- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
the operators guide cover this.
hot reprogram key fobs , all cars. have the book in the glove boxl
and tells you how many keys you must have (WORKING) TO make a new key, some take 2 or 3 key s to DIY..
ask toyota for the guide. its free sometimes. (i wax safety issues and bam free, tell engine will not idle can car is dangerous.. bam. free guide.)
or go to , "buy a new key fob dot com." goggle finds them easy.
pretend to buy and aftermarket key
and bam free instructions. wow huh:?
According to a website I found for you, if it's a 2010 model you can't do it yourself. The site, which has much more information on the subject that you may want to read, said: "There is no onboard programming procedure for this vehicle. This vehicle requires special equipment be connected to the vehicle to program the keyless remote. Try a locksmith before the dealership, they are usually 50% the cost."
The security system on Toyota products are added by the distributor in your region. Many of those security systems will not allow more than 4 key fobs to be programmed into them. Have you owned this vehicle since it was new? Have you tried to program more that 4 key fobs into it? Have you tried programming it more than 2 times? If you security system has had more than 4 key fobs programmed in then the only way to get it to reprogram is the replace the security unit with a new one. I found this out the hard way and had to replace mine in my 2000 tundra.
Instructions to program a keyless entry remote for a Chevy Silverado. They also work on 2003, 2004 and 2006 Suburbans.
Close all the vehicle doors.
Insert the ignition key into the ignition lock cylinder.
Press and hold the DOOR unlock switch.
While holding the DOOR lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF.
Release the DOOR unlock switch. The doors will lock and unlock to confirm the program mode.
Press and hold the LOCK button and the UNLOCK button simultaneously on one keyless remote. After a delay of approximately 15 seconds, the doors will lock and unlock to confirm the programming of that transmitter.
Repeat the previous step to program up to four transmitters.
Turn the ignition switch to the RUN (one more click forward) position in order to exit the keyless entry transmitter mode.
Operate the transmitter functions in order to verify correct system operation
Same car same problem, but I found the plug w/two wires behind the glove box. It is on a brace on the left hand side, has a clip holding it there. Lift up on the clip and it slides off.
I jumpered those two wires, the door locks did not cycle as was in the instructions and remote still doesn't work.
Sounds to me like I'm missing power from somewhere, but where?
Hope you find your wires and they work for you.