Question about 2008 Toyota Sienna

Open Question

How do i replace radio antenna on Toyota sienna?

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 79865 Answers

SOURCE: Electric Radio Antenna on 1994 Toyota Celica

Reverse the wires, one is hot going up and the other hot going down, the easiest way to deal with this is to just reverse them.

Posted on Nov 29, 2008


SOURCE: 1999 toyota sienna replacement the headlight set

Ask the dealer about the lens. That is where 98% come from

Posted on Sep 29, 2009

  • 1986 Answers

SOURCE: Replacing RH Side view mirror on a 2006 Toyota Sienna

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Posted on Sep 29, 2009

  • 1 Answer

SOURCE: Replacing RH Side view mirror on a 2006 Toyota Sienna

I had to replace my passenger side mirror on my 2004 Sienna a while back. I took some pictures as I did it. Maybe this can help.

Posted on Oct 04, 2009

  • 693 Answers

SOURCE: How do you replace the

How to change the Instrument Panel (Dash) lights in a 2001 Toyota Sienna.

Note! You should disconnect the Negative battery terminal before you start. If you do it will be a few trips before the engine runs and shifts normally. All electrical plugs have a catch. You have to find the correct place to push in, before they will come apart. All of the screws are #2 Phillips.

  1. Remove the two vertical screws in the trim panel above the cluster.
  2. Grab the bottom of the trim and pull strait back. Note, the center AC vent comes with it.
  3. Un-plug the wires and set it aside.
  4. Use a thin plastic putty knife to get under the left and right edges of the square Radio trim. Pry it strait out and let it hang from the wires.
  5. Above the radio face there are two screws that go strait up into the big piece of trim around the cluster. Take them out.
  6. There is another vertical screw on the left side below the dimmer. Remove it too.
  7. Look strait at the dash for the heads of two obvious Phillips head screws. Remove them.
  8. Pull the top of the big tunnel towards you. If you got all of the screws it should roll towards you until it is stopped by the wiring.
  9. Unplug everything. If you have an alarm the plugs may be in a ball of foam tape and cause you fits. Scrape off the tape. You may have to lower the knee bolster, under the dash, to get to the plugs There are little catches to find and push.
  10. You now have easy access to the cluster. Take out the 4 screws and roll it towards you.
  11. The panel lights are the 4 biggest sockets. The bulbs are 194s.
  12. Plug the dimmer back in, hook up the battery, turn on the lights and check the bulbs. Mine all worked after I fiddled with them. I replaced all four anyway.
  13. Remove the green covers carefully. The auto parts store won't have them.
  14. When you put it back together don't forget the light for the ignition switch. You may not have noticed it unplug when you took the big piece off.

Good Luck

Posted on Sep 22, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Car stereo wiring diagram

2007 Toyota Sienna Car Audio Wiring Color Codes
Car Radio Battery Constant 12v+ Wire: Blue/Yellow
Car Radio Accessory Switched 12v+ Wire: Gray
Car Radio Ground Wire: Brown
Car Radio Illumination Wire: Green
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger Wire: Black/Red
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Pink
Left Front Speaker Negative Wire (-): Violet
Right Front Speaker Positive Wire (+): Green
Right Front Speaker Negative Wire (-): Blue
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Black
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Red
Right Rear Speaker Negative Wire (-): White

Jul 24, 2012 | 2007 Toyota Sienna

1 Answer

Sienna radio fuse keeps blowing

You may need to unplug the radio to see if the short is internal, and if not its probably in the harness.

Jul 11, 2012 | Toyota Sienna Cars & Trucks

1 Answer

2001 Toyota Sienna AM Radio

wiring to windshield maybe

Mar 03, 2018 | Cars & Trucks

1 Answer

Need Detailed Diagram for Audio Wiring In 2000 Toyota Sienna

2000 Toyota Sienna Stereo Wiring Constant 12V+ Blue/Yellow Switched 12V+ Gray Ground Brown Illumination Green Dimmer n/a Antenna Trigger Black/Red Antenna Right Front Front Speakers 6 1/2" Doors Left Front (+) Pink Left Front (-) Purple Right Front (+) Green Right Front (-) Blue Rear Speakers 6 1/2" Side Panels Left Rear (+) Black Left Rear (-) Yellow Right Rear (+) Red Right Rear (-) White

Apr 04, 2010 | 2000 Toyota Sienna

1 Answer

CD won't eject or play in my 04 Toyota Sienna.

siennas have alot of concerns with radios... its a internal failure.. need to replace or repair your radio

Dec 09, 2009 | 2004 Toyota Sienna

1 Answer

How to remove antenna in toyota sienna 2006

All 3 solutions are not answering the question which is "how to remove the antenna in Toyota Sienna 2006?"

Sep 11, 2009 | 2006 Toyota Sienna

1 Answer

Replace the right side quarter panel glass on 1998 Toyota Sienna

ok to remove the right side quarter window requires the removal of of the vehicleheadliner, whitch in turn requires the removal of most of the interior panelsmy suggestion to dealer service department or other repair shop to avoid damaging the headliner.

Mar 21, 2009 | 1998 Toyota Sienna

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

376 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides