Question about Cars & Trucks

Open Question

Distributor and spark plug wiring for 1996 5.9 dodge pickup

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 834 Answers

SOURCE: need distributor cap and spark

One of these firing order diagrams should help to assist you, (depending on either a V-8, or V-6 engine) and let me know if you require any further assistance.

V-8 Firing Order Diagram.

884e1c9.jpg

V-6 Firing Order Diagram.

1d726be.jpg

Posted on Sep 25, 2010

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Can any body tell me which coil is the intake and which one is the exhaust?


Go to "youtube" type in your year make and model/ plug wires to coil.

May 07, 2017 | Nissan Cars & Trucks

1 Answer

Would the electronic distributor pickup cause a vehicle to spit,sputter and cut out at a high rate of speed ????


First you can not put Bosch plugs in it. Also watch cheap wires from parts house. Also check fuel pump pressure at high speed. Also watch for Catt converter plugging. Try unscrewing up stream o2 on both sides then drive. If goes away plugged Catt. You can scan those and see fuel values. Then you can tell. Any codes?

Mar 11, 2017 | Dodge Cars & Trucks

1 Answer

The pickup has no spark was going down the road and it just stopped running


Search Results

    "No start" Due to Pickup Coil Failure Inside Distributor ...

    repairpal.com > Problems > Toyota > Camry
    The pickup coil inside the distributor can fail and cause a no-start condition. ... checking reveals not only no spark at the plug, but also no spark going into distributor. ... the car runs great but only for about 10 miles. then it shuts down as if there is no ... The plugs have a weak spark when checked against the engine block.

    Car dies randomly, It turns over but no spark - 1989-1994 ...

    https://www.ifixit.com/.../Car+dies+randomly,+It+turns+over+but+n...

    iFixitf your engine cranks normally but will not start because it has no spark, or it stalls ... A bad pickup inside the distributor (on engines that have a distributor), a stripped ... Really old post but could you please tell me how I would go about checking if my ... When it all got down to it, one of the timing belt idlers had worn out and ...

    Dodge Ram 1500 Questions - 1994 dodge 5.9 just shut off ...

    www.cargurus.com > Questions > Dodge > Ram 1500

    CarGurusApr 12, 2012 - 1994 dodge 5.9 just shut off and wont start back up there is no spark or ... hall effect (magnetic pickup) in the distributor? ... So I ran power back to the wire and repaired the broken wire and she fired right up and is running darn good again. ... Ihave a 2000 dodge ram 1500 it died going down the road it is ...

    No Spark - 4.3L S10 Pickup - CarGurus

Dec 14, 2015 | Cars & Trucks

1 Answer

Diagram or picture of where the spark plug wires go into the distributer on a engine number 318-1


For this you have to determine when the #1 cylinder is at TDC (Top Dead Center) - when it would be firing. Take the distributor cap off and look at the rotor - it would be pointing at the #1 spark plug wire on the distributor. The wires would be connected it order around the distributor cap starting at 1. The sequence is 1-8-4-3-6-5-7-2 in a clockwise fashion.

Jul 13, 2014 | 1983 Dodge Pickup

1 Answer

Spark plug wires installed wrong


I did this also recently, but I also changed the distributor cap and rotor. THAT was my problem....Distributor screw tabs on distributor are plastic and can break off.....1st...Make sure you installed the wires in the right firing order. If they're correct, check your cap and rotor and make sure they are seated correctly. If the tabs broke off, Napa makes a metal U shaped piece that fixes this.

Jan 13, 2014 | 1996 Chevrolet S-10 Pickup

1 Answer

My 1986 dodge 600 won't start..the engine is cranking and gas is getting in to it but I can't get a spark..I also have changed the coil n still not gettin a spark..


i assume you have checked to make sure that the distributor is turn while cranking.if not then you have a broken timing belt,if it is turning then you probably have a bad pickup coil in the distributor.the wires that come out of the distributor that plug into a harness is part of the pickup coil.if you follow the wires into the distributor it will take you to the pickup coil itself this is the part that needs to be replaced.i trust that you checked to for battery voltage to the coil.

Mar 18, 2011 | Dodge 600 Cars & Trucks

1 Answer

1984 dodge Ramcharger w/318 been running great last night .No spark have gas at carb spins over no spark,dist dry,no fuse for ingnition that i can see any help?


check distributor module, oreilly can check these for free. also maybe plugs, wires, cap, rotor.. if this isnt it maybe the pickup coil went bad which would usually be easier to buy a new distributor instead of taking apart distributor, if you have to replace distributor i would check junk yard prices on something older like that you can probably get parts for pretty cheap

Mar 12, 2010 | 1984 Dodge Ramcharger

1 Answer

Spark plug wires mismatched. 1996 GMC Sonoma Pickup Truck.


Their is no distributor on a this vehicle from the factory. Their are two coil packs loctated underneath the intake manifold. If the coil packs have not been replaced then they will be labled 1-4 in white numbers next to the terminal. The pack lolcated on the lowerside of the ignition module should be 2 / 3 and the top 1 / 4.

Jun 23, 2009 | 1996 GMC Sonoma

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...