Question about Jeep Cars & Trucks
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Common problem in snow country where salt water can corrode starter parking gate wire connection at started tab. Just cleanthe connector and tab, coat in dielectric grease, problem solved in 15 minutes!
Posted on Dec 05, 2010
I had same prob with Grand Cherokee - no rhyme nor reason as to when, where or why it wouldn't start. After two new starters the shop finally found a starter wire/cable that was corroded on the inside. Mech' could move it back and forth and it would / would not start. Changed cable six months ago - no problems since. Hope it helps.
Posted on Aug 24, 2010
Have shop run an OHM test on your transmission sensors -- then have them replaced and rerun the OHM test. -- it's more than likely an input speed sensor that is not working properly and telling the jeep to go into "limp mode" hence your speed isn't changing but it can't read the actual speed.
Posted on Jun 22, 2010
YOU HAVE A MODULE PROBLEM THAT IS SHORTING OUT AND TRIGGERING ACCESSORIES CIRCUIT HAVE IT CHECK ''CAN SHORT CIRCUIT AND CAUSE FIRE''
Posted on Sep 16, 2009
Tips for a great answer:
Jul 20, 2015 | 2008 Jeep Commander Overland
Feb 12, 2014 | Jeep Commander Cars & Trucks
Oct 21, 2012 | 2008 Jeep Commander
Jun 29, 2012 | 2008 Chrysler Town & Country
May 24, 2012 | 2008 Jeep Commander Overland
May 07, 2012 | 2008 Jeep Commander
Oct 04, 2011 | 2006 Jeep Commander
Apr 13, 2010 | 2006 Jeep Commander
Sep 02, 2009 | 2007 Jeep Commander Rocky Mountain
Feb 19, 2018 | Jeep Cars & Trucks
1,211 people viewed this question
Usually answered in minutes!