers

SOURCE: 1999 chrysler cirrus transmission will not shift

It sounds like it may be you speed sensor at the transmission which is also called Vehicle Velocity Sensor (VVS), The sensor or the wire harness may have gone bad and needs to be replaced, but it's a good thing to have your car scanned at Auto Zone since they scan free of charge. I just want to make sure it is the VVS and not the transmission Control Module (TCM), Check the fuse under the dash and under the hood and look for any blown fuse like the TCM fuse. Good luck and hope this helps, keep me posted

Posted on Jun 24, 2009

  • 880 Answers

SOURCE: where is thermostat in a 1995 chrysler cirrus LX

A tee is located to the right hand side of the intake manifold, on top you should see the coolant system cap, its silver in color and is about 2-3 inches in diameter. This tee is the thermostat housing, it goes to your radiator and engine block, remove it from the block and you should see the thermostat. Remember when replacing the thermostat, the spring side goes into the block! 2.0L and 2.4L it is under where the upper rad hose hooks to the engine. 2.5L it is under where the lower rad hose hooks to the engine.

Posted on Dec 29, 2009

  • 1 Answer

SOURCE: 99 chrysler cirrus lxi won't shift out of 2nd, no speedometer

Had the same problem on my 1999 cirrus lxi. Replaced the output speed sensor on the tranny and topped off the tranny fluid... cleared the check engine light and the cirrus ran great. Caution...the output speed sensor reqires removal of the front left tie and plastic weatherproofing to replace. once you find it's locvation, the replacement is relatively easy.

Posted on Jan 10, 2010

  • 9 Answers

SOURCE: where is the battery located on a 1999 cirrus

The owner's manual says to crank the steering wheel all the way to the left. It is difficult and I had to lift the battery with one hand when replacing it, but you can get between the wheel well and tire, without removing the wheel.

Posted on Mar 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Change oil


Here is a tutorial on changing the oil in a 98 cirrus (I assume it would be the same on your car) : http://autoresource.internetautoguide.com/change-oil-98-chrysler-cirrus-3178.html

Oct 14, 2013 | 1999 Chrysler Cirrus

1 Answer

1999 chrysler cirrus engine is smoking


i would start with washing the engine down with a degreaser the smoke could be old oil burning off then if you still have a burning smell you will know its fresh you can get a dye from a parts store and with a black light you can trace the leak

Aug 08, 2012 | 1999 Chrysler Cirrus

2 Answers

2000 Chrysler Cirrus vibrates really bad at speeds under 40 km/h. Vibration still there at higher speed but not as bad. Steering and alignment don't appear to be affected. Any ideas?


Check the ball joints and tie rod ends and Tire balance. Could have broken/slpped bet in a tire or whaeel migh have thrown a balance weight.

Jan 15, 2010 | 2000 Chrysler Cirrus

1 Answer

2000 chrysler cirrus problems


I have the same problem with great shaking while stopped idling, but no engine light. It is worse when cold and worse when in gear. I have a 1999 Cirrus with the 2.4L engine. It works great and there are no error codes. What I have discovered is that there is something called a flex plate that goes between the torque converter and flywheel and it was cracked. It must be easy to access to inspect (more work to repair though) as the garage didn't charge me for the diagnosis. They said that the crankshaft rear seal was also pushing out. You can do both at the same time once you get it apart.

Jan 02, 2010 | 2000 Chrysler Cirrus

1 Answer

Brake light fuses for 1999 chrysler cirrus LXI


Under the hood fuse box. Fuse number 4, 20 AMP.

Nov 04, 2009 | 1999 Chrysler Cirrus

1 Answer

Where is oil sending unit location on 1999 chrysler cirrus 2.4 ?


most likley place is on the engine block look for it there

Oct 24, 2009 | 1999 Chrysler Cirrus

1 Answer

How to find oil bolt to change oil on 1999 chrysler cirrus


lift up the car on ramps or a jack and crawl underneath the front of the car the oil pan is directly below the motor at the lowest point you will find the bolt

Mar 10, 2009 | 1999 Chrysler Cirrus

Not finding what you are looking for?
1999 Chrysler Cirrus Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...