Question about 1996 Ford Explorer

1 Answer

O2 sensors Where is the O2 sensor for code PO153 located on 96 Ford Exploreer 5.0 V8?

Posted by on

  • Anonymous Mar 31, 2014

    my explorer is running hot. It going supper hot, then make sounds and go back down to half. I got a code po153, what should I do?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 56 Answers

The o2 sensor you are looking for is on the drivers side of the engine and it is the first on closest to the engine. Before the cat. I hope this is helpful.

Posted on Jan 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the o2 sensor in this car


Hello, It is or should be mid vehicle after the catalytic converter


Ford Oxygen Sensor Locations for 4 Cyl and V8

May 02, 2015 | 1998 Ford Escort

1 Answer

Ford explorer oxygen sensor


the o2 sensor is located by the catalytic converter and anaylyses the exhaust emissions,it may need a tune up but first i'd check all air intake hoses for leaks ,signs of wear etc as if the air/fuel mixture going into engine isn't correct the emissions will not be either ,you can get fuel additives which will clean cylinder,valves and the cat converter so try this first , if the light is still on get the garage to clear the OBD memory and retest drive as a stored code isn't always automaticly erased

Mar 29, 2014 | 1996 Ford Explorer

1 Answer

I need a picture of the 02 sensors on a 1996 ford explorer


No you don't

You have front or upstrean O2 Sensors before the exhaust
converters & downstream or monitors in the converter outlets

You obviously have wires going to them

If you went under the vehicle you wouldn't be asking

Nov 27, 2012 | 1996 Ford Explorer

1 Answer

Had 3 codes come up for ox. sensor..po155-po151-po153 which one to replace and exactly where located?


it is the o2 sensor in front of the cat converter jack up truck and support under truck locate ur cat converter do this with truck cold cat can burn skin very easily same with exhaust pipes .when locate converter follow pipe forward towards engine look toward top of exhaust pipe will see a small tube with wire connected this is problem sensor check wiring and connector un plug and remove replace than reconnect

Oct 24, 2011 | 1999 Ford Explorer

1 Answer

I have a 1997 ford expedition 5.4 L with the check engine codes of PO153 and PO133 coming on.... the truck stalls and jumps need to know what part to replace or how many i need?


PO -133 O2 Sensor Slow Response

Po -- 153 same thing


Check for vacuum leaks --every where

Clean MAF Sensor -CRC MAF Cleaner

Replace the 2 --front O2 Sensors, if over
100,000 miles on them The ones closest to motor

Use the OEM Type not the cut & splice
universal junk

NAPA can order them
Should be Bosch or NGK

Codes do not tell you anything about what is wrong
or what to replace.

Jun 11, 2011 | 1997 Ford Expedition

2 Answers

I have a 2000 ford explorer 4.0 v6 ohv and i have an bank 1 sensor 1 code. which o2 sensor is that?


Ford Explorer and V8 O2 Sensor Locations diagram. This shows the location of Ford oxygen sensors on Bank 1 and Bank 2. If you want to know where your O2 sensors are, this diagram is your guide (click over pic for zoom)...

zjlimited_327.gif


Hope helps with this (remember to rate and comment this answer).

Apr 29, 2011 | 2000 Ford Explorer

1 Answer

Check engine light came on though the car runs fine. Mechanic said the code was p0153. He reset it and had me drive it around 'till it came on again. Came on two weeks later.


Why would a mechanic tell you to drive a vehicle
with an O2 Sensor Code, and why clear the code?

Plain stupid

PO153-O2 Sensor (Bank 2 Sensor 1) slow response

Just buy the sensor and replace yourself.

It is slow because it is worn out,most likely over
100,000 miles on it

Replace both front sensors ,if you have 2,the ones
closest to the engine

Apr 22, 2011 | Ford Taurus Cars & Trucks

1 Answer

Where is bank 1 sensor 2 on f150 4.6 Eng. .


Diagram: Ford Explorer and V8 O2 (Oxygen) Sensor Locations

Ford Explorer and V8 O2 Sensor Locations diagram. This shows the location of Ford oxygen sensors on Bank 1 and Bank 2. If you want to know where your O2 sensors are, this diagram is your guide.

zjlimited_192.gif

Hope helps.

Feb 14, 2011 | 1997 Ford F150 Regular Cab

2 Answers

2007 tiburon po153 engine light 27000 miles?


P0153 O2 Sensor Circuit Slow Response - Bank 2 Sensor 1
For the 6 cylinder engine I got the above result which indicates an O2 sensor is bad or contaminated.

Would change the O2 sensor.

Oct 29, 2010 | 2007 Hyundai Tiburon

1 Answer

Get code number PO153


Bank 2 sensor 1 is driver's side upstream (before converter) sensor. O2 sensers go bad all the time, I say replace it

Jan 26, 2010 | 2004 Ford F150

Not finding what you are looking for?
1996 Ford Explorer Logo

Related Topics:

440 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...