Question about 1985 Toyota Pickup

1 Answer

#3plug in22r motor is stuck how do i remove - 1985 Toyota Pickup

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Toyota Master
  • 14,381 Answers

Hey Don,is your spark plug cross threaded?If so put oil on plug to get on threads,it's possible that you can break area around plug,be super careful.If you get it out and the threads are stripped,go to Autozone and tell them that your stripped out a spark plug hole and you need a insert Get a breaker bar if hard to turn or a long extension..

Posted on Nov 06, 2012


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

How do you remove the driver side seat to replace the power seat motor? the seat is stuck al the way forward. the motor runs but the screws do not turn.

Hi William:
Usually the seats are attached to the floor by four bolts.
Removal is a matter of opening the door,
put something soft on the ground to protect your knees
With a flashlight, look under the seat to locate the bolts.
With a socket or combination wrench, remove the bolts
unplug any electrical connections,
Out comes the seat.

Sep 08, 2015 | 2006 Pontiac Grand Prix

1 Answer

2001 grand prix changed one spark number 3plug and now have knock and hesitation when gas is about halfway daniel 84598 would this be due to a wrong park plug its an ac delco recommended rwplacement plug...

run fault codes to find the fault as it may be a faulty injector and not a plug.. You can put a different brand of plug in each cylinder and it will not make one iota of difference . It is the reach (length of thread that matters). The knocking may be detonation and that will be revealed by the code reader.

Dec 23, 2013 | Cars & Trucks

1 Answer

My rear wiper on my 2003 chevy suburban 1500 stoped working and my battery is being drained

Hello the wiper motor axel is stucked by rust and the hole viper motor must be changed or renewed with a used/better one.

To prevent the battery from draining remove the multiplug connector from the rear viper engine.
(Remember to remove the negative cable from the battery)

When the viper motor is stucked the power circuit can`t close in position and this is why your battery is being drained for power.

Hope this will help you

Dec 17, 2012 | 2003 Chevrolet Suburban 1500

2 Answers

Vent door stuck and can't remove glove box

why can't you remove the glove box? You can get at the door from under the dash but it's a ***** to do. try lubing the vent cables unless it uses the vacuum motor, if it uses the vac. motor it will be hard to get to without the glove box being out.

Jan 05, 2010 | 1994 Chevrolet S-10

1 Answer

Hub is stuck. remove knuckle? the entire ubnit

What is hub stuck shaft going to motor

Oct 15, 2009 | 2005 Saturn VUE

1 Answer

2006 monti carlo blower motor stuck on high, even

what blower you talking about.if ac blower your blower relay stuck close. your monte carlo has a super charger blower also.

Jul 05, 2009 | 2006 Chevrolet Monte Carlo

1 Answer

96 318i turns over but want start

Needs Crank sensor, that's why you have no spark,this sensor controls reference for spark to plugs. Good

Dec 29, 2008 | 1996 BMW 318

1 Answer

Driver side power seat front to back motor stuck forward

Take apart the drive box in front of seat track, on both sides with an allen wrench. You can then push the seat to get at the bolts to remove it. My trolley drive motor had bad brushes. I am now looking to replace the motor, if I can find the replacement.

Oct 03, 2008 | 1998 Chrysler Sebring

3 Answers

Power lift gate stuck in open position

try reseting it by undoing the battery cable

Jul 04, 2008 | 2003 Dodge Caravan

Not finding what you are looking for?
Cars & Trucks Logo

94 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides