Question about Dodge Cars & Trucks

Open Question

1997 Dodge dakota 3.9 starts and shuts off

The truck wont start I have replaced fuel pump, distributor, rotor, pick up modular and crank shaft sensor

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 1995 Dodge Dakota Pick up

go to Didgeforums.com.

I had a similiar problem, found the solution there. It was the wiring harnes on the drivers side under the hood, just above the wheel well. there are a cluster of wires in a bundle. I unpacked the bundle carefuly and sure enough the were two or three wires all coroded, had wite powder from corosion. repaired the connections and bingo. I posted details at dodgeforums.com. browse around there. I posted pictures as well. this is a common problem.

Posted on Sep 05, 2008

Ad
  • 1 Answer

SOURCE: 2000 chevy blazer, truck cranks

Does your battery go dead?

Posted on Dec 18, 2008

  • 3 Answers

SOURCE: 1994 dodge dakota truck won't start

hoggharley@comcast.net fuel pump is located in the gas tank pop the hood to right of carb or left side look for a black cap that looks like a tire cap it will be on a metal pipe fuel pipe take it of have somebody try to start truck then push the little valve if gas comes out the pump is working if not fuel pump coil i think is mounted left side of motor as you look at it pull coil plug then take some rubber coated needle nose pliers hold near the coil look for blue ark remember this do not hold coil wire with bare hands or bare pliers it will shock you real good my buddy had just a bad coil wire so he got a whole wire set frm autozone they also have a web site autozone,com that will have trouble shooting for your truck let me no what happens

Posted on Feb 21, 2009

  • 35 Answers

SOURCE: My 1999 dodge intrepid is hesitating to start but wont start

The MAP sensor. Do you have a check engine light on?

Posted on Apr 29, 2009

  • 7 Answers

SOURCE: 1997 Dodge Ram 1500 5.2 liter won't start

I WOULD SAY IT IS THE COMPUTER {BRAIN} THAT IS WHAT SENDS THE FIREING ORDER AND VOLTAGE AND SETS THE TIMEING SPECK I WOULD SAY CHECK THE COMP

Posted on May 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Will fire ,but will not turn over


Dodge Dakota Crank No Start Fix - YouTube

? 8:10
https://www.youtube.com/watch?v=a-rfAd0YLg0
Jun 29, 2014 - Uploaded by AJ Pierce
In this video, I will show you how I fixed my 1992 Dodge Dakotanot starting. ... Engine cranks but won't start - Duration: 18:30. jimthecarguy ...

Inspect Fuses if Engine Cranks But Does Not Start : Dodge ...

repairpal.com > Problems > Dodge > Dakota
Engine Will Not Start Due to Blown Door Lock Fuse on Dodge Dakota ... cap and rotor, wires, plugs, coil, fuel pump assy, coil pickup sensor, crank position sensor and have new ECM on the way, Cranks but won't fire. ... 1990 Dodge Dakota.

Dakota won't Start - Discussion on Topix

www.topix.com > Dodge Dakota
Jan 22, 2009 - have a 1993 dodge dakota sport that wont start. when you turn the key on there is no power to the fuel pump and does not fire. any ideas ... I just bought a1990 Dodge Dakota Sport 4x4 5-Speed, there is only one problem, it only .... I went to move it the other day, it would turn over, but had no spark or gas.

Dodge Dakota Questions - PROBLEM STARTING - CarGurus

www.cargurus.com > Questions > Dodge > Dakota

CarGurus

Jan 09, 2016 | 1990 Dodge Dakota

1 Answer

1996 dodge 2500 v10 8.0 no spark and no fuel pump. Ran fine 3 days ago


Check the fuel pump fuse and relay, if it's OK, you have a bad fuel pump. About the no spark, could be many things
Ignition coil, distributor (if so equipment) , main shaft position sensor, computer problem
Good Luck

Mar 24, 2013 | 1997 Dodge Ram 2500 Club Cab

1 Answer

My 1997 Dodge Dakota will not start. It will turn over but will not start. I have replaced plugs, plug wires, distributor cap and rotor, Timing chain, Coil and the crankshaft sensor. I turned the key to...


your fuel pump may not be supplying the correct amount of pressure, this is pretty much a trait of Dodge, it will click and make noise, but the pressure just isn't there, spray some starter fluid into the air cleaner system, and turn it over, if it starts this is your problem

Jul 24, 2011 | 1997 Dodge Dakota

1 Answer

Gets gas gets spark but don't start. new fuel


1. does it turn over? if so, strong, or weak? 2. did you replace the fuel filter? 3. coil packs, or distributor (pack(s) can be tested) if distributed check cap and rotor, replace coil, but first check starter relay - 4. Check all ignition fuses, starter fuse - (along with relay{above}) 5. Check all connections from battery - positive, negative etc.
Please let me know if you need further assistance.
carsandcomps,
Guru, Premium Expert @ Fixya.com

May 26, 2011 | 1997 Dodge Dakota

1 Answer

1997 Dodge Dakota 3.9 slight acceleration like when starting out it misses like crazy replace temp sensor ,air charge sensor ,oxygen sensor in cad converter .crankshaft sensor and cam shaft sensor plugs...


check fuel pump pressure to see if it is getting the right pressure for fuel injectors and or fuel filter under driver's door on frame might have junk in it.

May 18, 2011 | 1997 Dodge Dakota

2 Answers

I have a 1990 Dodge Dakota. i replaced battery,altenator,plugs,wires,starter,distributor cap and rotor,pick up coil,and the egr valve but the ttruck wont start any suggestions?


Thanks for choosing FixYa and welcome. I would look at the timing belt/chain. Have you ruled out the fuel pump, fuel system? May be the computer.

May 13, 2011 | 1990 Dodge Dakota

1 Answer

I have a 1990 dodge ram 250 3.9 v6 just replaced the fuel pump and the map sencer and the intake temp. sencer and fuel filter new spark plugs wires cap rotor and the dist. pick up plate ran good for one...


could it be your crank sensor?
having a similar problem with a dakota. dodge tells me it may be the dist, but seeing as how you replaced it with a new one it could be that the sensor needs replacing

Apr 06, 2011 | 1990 Dodge Ram

1 Answer

97 dodge dakota. 2.5 , 5 speed, 2wd, 110k . I have replaced - dist. cap, rotor,wires, plugs, fuel pump, fuel filter, # 4 injector, tps, crank pos sensor, air filter. Truck will start and run fine until...


How about the pick up coil in the distributor? A trick we used to use back in the day was to tap the distributor housing with a hammer, key word tap. If the engine missed or stalled than the pick-up coil was replaced.

Oct 27, 2010 | 1997 Dodge Dakota

1 Answer

1994Dodge Dakota Wont start changed distributor cap rotor,coil, fuel pump, no spark wont start


could be a bad crankshaft position sensor or a bad camshaft position sensor. Either would cause no spark. I would check to see that you have fuel coming up to the throttle body

Jun 06, 2009 | 1994 Dodge Dakota Club Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...